Please wait a minute...
浙江大学学报(工学版)
J4  2009, Vol. 43 Issue (8): 1443-1447    DOI: 10.3785/j.issn.1008-973X.2009.
力学     
倾斜裂纹的应力分布与裂纹面开口位移的关系
马有理
(哈尔滨商业大学 轻工学院, 黑龙江 哈尔滨 150028)
Relationship between stress distribution along slant crack and
opening displacement on crack-surface
 MA Wei-Li
College of Light Industry, Harbin University of Commerce, Harbin 150028, China
 全文: PDF(614 KB)   HTML
摘要：

由于存在裂纹的机械结构的受力方向未必与裂纹方向相垂直,有必要研究裂纹在混合型应力条件下的应力分布及位移特性,而实际机械结构的形状往往很复杂,直接测得裂尖前沿的应力分布是很困难的.为此,在应力比为零的I型循环应力下制作倾斜角度为45°的裂纹,通过测量裂纹面的开口位移,计算得到了裂尖张开方向的应力分布和滑移方向的应力分布.对实验中试件和裂纹的实际尺寸进行了有限元模拟计算.通过比较实验和模拟计算结果,分析了在混合型应力条件下影响裂纹面开口位移特性的因素.结果表明,裂纹表面的凹凸不平导致的接触会影响裂纹面（特别是裂尖处）的滑移变形；当裂纹张开方向的变形较小时,随着裂纹表面接触面积增加,裂纹滑移方向的变形阻力增大,这种影响表现得更为突出；相反,裂纹表面接触对裂纹张开方向的变形却起到了促进的作用；另外,由于压缩残余应力的作用,疲劳裂纹的张开位移受到制约.
Abstract:

The load is not always vertical to the crack in an actual mechanical part, so it is necessary to study the crack deformation behavior under the mixed-mode stress condition. It is difficult to measure the stress distribution along a crack for complex mechanical structures. Using the cracks with slant angle of 45° introduced by the cycle stress of mode I at zero stress ratio, this work measured the opening and sliding discontinuous displacements along the crack, then calculated the mode I and mode II stress distributions. Furthermore, finite element method (FEM) was used to simulate the dimensions of the specimen used in the experiment. The factors influencing the opening and sliding discontinuous displacement on the crack surface were discussed by comparing experimental and FEM data. The results show that the sliding deformation of fatigue crack is restrained because of the contact of crack zigzag surfaces especially at the crack tip. This effect is outstanding while the contact surface increases, which causes by the decreased opening deformation. On the contrary, the crack opening deformation increases because of the crack surface contact. And the opening deformation behavior is affected by the compressive residual stress near the crack.
出版日期: 2009-09-28
:  TU 51  
作者简介: 马有理（1961-），男，黑龙江哈尔滨人，副教授，从事机械设计及理论和断裂力学的研究.
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　

引用本文:

马有理. 倾斜裂纹的应力分布与裂纹面开口位移的关系[J]. J4, 2009, 43(8): 1443-1447.

MA Wei-Li. Relationship between stress distribution along slant crack and
opening displacement on crack-surface. J4, 2009, 43(8): 1443-1447.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2009.    或    http://www.zjujournals.com/eng/CN/Y2009/V43/I8/1443

[1] 于慧臣,孙燕国,张岩基,等. 不锈钢在扭转/拉伸复合载荷下近门槛值的疲劳裂纹扩展行为[J]. 金属学报, 2006, 42(2): 186-190.
YU Hui-chen, SUN Yan-guo, ZHANG Yan-ji, et al. Near-threshold fatigue crack propagation in stainless steel under combined torsion and tension [J]. Acta Metallurgica Sinica, 2006, 42(2): 186-190.
[2] 王习术,梁锋,曾燕屏,等. 夹杂物对超高强度钢低周疲劳裂纹萌生及扩展影响的原位观测[J]. 金属学报, 2005, 41(12): 1272-1276.
WANG Xi-shu, LIANG Feng, ZENG Yan-ping, et al. SEM in situ observations to the effects of inclusions on initiation and propagation of the low cycle fatigue crack in super strong steel [J]. Acta Metallurgica Sinica, 2005, 41(12): 1272-1276.
[3] PROWAN J W. 概率断裂力学和可靠性[M]. 北京:航空工业出版社, 2001.
[4] MA Y L. Study on fatigue crack propagation behavior under mixed-mode conditions with compressive residual stress [D]. Tokyo: Parliament Library, 2006.
[5] SIH G C, BARTHELEMY B M. Mixed mode fatigue crack growth predictions [J]. Engineering Fracture Mechanics, 1980, 13(3): 439-451.
[6] TSUTSUMI N, SHIROMOTO A, DOQUET V, et al. Effect of test frequency on fatigue strength of low carbon steel [J]. Transactions of the Japan Society of Mechanical Engineers, 2006, 72(715): 317-325.
[7] KOTERAZAWA R, OHASHI Y, WATANABE H. Propagation of part-through fatigue cracks and crack closure in carbon-steel [J]. Materials, 1978, 27(295): 363-369.
[8] TSUJI M, TOKUMASU H, KUBO S. Predictions of propagation behavior of semi-elliptical slant surface cracks in residual stress fields based on simulations of the partial elastic contact of crack surfaces [J]. Transactions of the Japan Society of Mechanical Engineers, 2007, 73(732): 861-868.
[9] FENG H, ZHANG J, ROHDE J. Crack surface relative displacement analysis of mixed-mode fracture mechanics problem [J]. Engineering Fracture Mechanics, 1990, 36(6): 971-978.
No related articles found!