Please wait a minute...
浙江大学学报(工学版)
浙江大学学报(工学版)  2018, Vol. 52 Issue (3): 577-583    DOI: 10.3785/j.issn.1008-973X.2018.03.021
电气工程     
电厂氟塑钢空预器的传热与积灰性能研究
杨继虎, 孙志坚, 袁瑞峰, 黄浩, 陈天宇, 胡亚才
浙江大学 热工与动力系统研究所, 浙江 杭州 310027
Study on heat transfer and ash deposit characteristics of fluoroplastic steel air-preheater in power plant
YANG Ji-hu, SUN Zhi-jian, YUAN Rui-feng, HUANG Hao, CHEN Tian-yu, HU Ya-cai
Institute of Thermal Science and Power Systems, Zhejiang University, Hangzhou 310027, China
 全文: PDF(1707 KB)   HTML
摘要：

介绍一种新型氟塑钢管板式空气预热器（氟塑钢空预器）.与纯PTFE空预器相比，氟塑钢空预器综合聚四氟乙烯（PTFE）材料的耐腐蚀、不易积灰和不锈钢材料良好的传热性能和机械性能，成本大大降低.理论分析表明，相比不锈钢空预器，氟塑钢空预器多了一层氟塑料，由此产生的空预器传热能力减弱的影响可以接受.某污泥焚烧电厂的测试结果显示，清灰前和清灰后，氟塑钢空预器的传热系数均大于搪瓷空预器，污垢热阻均小于搪瓷空预器.对氟塑钢及搪瓷换热管表面烟灰的EDS及XRD分析显示，在酸环境中，搪瓷管与烟气中氧气及水反应生成铁的氧化物和铁的水合氧化物附着在换热管表面，而氟塑钢空预器几乎没有发生低温腐蚀.氟塑钢空预器可在电厂恶劣的低温腐蚀环境中应用.
Abstract:

A new type of fluorine steel pipe plate air-preheater (fluoroplastic steel air-preheater) was introduced. Fluoroplastic steel air-preheater is corrosion resistant and nearly no ash deposit because of PTFE material, and has good heat transfer performance and good mechanical properties due to stainless steel. Thus, the air-preheater greatly reduced the cost compared to pure PTFE heat exchanger. Compared to stainless steel tube, fluoride plastic pipe has a layer of fluorine plastic, leading to the decrease of air-preheater's heat transfer ability, which is acceptable in theoretical analysis. The test results of fluoroplastic steel air-preheater used in a sewage sludge boiler show that the heat transfer performance of fluoroplastic steel air-preheater is better than that of the enamel air-preheater; the thermal resistance of ash deposit is much smaller than that of the enamel air-preheater. The main composition of deposits on the surfaces of fluoroplastic steel and enamel air-preheater was analyzed by using energy dispersive spectrometry (EDS) and X-ray diffraction (XRD). Results show that in the acid environment, the enamel tubes react with oxygen and water in flue gas to produce iron oxides and hydrated oxides, which will attach to the surface of the heat transfer tubes. But the fluorine plastic steel air-preheater is almost no corrosion in the low temperature. Fluoroplastic steel air-preheater can be applied in low temperature corrosion conditions of power plants.
收稿日期: 2016-11-26 出版日期: 2018-09-11
CLC:  TK124  
基金资助:

国家重点研发计划资助项目（2016YFC0203704）.
通讯作者: 孙志坚,男,副教授.     E-mail: sun_zju@126.com
作者简介: 杨继虎(1993-),男,硕士生,从事余热深度利用、强化传热研究.orcid.org/0000-0001-5300-1400.E-mail:yjh1993@zju.edu.cn
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
作者相关文章　　

引用本文:

杨继虎, 孙志坚, 袁瑞峰, 黄浩, 陈天宇, 胡亚才. 电厂氟塑钢空预器的传热与积灰性能研究[J]. 浙江大学学报(工学版), 2018, 52(3): 577-583.

YANG Ji-hu, SUN Zhi-jian, YUAN Rui-feng, HUANG Hao, CHEN Tian-yu, HU Ya-cai. Study on heat transfer and ash deposit characteristics of fluoroplastic steel air-preheater in power plant. JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE), 2018, 52(3): 577-583.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2018.03.021    或    http://www.zjujournals.com/eng/CN/Y2018/V52/I3/577

[1] 吴华新.低位烟气余热深度回收利用状况述评(Ⅱ)-传热过程与技术应用研究[J].热能动力工程,2012,27(4):399-404. WU Hua-xin. Review of the status quo of low quality flue gas waste heat recovery and utilization (Ⅱ):study of the application of heat transfer process and technologies[J]. Journal of Engineering for Thermal Energy and Power, 2012, 27(4):399-404.
[2] 何雅玲,汤松臻,王飞龙,等.中低温烟气换热器气侧积灰、磨损及腐蚀的研究[J].科学通报,2016,61:1858-1876. HE Ya-ling, TANG Song-zhen, WANG Fei-ling, et al. Gas-side fouling, erosion and corrosion of heat exchanger for middle and low temperature flue gas waste heat recovery[J]. Chinese Science Bulletin, 2016, 61:1858-1876.
[3] 李志敏.燃煤锅炉排烟的酸-灰耦合作用与露点的动态变化机制研究[D].济南:山东大学,2016. LI Zhi-min. Research on acid-grey coupling mechanism and dew point dynamic characteristics of Coal-fired boiler flue gas[D].Jinan:Shandong University, 2016.
[4] 胡亚才,张雪东,王建平,等.塑料换热技术在溴化锂吸收式制冷机上的应用展望[J].制冷学报,2005,24(1):44-48. HU Ya-cai,ZHANG Xue-dong,WANG Jian-ping,et al.Plastic heat transfer technology application prospect on lithium bromide-water absorption chillers[J]. Journal of Refrigeration, 2005, 24(1):44-48.
[5] LIU J, ZHANG T, LIU X, et al. Experimental analysis of an internally-cooled/heated liquid desiccant dehumidifier/regenerator made of thermally conductive plastic[J].Energy and Buildings, 2015, 99:75-86.
[6] BANDEL ER P, DERONZIER J C, LAURO F. Plastic heat exchangers[M]. Design and Operation of Heat Exchangers, Berlin:Springer Berlin Heidelberg, 1992:201-209.
[7] EL-DESSOUKY H T, ETTOUNEY H M. Plastic/compact heat exchangers for single-effect desalination systems[J]. Desalination, 1999, 122(2):271-289.
[8] SAMAN W Y, ALIZADEH S. Modelling and performance analysis of a cross-flow type plate heat exchanger for dehumidification/cooling[J]. Solar Energy, 2001, 70(4):361-372.
[9] JIA L, PENG X F, SUN J D, et al. An experimental study on vapor condensation of wet flue gas in a plastic heat exchanger[J]. Heat Transfer-Asian Research, 2001, 30(7):571-580.
[10] 陈林, 孙颖颖,杜小泽,等.回收烟气余热的特种耐腐蚀塑料换热器的性能分析[J].中国电机工程学报,2014,34(17):2778-2783. CHEN Lin, SUN Ying-ying, DU Xiao-ze, et al. Performance analysis of anti-corrosion heat exchangers made of special plastics for flue gas heat recovery[J]. Proceedings of the CSEE, 2014, 34(17):2778-2783.
[11] HE Y, WALSH D, SHI C. Fluoropolymer composite coating for condensing heat exchangers:characterization of the mechanical, tribological and thermal properties[J]. Applied Thermal Engineering, 2015, 91:387-398.
[12] TROJANOWSKI R, BUTCHER T, WOREK M, et al. Polymer heat exchanger design for condensing boiler applications[J]. Applied Thermal Engineering, 2016, 103:150-158.
[13] ZHUANG J, HUANG C, ZHOU G, et al. Influence of factors on heat dissipation performance of composite metal-polymer heat exchanger with rectangular microstructure[J]. Applied Thermal Engineering, 2016, 102:1473-1480.
[14] 陈林,杜小泽,林俊,等. 导热塑料在换热器中的应用[J]. 塑料,2013,42(6):28-30. CHEN Lin,DU Xiao-ze,LIN Jun, et al. Application of thermally conductive plastic in heat exchanger[J]. Plastics, 2013, 42(6):28-30.
[15] CHEN L, LI Z, GUO Z Y. Experimental investigation of plastic finned-tube heat exchangers, with emphasis on material thermal conductivity[J]. Experimental Thermal and Fluid Science, 2009, 33(5):922-928.
[16] CEHN X, SU Y, REAY D, et al. Recent research developments in polymer heat exchangers:a review[J]. Renewable and Sustainable Energy Reviews, 2016, 60:1367-1386.
[17] 朱云峰,胡亚才,李军,等.一种具有防腐防堵功能的氟塑钢空气预热器:201510903778.8[P]. 2016-03-16.
[18] 林宗虎,徐通模,黄祥新,等.实用锅炉手册[M].北京:化学工业出版社,2009:429-529.
[19] 容銮恩,袁镇福,刘志敏,等.电站锅炉原理[M].北京:中国电力出版社,1997:40-51,195-204.
[20] 杨世铭,陶文铨.传热学[M].北京:高等教育出版社,2006:466-508.
[21] 中国国家标准化管理委员会. 电站锅炉性能试验规程:空气预热器性能:GB/T10184-2015[S]. 北京:中国标准出版社,2015.
[1] 牟林巍, 张宇鸿, 李佳琦, 张嘉懿, 蒋平, 范利武. 表面芯吸性对淬火过程中沸腾传热特性的影响[J]. 浙江大学学报(工学版), 2018, 52(5): 960-965.
[2] 代超, 纪献兵, 周冬冬, 王野, 徐进良. 液滴碰撞不同湿润性表面的行为特征[J]. 浙江大学学报(工学版), 2018, 52(1): 36-42.
[3] 钟勋, 俞小莉, 吴俊, 蒋平灶. 氧化铝纳米流体在车用热交换器中的试验研究[J]. J4, 2010, 44(4): 761-764.
[4] 李冠球, 李蔚, 张政江, 张巍, 徐志明. 基于冯-卡门类比建立螺纹管内颗粒污垢模型[J]. J4, 2010, 44(3): 494-498.