Please wait a minute...
浙江大学学报(工学版)
J4  2012, Vol. 46 Issue (2): 309-314    DOI: 10.3785/j.issn.1008-973X.2012.02.020
机械工程、能源工程     
永磁屏蔽式耐高压高速开关电磁铁
满军1, 丁凡1, 李其朋1,2, 笪靖1,3, 邵森寅1,4
1.浙江大学 流体传动及控制国家重点实验室, 浙江 杭州 310027;2.浙江科技学院 机械与汽车工程学院,浙江 杭州,310023;
3.镇江船艇学院 船艇工程学系,江苏 镇江,212003; 4. 92132 部队装备部
Study of high-pressure high-speed on-off solenoid using
permanent magnet shield
MAN Jun 1, DING Fan 1, LI Qi-peng 1,2, DA Jing 1,3, SHAO Sen-yin1,4
1. State Key Laboratory of Fluid Power Transmission and Control, Zhejiang University, Hangzhou, 310027, China;
2. School of Mechanical and Automotive Engineering, Zhejiang University of Science and Technology, Hangzhou, 310023, China;
3. Department of Watercraft Engineering, Zhenjiang watercraft college, Zhenjiang, 212003, China;
4. Armament Department of troop 92132
 全文: PDF  HTML
摘要：

为了提高电磁力、加快响应速度,提出一种永磁屏蔽式耐高压高速开关电磁铁,采用NdFeB稀土永磁材料作为磁屏蔽元件,减少漏磁并加快了动态响应.基于有限元方法建立电磁铁的动态数学模型,并通过实验进行验证,实验与仿真基本吻合,响应误差为3.2%,验证模型的有效性.在此基础上,对该高速开关电磁铁进行动态仿真,探讨永磁体长度、厚度、激磁方向,盆口高,耐压环厚度,隔磁片长度,前隔磁角和后隔磁角等结构参数对响应时间的影响规律.结合实际设计要求,结果表明,采用优化后的结构参数研制的永磁屏蔽式耐高压高速开关电磁铁在0.6 mm行程时的响应时间为2.20 ms.
Abstract:

To increase electromagnetic force and to speed up response time, this paper proposed a high-pressure high-speed on-off solenoid using permanent magnet (PM) shield. By reducing flux leakage, the rare-earth NdFeB PM shield improves the dynamic response. A dynamic model of solenoid based on finite element analysis was established. The results from a simulation based on the model were verified by those from experiments while response error was 3.2%. The dynamic simulation analysis of the main structure parameters — such as PM length, PM thickness, PM direction, basin height, pressure ring thickness, nonmagnetic spacer length, front ring angle, and back ring angle — were performed for the PM shield type solenoid. Based on optimal design parameters selection and engineering practice, the response time of the high-pressure long-stroke high-speed solenoid with PM shield is 2.20 ms with a stroke of 0.6 mm.
出版日期: 2012-03-20
:  TH 137  
基金资助:

浙江省重大科技专项基金资助项目(2008C11028）；国家自然科学基金资助项目（50905166）.
通讯作者: 丁凡，男，教授，博导.     E-mail: fding@zju.edu.cn
作者简介: 满军（1981—），男，博士生，从事电液比例/伺服元件及系统的研究.E-mail：phenomenon@zju.edu.cn
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　

引用本文:

满军, 丁凡, 李其朋, 笪靖, 邵森寅. 永磁屏蔽式耐高压高速开关电磁铁[J]. J4, 2012, 46(2): 309-314.

MAN Jun , DING Fan , LI Qi-peng , DA Jing , SHAO Sen-yin. Study of high-pressure high-speed on-off solenoid using
permanent magnet shield. J4, 2012, 46(2): 309-314.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2012.02.020    或    http://www.zjujournals.com/eng/CN/Y2012/V46/I2/309

［1］ LU Y X. New challenges, new chances, new contributionsa look forward to the future of fluid power technology ［C］∥ Proceedings of the Seventh International Conference on Fluid Power Transmission and Control. Hangzhou: World Publishing Corporation. 2009: 1-3.
［2］ FANG P, DING F, LI Q P,et al. Highresponse electromagnetic actuator with twisting axis for gravure systems ［J］. IEEE Transactions on Magnetics, 2009, 45(1): 172-176.
［3］ 向忠,陶国良,谢建蔚,等.气动高速开关阀动态压力特性仿真与试验研究［J］.浙江大学学报:工学版,2008, 42(5): 845-849.
XIANG Z, TAO G L, XIE J W,et al. Simulation and experimental investigation on pressure dynamics of pneumatic highspeed on/off valves ［J］. Journal of Zhejiang University: Engineering Science, 2008, 42(5): 845-849.
［4］ 孟爱华,项占琴,吕福在. 微型超磁致伸缩高速阀致动器的优化设计［J］. 浙江大学学报:工学版,2006, 40(2): 216-220.
MENG AH, XIANG Z Q, LU F Z. Optimization design of giant magnetostrictive micro highspeed valve actuator［J］. Journal of Zhejiang University: Engineering Science, 2006, 40(2): 216-220.
［5］ 李勇,丁凡,李其朋,等. 低功耗耐高压双向线性力马达静态力特性研究［J］.浙江大学学报:工学版,2009, 43(1): 135-137.
LI Y, DING F, LI Q P, CUI J. Static force characteristics of lowpowerconsumption bidirectional linear force motor used for high hydraulic pressure ［J］. Journal of Zhejiang University: Engineering Science,2009, 43(1): 135-137.
［6］ 崔剑,丁凡,李其朋.耐高压双向旋转比例电磁铁的静态力矩特性［J］.浙江大学学报:工学版,2007,41(9): 1578-1581.
CUI Jian, DING Fan, LI Qipeng. Static torque characteristics of highpressure bidirectional rotary proportional solenoid ［J］. Journal of Zhejiang University: Engineering Science, 2007, 41(9): 1578-1581.
［7］ LEE I. Switching response improvement of a high speed on/off solenoid valve by using a 3 power source type valve driving circuit［C］∥ Mumbai, India: Institute of Electrical and Electronics Engineers Inc. \
[S. l.\]: \
[s. n.\], 2006: 1823-1828.
［8］ KIM J. Design and analysis of new, quickresponse, latching electromagnetic linear actuators［D］. United StatesCalifornia: University of California, Berkeley, 2005.
［9］ CANTER N. New valve technology boosts engine performance ［J］. Tribology and Lubrication Technology. 2005, 61(8): 14-16.
［10］ ALEXANDER D, CASSAIDY K, PARIKH A A, et al, Method for manufacturing solenoid actuator, involves forming solenoid actuator using two materials having similar moduli of elasticity. US, US2010024200A1［P］. 2010-02-04.
［11］ SUNG B J, LEE E W, KIM H E. Characteristics of nonmagnetic ring for highspeed solenoid actuator［C］∥ The Eleventh Biennial IEEE Conference on Electromagnetic Field Computation. Korea: ［s. n.］, 2004.
［12］ COLLINS D E, TACKETT W D, HOOL P H, et al. Control valve for a vehicular brake system. US20030389459 ［P］. 2004-09-16.
［13］ SUBIC A, CVETKOVIC D. Virtual design and development of compact fastacting fuel injector solenoid actuator ［J］. International Journal of Vehicle Design, 2008, 46(3): 309-327.
［14］ 倪光正.工程电磁场原理［M］.北京:高等教育出版社,2002: 207-210.
［15］ 满军,丁凡,李勇,等.耐高压大行程高速开关电磁铁的动态特性［J］.煤炭学报.2010,35(5): 871-875.
MAN Jun, DING Fan, LI Yong,et al. Dynamic characteristics of highpressure longstoke highspeed onoff solenoid ［J］. Journal of China Coal Society, 2010, 35(5): 871-875.
[1] 丁川,丁凡,周星,满在朋,杨灿军. 新型耐压湿式比例电磁铁的研制与对比试验研究[J]. J4, 2014, 48(3): 451-455.
[2] 宋月超, 徐兵, 杨华勇, 张军辉. 改进的柱塞泵流量脉动“实用近似”测试法[J]. J4, 2014, 48(2): 200-205.
[3] 满在朋,丁凡,丁川,刘硕,黄挺峰. 液压软管脉冲试验的发展与研究综述[J]. J4, 2014, 48(1): 21-28.
[4] 施虎, 杨华勇, 龚国芳, 侯典清. 盾构推进液压系统载荷顺应性指标和评价方法[J]. J4, 2013, 47(8): 1444-1449.
[5] 侯典清,龚国芳,施虎,王林涛. 基于顺应特性的新型盾构推进系统设计[J]. J4, 2013, 47(7): 1287-1292.
[6] 施虎,杨华勇,龚国芳,王林涛. 盾构掘进机关键技术及模拟试验台现状与展望[J]. J4, 2013, 47(5): 741-749.
[7] 魏建华,国凯,熊义. 大型装备多轴电液执行器同步控制[J]. J4, 2013, 47(5): 755-760.
[8] 侯典清, 龚国芳, 施虎, 王林涛. 盾构推进系统突变载荷顺应特性研究[J]. J4, 2013, 47(3): 522-527.
[9] 朱旭, 魏建华, 方锦辉. 先导式电液配流系统的动态特性[J]. J4, 2013, 47(2): 193-200.
[10] 张彦廷, 渠迎锋, 刘振东, 马江涛. 天车升沉补偿系统摇摆装置的设计[J]. J4, 2012, 46(12): 2268-2273.
[11] 杜恒, 魏建华, 冯瑞琳. 压力跟踪阀建模、仿真与试验研究[J]. J4, 2012, 46(6): 1034-1040.
[12] 方锦辉, 魏建华, 孔晓武. 并联伺服阀的同步控制策略[J]. J4, 2012, 46(6): 1054-1059.
[13] 管成,徐晓,林潇,王守洪. 液压挖掘机回转制动能量回收系统[J]. J4, 2012, 46(1): 142-149.
[14] 黄家海,邱敏秀,方文敏. 液黏调速离合器中摩擦副间隙内流体传热分析[J]. J4, 2011, 45(11): 1934-1940.
[15] 黄家海,魏建华,邱敏秀. 液黏调速离合器传动特性分析[J]. J4, 2011, 45(11): 1927-1933.