Please wait a minute...
J4  2012, Vol. 46 Issue (6): 1054-1059    DOI: 10.3785/j.issn.1008-973X.2012.06.015
机械工程     
并联伺服阀的同步控制策略
方锦辉, 魏建华, 孔晓武
浙江大学 流体传动及控制国家重点实验室,浙江 杭州 310027
Synchronous control strategy for paralleled servo valves
FANG Jin-hui, WEI Jian-hua, KONG Xiao-wu
State Key Laboratory of Fluid Power Transmission and Control, Zhejiang University, Hangzhou 310027, China
 全文: PDF  HTML
摘要:

针对大型振动台和线性摩擦焊机等设备对液压伺服系统的大流量和高频响要求,以及现有伺服阀随着额定流量增加频响大幅降低的矛盾,提出多个伺服阀并联使用的方案.为克服伺服阀在通径、制造和电气等方面差异所导致的阀并联工作时阀芯过零位出现同步误差、造成流量降低和油路冲击等问题,通过监测伺服阀在不同频率、不同幅值正弦信号下和变幅值的类正弦信号下阀芯的位移,得出阀芯运动的若干非线性特征,并在此基础上采用移相和变幅相结合的同步控制策略,解决了阀芯运动的不同步问题.通过对相对滞后阀的指令信号进行超前移相,消除了大部分的同步误差;缩小相对滞后阀的指令信号幅值同时增大相对超前阀的信号幅值,进一步削减了阀并联运动的同步误差.实验结果表明,该同步控制策略效果良好,两阀阀芯穿越零位的相位差可控制在±2°.

Abstract:

 A new method which paralleled a number of servo valves was proposed, to meet the contradiction between the requirement of large flow and high frequency response in some industry areas, such as high-frequency vibration generators and linearity friction weld machines, and the decreasing frequency response of servo valves as the nominal flow increases. Because of the discrepancies of valves in sizes, manufacture, electrical, etc, the synchronous motion error of spools occurs when crossing the null position if they are paralleled and driven by the same signals, as well as the problem of flow decreasing and hydraulic shock. By analyzing the motion of spools under the drive of sinusoidal signal with different amplitudes and different frequencies, and of sine-like signal with varied amplitude, a number of nonlinear features of servo valves were obtained. Then, a control strategy through combination of phase-shifting and amplitudevarying was designed to achieve a synchronous motion objective. By shifting forward the phase of signal driving the valve which lagged behind others, the major synchronization error was eliminated. The rest of error was reduced by shrinking the amplitude of lagging valves and enlarging the amplitude of leading valves at the same time so that the total flow was the same. The experimental results show that the proposed strategy works well, and the phase error can be controlled within ± 2 °, when the spools cross the null position.

出版日期: 2012-07-24
:  TH 137  
基金资助:

国家自然科学基金资助项目(50805127).

通讯作者: 魏建华,男,教授,博导.     E-mail: jhwei@sfp.zju.edu.cn
作者简介: 方锦辉(1983—),男,博士生,从事电液控制系统和大流量阀的研究.E-mail:jhfang@126.com
服务  
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章  

引用本文:

方锦辉, 魏建华, 孔晓武. 并联伺服阀的同步控制策略[J]. J4, 2012, 46(6): 1054-1059.

FANG Jin-hui, WEI Jian-hua, KONG Xiao-wu. Synchronous control strategy for paralleled servo valves. J4, 2012, 46(6): 1054-1059.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2012.06.015        http://www.zjujournals.com/eng/CN/Y2012/V46/I6/1054

[1] 李其朋,丁凡.电液伺服阀技术研究现状及发展趋势[J].工程机械, 2003, 34(6): 28-33.
LI Qipeng, DING Fan. Current situations and developing trend of the research of electrohydraulic servo valve technique [J]. Construction Machinery and Equipment, 2003, 34(6): 28-33.
[2] 傅林坚.大流量高响应电液比例阀的设计及关键技术研究[D].杭州:浙江大学,2010: 1-9.
FU Linjian. Research on the design and the key technology of the elechydraulic proportional valve with large flow rate and high responsibility [D]. Hangzhou: Zhejiang University, 2010: 1-9.
[3] 孔晓武,魏建华.大流量插装式伺服阀数学模型及试验验证[J].浙江大学学报:工学版,2007, 41(10): 1759-1762.
KONG Xiaowu; WEI Jianhua. Mathematical model and experimental verification of high flow cartridge servo valve [J]. Journal of Zhejiang University: Engineering Science, 2007, 41(10): 1759-1762.

[4] CHEN C Y, LIU L Q, CHENG C C, et al. Fuzzy controller design for synchronous motion in a dualcylinder electrohydraulic system [J]. Control Engineering Practice, 2008, 16(6): 658-673.
[5] SUN H, CHIU G. Motion synchronization for multicylinder electrohydraulic system [C]∥ Proceedings of 2001 IEEE/ASME International Conference on Advanced Intelligent Mechatronics. Como: IEEE, 2001: 8-12.
[6] SUN Dong. Position synchronization of multiple motion axes with adaptive coupling control [J]. Automatica, 2003, 39(6): 997-1005.
[7] 金波,朱世强.双阀并联电液位置控制系统研究[J].机械工程学报,2000,36(9): 72-75.
JIN Bo, ZHU Shiqiang. Study on parallel connected hydraulic position control system [J]. Chinese Journal of Mechanical Engineering, 2000, 36(9): 72-75.
[8] LI K, CHEN Jian, XIAO Ziyuan, et al. An electrohydraulic system for synchronized roof erection [J]. Automation in Construction, 2003, 12(1): 29-42.
[9] 王经甫,叶正茂,李洪人.双阀并联控制在船舶舵机电液负载模拟器多余力抑制中的研究[J].机械工程学报,2005,41(4): 229-233.
WANG Jingfu, YE Zhengmao, LI Hongren. Study on eliminating the superfluous force of marine electrohydraulic load simulator applied with dualvalve parallel connected control [J]. Chinese Journal of Mechanical Engineering, 2005, 41(4): 229-233.
[10] 戴远敏,李建英,刘海之.双阀并联控制在电液负载模拟器多余力抑制中的应用[J].机床与液压,2007, 35(3): 87-89.
DAI Yuanmin, LI Jianying, LIU Haizhi. Application of double valve parallel control in eliminating superfluous force of electrohydraulic load simulator [J]. Machine Tool & Hydraulics, 2007, 35(3): 87-89.
[11] MOOG HYDROLUX. DSHR Series 2/2Way Servo Cartridge Valves [EB/OL]. [2010-10-08]. http:∥www.moog.com/literature/ICD/dshrseriesvalves.pdf.
[12] MOOG HYDROLUX. D660 series valves [EB/OL]. [2010-10-08]. http:∥www.moog.com/literature/ICD/Products/Valves/d660seriesvalves.pdf.
[13] BoschRexroth. 4/4way servo solenoid directional control valves, directly operated, with electrical position feedback and onboard electronics (OBE) [EB/OL]. [2010-10-10]. http:∥www.boschrexroth.com/modules/BRMV2PDFDownload.dlldb=brmv2&lvid=1154232&mvid=4365&clid=1&sid=6408303A760EDA4AF4BF8006B87D2343&sch=M.

[1] 丁川,丁凡,周星,满在朋,杨灿军. 新型耐压湿式比例电磁铁的研制与对比试验研究[J]. J4, 2014, 48(3): 451-455.
[2] 宋月超, 徐兵, 杨华勇, 张军辉. 改进的柱塞泵流量脉动“实用近似”测试法[J]. J4, 2014, 48(2): 200-205.
[3] 满在朋,丁凡,丁川,刘硕,黄挺峰. 液压软管脉冲试验的发展与研究综述[J]. J4, 2014, 48(1): 21-28.
[4] 施虎, 杨华勇, 龚国芳, 侯典清. 盾构推进液压系统载荷顺应性指标和评价方法[J]. J4, 2013, 47(8): 1444-1449.
[5] 侯典清,龚国芳,施虎,王林涛. 基于顺应特性的新型盾构推进系统设计[J]. J4, 2013, 47(7): 1287-1292.
[6] 魏建华,国凯,熊义. 大型装备多轴电液执行器同步控制[J]. J4, 2013, 47(5): 755-760.
[7] 施虎,杨华勇,龚国芳,王林涛. 盾构掘进机关键技术及模拟试验台现状与展望[J]. J4, 2013, 47(5): 741-749.
[8] 侯典清, 龚国芳, 施虎, 王林涛. 盾构推进系统突变载荷顺应特性研究[J]. J4, 2013, 47(3): 522-527.
[9] 朱旭, 魏建华, 方锦辉. 先导式电液配流系统的动态特性[J]. J4, 2013, 47(2): 193-200.
[10] 张彦廷, 渠迎锋, 刘振东, 马江涛. 天车升沉补偿系统摇摆装置的设计[J]. J4, 2012, 46(12): 2268-2273.
[11] 杜恒, 魏建华, 冯瑞琳. 压力跟踪阀建模、仿真与试验研究[J]. J4, 2012, 46(6): 1034-1040.
[12] 满军, 丁凡, 李其朋, 笪靖, 邵森寅. 永磁屏蔽式耐高压高速开关电磁铁[J]. J4, 2012, 46(2): 309-314.
[13] 管成,徐晓,林潇,王守洪. 液压挖掘机回转制动能量回收系统[J]. J4, 2012, 46(1): 142-149.
[14] 黄家海,邱敏秀,方文敏. 液黏调速离合器中摩擦副间隙内流体传热分析[J]. J4, 2011, 45(11): 1934-1940.
[15] 黄家海,魏建华,邱敏秀. 液黏调速离合器传动特性分析[J]. J4, 2011, 45(11): 1927-1933.