| Mechanical Engineering |
|
|
|
|
| Analysis on torque characteristic of axial piston motor with dual driving |
| DENG Hai shun1,2, HUANG Ran1, WANG Chuan li1, LI Gang2 |
| 1.Department of Mechanical Engineering, Anhui University of Science and Technology, Huainan 232001, China;2. Mechanical Technology Company Limited of Xuzhou Aobo, Xuzhou 221100,China |
|
|
|
Abstract The transient torque computational formula of axial piston motor with dual driving was deduced considering the influence of the triangular groove and stagger angle on the port plate in order to analyze the torque characteristic. Simulated analysis was conducted to analyze the torque characteristic under different parities, staggers and average torques of the pistons inside and outside. Results show that the torque ripple in the pistons inside and outside with odd numbers were superior to those with even numbers. The torque ripple can be reduced by the stagger angle. The optimal stagger angle was a quarter of its ideal period when the numbers of the pistons inside and outside are odd, and the optimal stagger angle is a half of its ideal period when the numbers of the pistons inside and outside are even. The torque ripple can be reduced when the average torque inside is equal to the average torque outside. The abrupt change of the torque was caused by the blocking angle of the port plate, and more abrupt changes lead to more significant blocking angles. The abrupt change of the torque can be significantly reduced by the stagger angle．
|
|
Published: 18 September 2016
|
|
|
双侧驱动轴向柱塞马达扭矩脉动分析
为研究新型液压执行元件双侧驱动轴向柱塞马达的扭矩脉动,在考虑配流盘三角槽和闭死角影响的前提下,推导出双侧驱动轴向柱塞马达的瞬态扭矩公式.仿真分析扭矩特性,得出不同内外排柱塞数的奇偶性、交错角、平均扭矩对双侧驱动轴向柱塞马达扭矩特性的影响.结果表明：当内外排柱塞数均为奇数时,扭矩脉动优于内外排柱塞数均为偶数；存在交错角的扭矩脉动较小,内外排柱塞数均为奇数的最优交错角为其理想周期的1/4,内外排柱塞数均为偶数的最优交错角为其理想周期的1/2；内外排平均扭矩相等有利于降低扭矩脉动率；闭死角导致双侧驱动轴向柱塞马达产生扭矩突跳,且闭死角越大,扭矩突跳越明显,但交错角能显著降低扭矩的突跳值.
|
|
| ［1］ 于红英, 钟汉田, 李硕. 修正心形线式内曲线径向柱塞马达脉动分析 ［J］. 哈尔滨工业大学学报, 2012. 44(3): 44-48．
YU Hong ying, ZHONG Han tian, LI Shuo. The analysis on the flow pulsation of radial piston motor with the modified heart shaped curve as inner curve ［J］. Journal of Harbin Institute of Technology, 2012. 44(3): 44-48．
［2］ MICHAEL P W, GARCIA J M, BAIR S S, et al. Lubricant chemistry and rheology effects on hydraulic motor starting efficiency ［J］. Tribology Transactions, 2012, 55(5): 549557．
［3］ 徐兵, 宋月超, 杨华勇. 柱塞泵斜盘交错角降噪结构优化［J］. 浙江大学学报:工学版, 2013. 47(6):1043-1050．
XU Bing, SONG Yue chao, YANG Hua yong. Optimization of swash plate cross angle noise reduction structure for swash plate type axial piston pump ［J］. Journal of Zhejiang University:Engineering Science, 2013, 47(6): 1043-1050．
［4］ YANG L, NIE S, YIN S, et al. Numerical and experimental investigation on torque characteristics of seawater hydraulic axial piston motor for underwater tool system［J］. Ocean Engineering, 2015,104(8):168-184．
［5］ WANG Z, GU L, LI L. Experimental studies on the overall efficiency performance of axial piston motor with a laser surface textured valve plate ［J］. Proceedings of the Institution of Mechanical Engineers,Part B: Journal of Engineering Manufacture, 2013.227(7): 1049-1056．
［6］ 李欢, 王吉龙. 五星单作用活塞缸偏置式径向柱塞马达的设计［J］. 机械设计与制造, 2013 (12): 24-26．
LI Huan, WANG Ji long. The design of the five star sin gle acting piston cylinder offset type of radial motor ［J］. Machinery Design and Manufacture, 2013, (12): 24-26．
［7］ 廖传林, 李维扬. 多作用内曲线径向柱塞马达结构优化分析［J］. 液压与气动, 2013(6): 122-123．
LIAO Chuan lin, LI Wei yang. Introduction of inner curve radial piston motor ［J］. Chinese Hydraulics and Pneumatics, 2013 (6): 122-123．
［8］ 高殿荣, 王志强, 温茂森, 等. 径向低速大扭矩水液压马达定子曲线分析［J］. 燕山大学学报, 2012, 35(6): 493-500．
GAO Dian rong, WANG Zhi qiang, WEN Mao sen, et al. Analysis of stator curve of low speed high torque water hydraulic motor with radial piston ［J］. Journal of Yanshan University, 2012, 35(6): 493-500．
［9］ 聂松林, 李壮云, 余祖耀. 轴向柱塞式液压马达转矩特性的理论研究［J］. 液压与气动, 2002(7): 7-10．
NIE Song lin, LI Zhuang yun, YU Zu yao. Study on torque characteristic of axial piston hydraulic motor ［J］. Chinese Hydraulics and Pneumatics, 2002(7): 7-10．
［10］ 闻德生, 郑珍泉, 杨杰, 等. 力平衡型双定子轴向柱塞马达的转矩脉动分析［J］. 北京理工大学学报, 2014,34(7) : 676-679．
WEN De sheng, ZHANG Zhen quan, YANG Kai ming,et al. The torque ripple analysis of the force balanced double stator axial piston motor ［J］. Transactions of Beijing Institute of Technology, 2014,34(7) : 676-679．
［11］ 胡竟湘, 谭立新. 液压马达脉动问题研究［J］. 机床与液压, 2008, 36(12):78-80．
HU Jing xiang, TAN Li xin. Study on the hydraulic pulse of hydraulic motors ［J］. Machine Tools and Hydraulics, 2008. 36(12):78-80．
［12］ 邓海顺, 王传礼, 许亚峰,等. 一种双侧驱动平衡式低速大扭矩轴向柱塞马达: 2014206530257 ［P］. 2014 11 03．
［13］ MILLER M K, KHALID H, MICHAEL P W, et al. An investigation of hydraulic motor efficiency and tribological surface properties ［J］. Tribology Transactions, 2014, 57(4): 622-630．
［14］ WANG Z, GU L, LI L. Experimental studies on the overall efficiency performance of axial piston motor with a laser surface textured valve plate ［J］. Proceedings of the Institution of Mechanical Engineers Part B Journal of Engineering Manufacture, 2013, 227(7):1049-1056．
［15］ OSIPOV V, VOROTYNTSEV B, STAZHKOV S, et al. Axial piston hydraulic motor with heightened control range ［J］. Procedia Engineering, 2015,100(2):1455-1458．
［16］ 李壮云. 液压元件与系统:第3版［M］. 北京: 机械工业出版社, 2011:72-74．
［17］ KUMAR S, BERGADA J M, WATTON J. Axial piston pump grooved slipper analysis by CFD simulation of three dimensional NVS equation in cylindrical coordinates ［J］. Computers and Fluids, 2009,38(3): 648-663．
［18］ 邓海顺, 王传礼, 张立祥. 平衡式两排轴向柱塞泵流量脉动的研究［J］. 农业机械学报,2014,45(5):305-309．
DENG Hai shun, WANG Chuan li, ZHANG Li xiang. Study on flow ripple of balanced two ring axial piston pump ［J］. Transactions of the Chinese Society for Agricultural Machinery, 2014,45(5): 305-309． |
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
| |
Shared |
|
|
|
|
| |
Discussed |
|
|
|
|
