|
|
|
| Research on artillery structural parameter optimization based on ADAMS and CPSO algorithm |
| CUI Kai-Bo1, QIN Jun-Qi1, DI Chang-Chun1, ZHANG Yan-Jun2 |
1.Department of Guns Engineering, Ordnance Engineering College, Shijiazhuang 050003, China；
2.Wuhan Ordnance Noncommissioned Officer Academy, Wuhan 430075, China |
|
|
|
Abstract Considering artillery to be a multi-component dynamic model and strongly nonlinear system, traditional optimization method which was directly used in the ADAMS environment to optimize the structural parameters of artillery would encounter many obstacles such as the excessive number of iterations, the optimization effect is not obvious and so on. Therefore, the optimization for artillery structural parameters based on ADAMS and CPSO algorithm was proposed. The virtual prototype of artillery was set up by Pro/E and ADAMS, simulation experimentation was executed subsequently. On this condition, chaotic particle swarm algorithm was used to optimize the structural parameters, optimization effect was obvious. According to the comparation between optimization results and initial value, the method is practically validated．
|
|
Published: 28 August 2012
|
基于ADAMS与CPSO算法的火炮结构参数优化设计研究
针对火炮动力学模型是多部件、强非线性的系统,直接在ADAMS环境下对火炮结构参数进行优化,可能存在实现难度大、迭代次数过多、优化效果不明显等问题,提出了基于ADAMS与CPSO算法相结合的火炮结构参数优化设计方法．在利用Pro/E与ADAMS建立火炮虚拟样机并进行仿真试验的基础上,采用混沌粒子群算法对火炮结构参数进行优化,从而获得火炮结构参数和炮口扰动优化结果．根据优化值与初始值的对比分析,证明了文中所提优化设计方法合理可行．
关键词：
火炮,
虚拟样机,
炮口扰动,
CPSO算法,
参数优化
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
| |
Shared |
|
|
|
|
| |
Discussed |
|
|
|
|
