|
|
Experimental study on slagging characteristics during coal and biomass co-combustion with on-line measurement technique |
Jia-kai ZHANG1( ),Li NIE2,Ke-fa CEN1,Xiao JIANG1,Hao ZHOU1,*( ) |
1. State Key Laboratory of Clean Energy Utilization, Zhejiang University, Hangzhou 310027, China 2. Dongfang Boiler Limited Company, Dongfang Electric Corporation, Chengdu 611731, China |
|
|
Abstract An online measurement technique was applied to analyze the slagging characteristics during co-combustion of coal and stalk in a 50 kW furnace. Results showed that with the addition of biomass stalk, the stable slag thickness increased and the stable relative heat flux decreased compared with combustion of pure coal. When the mass ratio of corn stalks is 0%, 6.7%, 15%, 22%, the corresponding stable thickness of the slag were 1.37, 2.51, 5.21, 5.38 mm, and the stable relative heat fluxes were 0.44, 0.42, 0.37, 0.35. When the mass proportions of peanut stalks were 6.7%, 15%, and 22%, the corresponding stable thickness of the slag were 3.37, 3.89, and 5.33 mm, and the stable relative heat fluxes were 0.39, 0.36, and 0.30. The liquid slag mass fraction which was obtained by Factsage increased significantly when coal was co-fired with stalk. Base-to-acid ratio showed a good performance in predicting the ash behavior and slagging tendency by using four slagging indexes.
|
Received: 16 August 2019
Published: 28 October 2020
|
|
Corresponding Authors:
Hao ZHOU
E-mail: zhangjiakai_111@163.com;zhouhao@cmee.zju.edu.cn
|
生物质秸秆与神府烟煤掺烧结渣特性的在线监测
利用自主开发的在线监测系统,在50 kW的下行炉探究2种生物质秸秆与神府烟煤掺烧的结渣特性. 结果表明,随着生物质秸秆的掺烧,灰渣的稳定厚度增加,稳定热流减小. 当掺烧玉米秸秆质量分数为0%、6.7%、15%、22%时,相应的灰渣稳定厚度为1.37、2.51、5.21、5.38 mm,稳定相对热流密度为0.44、0.42、0.37、0.35. 当掺烧花生秸秆质量分数为6.7%、15%、22%时,相应的灰渣稳定厚度为3.37、3.89、5.33 mm,稳定相对热流密度为0.39、0.36、0.30. 利用热力学计算软件Factsage进行化学平衡计算发现,随着秸秆掺烧比例的增加,灰中熔融相的质量分数增加. 用4种结渣指数对生物质掺烧结渣进行预判,碱酸比的预测最准确.
关键词:
灰沉积,
在线监测,
热流密度,
生物质,
结渣指数
|
|
[1] |
ZHOU W, SWANSON L, MOYEDA D, et al Process evaluation of biomass cofiring and reburning in utility boilers[J]. Energy and Fuels, 2010, 24 (8): 4510- 4517
doi: 10.1021/ef1005379
|
|
|
[2] |
宁新宇, 李诗媛, 吕清刚, 等 秸秆类生物质与石煤在流化床中的混烧与黏结机制[J]. 中国电机工程学报, 2008, 28 (29): 105- 110 NING Xin-yu, LI Shi-yuan, LV Qing-gang, et al Study on co-firing and agglomeration mechanism of stalk biomass and stone coal in fluidized bed[J]. Proceedings of the CSEE, 2008, 28 (29): 105- 110
|
|
|
[3] |
BARTOLOME C, GIL A Ash deposition and fouling tendency of two energy crops (cynara and poplar) and a forest residue (pine chips) co-fired with coal in a pulverized fuel pilot plant[J]. Energy and Fuels, 2013, 27 (10): 878- 889
|
|
|
[4] |
陈炜, 段佳, 林鹏, 等 氧量对典型生物质燃烧特性的影响[J]. 中国电机工程学报, 2008, 28 (2): 43- 48 CHEN Wei, DUAN Jia, LIN Peng, et al Effect of oxygen concentration on combustion characteristics of typical biomass material[J]. Proceedings of the CSEE, 2008, 28 (2): 43- 48
|
|
|
[5] |
栾积毅, 孙锐, 路军锋, 等 生物质再燃脱硝的试验研究[J]. 中国电机工程学报, 2008, 28 (14): 73- 79 LUAN Ji-yi, SUN Rui, LU Jun-feng, et al Experimental studies on reburning with biomass for NOx reduction[J]. Proceedings of the CSEE, 2008, 28 (14): 73- 79
|
|
|
[6] |
NIU Y, TAN H, HUI S Ash-related issues during biomass combustion: Alkali-induced slagging, silicate melt-induced slagging (ash fusion), agglomeration, corrosion, ash utilization, and related countermeasures[J]. Progress in Energy and Combustion Science, 2016, 52: 1- 61
doi: 10.1016/j.pecs.2015.09.003
|
|
|
[7] |
WANG X, TAN H, NIU Y, et al Experimental investigation on biomass co-firing in a 300 MW pulverized coal-fired utility furnace in China[J]. Proceedings of the Combustion Institute, 2011, 33 (2): 2725- 2733
doi: 10.1016/j.proci.2010.06.055
|
|
|
[8] |
VAMVUKA D, MISTAKIDOU E, DRAKONAKI S, et al Ash quality of a beneficiated lignite from Ptolemais Basin, Northern Greece[J]. Energy and Fuels, 2001, 15: 1181- 1185
doi: 10.1021/ef0100193
|
|
|
[9] |
ZHENG Z, WANG H, CAI Y, et al A novel method used to study growth of ash deposition and in situ measurement of effective thermal conductivity of ash deposit[J]. Heat Transfer-Asian Research, 2018, 47: 271- 285
doi: 10.1002/htj.21302
|
|
|
[10] |
WANG Y, TAN H, WANG X, et al The condensation and thermodynamic characteristics of alkali compound vapors on wall during wheat straw combustion[J]. Fuel, 2017, 187: 33- 42
doi: 10.1016/j.fuel.2016.09.014
|
|
|
[11] |
LUAN C, YOU C, ZHANG D Composition and sintering characteristics of ashes from co-firing of coal and biomass in a laboratory-scale drop tube furnace[J]. Energy, 2014, 69: 562- 570
doi: 10.1016/j.energy.2014.03.050
|
|
|
[12] |
ROBINSON A, JUNKER H, BAXTER L Pilot-scale investigation of the influence of coal?biomass cofiring on ash deposition[J]. Energy and Fuels, 2002, 16 (2): 343- 355
doi: 10.1021/ef010128h
|
|
|
[13] |
WANG G, PINTO T, COSTA M Investigation on ash deposit formation during the co-firing of coal with agricultural residues in a large-scale laboratory furnace[J]. Fuel, 2014, 117: 269- 277
doi: 10.1016/j.fuel.2013.09.084
|
|
|
[14] |
KUPKA T, MANCINI M, IRMER M, WEBER R Investigation of ash deposit formation during co-firing of coal with sewage sludge, sawdust and refuse derived fuel[J]. Fuel, 2008, 87 (12): 2824- 2837
doi: 10.1016/j.fuel.2008.01.024
|
|
|
[15] |
MOLCAN P, LU G, BRIS T, et al Characterisation of biomass and coal co-firing on a 3 MWth combustion test facility using flame imaging and gas/ash sampling techniques[J]. Fuel, 2009, 88 (12): 2328- 2334
doi: 10.1016/j.fuel.2009.06.027
|
|
|
[16] |
NIU Y, TAN H, MA L, et al Slagging characteristics on the superheaters of a 12 MW biomass-fired boiler[J]. Energy and Fuels, 2010, 24 (11): 5222- 5227
|
|
|
[17] |
PANG C, HEWAKANDAMBY B, WU T, et al An automated ash fusion test for characterization of the behaviour of ashes from biomass and coal at elevated temperatures[J]. Fuel, 2013, 103: 454- 466
doi: 10.1016/j.fuel.2012.06.120
|
|
|
[18] |
LI Q, ZHANG Y, MENG A, et al Study on ash fusion temperature using original and simulated biomass ashes[J]. Fuel Processing Technology, 2013, 107: 107- 112
doi: 10.1016/j.fuproc.2012.08.012
|
|
|
[19] |
FANG X, JIA L Experimental study on ash fusion characteristics of biomass[J]. Bioresource Technology, 2012, 104: 769- 774
doi: 10.1016/j.biortech.2011.11.055
|
|
|
[20] |
ZHOU H, ZHANG J, ZHANG K Investigation of the deposition characteristics of ammonium bisulfate and fly ash blend using an on-line digital image technique: effect of deposition surface temperature[J]. Fuel Processing Technology, 2018, 179: 359- 368
doi: 10.1016/j.fuproc.2018.07.030
|
|
|
[21] |
YANG X, INGHAM D, MA L, et al Predicting ash deposition behaviour for co-combustion of palm kernel with coal based on CFD modelling of particle impaction and sticking[J]. Fuel, 2016, 165: 41- 49
doi: 10.1016/j.fuel.2015.10.056
|
|
|
[22] |
NIU Y, ZHU Y, TAN H, et al Investigations on biomass slagging in utility boiler: criterion numbers and slagging growth mechanisms[J]. Fuel Processing Technology, 2014, 128: 499- 508
doi: 10.1016/j.fuproc.2014.07.038
|
|
|
[23] |
周斌. 劣质煤积灰结渣的可视化研究及其在富氧条件下的烧结特性研究[D]. 杭州: 浙江大学, 2015. ZHOU Bin. Visualization research of fouling and slagging for inferior coal and its sintering behavior under oxy-fuel combustion atmosphere [D]. Hangzhou: Zhejiang University, 2015.
|
|
|
[24] |
潘攀. 煤的结渣特性研究[D]. 北京: 华北电力大学, 2007. PAN Pan. Slagging property research of coal [D]. Beijing: North China Electric Power University, 2007.
|
|
|
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
|
Shared |
|
|
|
|
|
Discussed |
|
|
|
|