Please wait a minute...
J4  2012, Vol. 46 Issue (4): 577-583    DOI: 10.3785/j.issn.1008-973X.2012.04.001
能源与机械工程     
偏置出口循环流化床内颗粒体积分数分布的测试
田晨, 王勤辉, 程乐鸣, 骆仲泱, 倪明江
浙江大学 能源清洁利用国家重点实验室,浙江 杭州 310027
Experimental investigation on local particle volume fractions
distribution in offset-exit circulating fluidized bed
TIAN Chen, WANG Qin-hui, CHENG Le-ming, LUO Zhong-yang, NI Ming-jiang
State Key Laboratory of Clean Energy Utilization, Zhejiang University, Hangzhou 310027, China
 全文: PDF  HTML
摘要:

为了研究不同床体布置结构对循环流化床内气固流动特性的影响,在截面为0.35 m ×0.48 m、高4.9 m的循环流化床实验台上,以平均粒径为366.2 μm的玻璃珠为床料,采用PC6D反射式光纤探针对不同轴向高度截面上不同径向位置处的局部颗粒体积分数分布进行实验测量.采用数值插值和时序分析的方法对测量结果进行分析后发现:床内结构的布置对炉内气固两相流动的影响明显,底部炉膛单侧渐扩结造成颗粒体积分数的径向分布不均,后墙侧颗粒体积分数明显高于前墙侧;受炉膛矩形截面的影响,炉膛截面长边处的颗粒体积分数明显低于短边处的颗粒体积分数;稀相区偏置炉膛出口的布置破坏了炉内气固流动的环核结构,在炉膛左墙和后墙侧形成了颗粒的局部高体积分数分布.利用时序分析的方法对颗粒体积分数瞬时信号进行分析.结果表明,在该工况条件下炉膛底部的气固流动在微观结构上为不稳定的两相结构,在过渡段环核结构的交界位置气固作用最剧烈,颗粒体积分数波动较大.

Abstract:

The local solid-particle volume fraction distributions were studied in a plexiglas rectangular CFB cold model with the size of 0.35 m ×0.48 m×4.9 m by using a reflective-type fiber-optic particle concentration probe (PC6D) in order to analyze the effects of the geometry structure on the gas-solid flow properties. The transparent glass bead with 366.2 μm diameter was used as bed materials during the experiment. Time series analysis and numerical interpolation methods were adopted to analyze the experimental data. Results showed that: in transition region, the expanding cross-section of wear wall structure significantly affected the gassolid flow and the radial distribution of solid volume fraction was asymmetry; the local solid volume fraction near the wear wall was higher than the solid volume fraction near the front wall. In the dilute region, the offset-exit and the corner effect induced the defluxion of the particles movement and the core-annular distribution was broken. Time series analysis of the transient signals indicated that the two-phase structure in the bottom was unstable, and in the transition region the solids fluctuation was acute near the boundary between the core and annular section.

出版日期: 2012-05-17
:  TK 224  
基金资助:

国家“十一五”科技支撑计划资助项目(2006BAA03B01-06).

通讯作者: 王勤辉,男,博导.     E-mail: qhwang@zju.edu.cn
作者简介: 田晨(1983—), 男,博士生,从事循环流化床气固两相流动的研究.E-mail: wftc1983614@zju.edu.cn
服务  
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章  

引用本文:

田晨, 王勤辉, 程乐鸣, 骆仲泱, 倪明江. 偏置出口循环流化床内颗粒体积分数分布的测试[J]. J4, 2012, 46(4): 577-583.

TIAN Chen, WANG Qin-hui, CHENG Le-ming, LUO Zhong-yang, NI Ming-jiang. Experimental investigation on local particle volume fractions
distribution in offset-exit circulating fluidized bed. J4, 2012, 46(4): 577-583.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2012.04.001        http://www.zjujournals.com/eng/CN/Y2012/V46/I4/577

[1] 漆小波,曾涛,黄卫星,等.循环流化床提升管中团聚物颗粒浓度的实验研究[J].四川大学学报,2005, 37(5): 46-50.
QI Xiaobo, ZENG Tao, HUANG Weixing, et al. Experimental study of solids holdups inside particle clusters in CFB risers [J]. Journal of Sichuan University, 2005, 37(5): 46-50.
[2] 周浩生,陆继东,刘德昌,等. 循环流化床稀相区流动结构的实验研究[J].燃烧科学与技术,1998, 4(4): 391-395.
ZHOU Haosheng, LU Jidong, LIU Dechang, et al. Flow structure in circulating fluidized bed riser [J]. Journal of Combustion Science and Technology, 1998, 4(4): 391-395.
[3] ZHU Haiyan, ZHU Jesse, LI Guozheng, et al. Detailed measurements of flow structure inside a dense gassolid fluidized bed [J]. Powder Technology, 2008, 180(3): 339-349.
[4] FAN Xianfeng, DAVID J P, YANG Zhufang, et al. The effect of bed materials on the solid/bubble motion in a uidised bed [J]. Chemical Engineering Science, 2008, 63(4): 943-950.
[5] MARIA L M, UMBERTO A. The effect of particle size and density on solids distribution along the riser of a circulating fluidized bed [J]. Chemical Engineering Science, 1999, 54(22): 5383-5391.
[6] 安恩科,谭厚章,李军,等. CFB主床的床顶结构对边壁下降流的影响[J]. 热力发电,1998(6): 4-6.
AN Enke, TAN Houzhang, LI Jun, et al. Experimental investigation about the down flow on the bed wall in CFB boiler [J]. Thermal Power Generation, 1998(6): 4-6.
[7] 马健,张伟,马天星,等. 炉顶结构对循环流化床锅炉颗粒内循环影响的实验研究[J]. 锅炉技术, 2007, 38(3): 23-28.
MA Jian, ZHANG Wei, MA Tianxing, et al. Experimental study of influence on internal solid particles circulation exerted by exit structure of CFB boiler [J]. Boiler Technology, 2007, 38(3): 23-28.
[8] HARRIS A T, DAVIDSON J F, THORPE R B. The influence of the riser exit on the particle residence time distribution in a circulating fluidized bed riser [J]. Chemical Engineering Science, 2003, 58(16): 3669-3680.
[9] HARRIS A T, DAVIDSON J F, THORPE R B. Particle residence time distributions in circulating fluidized beds [J]. Chemical Engineering Science, 2003, 58(11): 2181-2202.
[10] 刘宝勇,魏绪玲,郭庆杰,等. 大型循环流化床底部区域颗粒浓度波动研究[J]. 兰州交通大学学报, 2009, 28(3): 174-179.
LIU Baoyong, WEI Xuling, GUO Qingjie, et al. Research on particle concentration fluctuation in the bottomzone of a plant circulating fluidized bed [J]. Journal of Lanzhou Jiaotong University, 2009, 28(3): 174-179.
[11] LIN Qian, WEI Fei, JIN Yong. Transient density signal analysis and twophase microstructure flow in gassolid fluidization [J]. Chemical Engineering Science, 2001, 56(6): 2179-2189.
[12] ZHANG Hai, JOHNSTON P M, ZHU J X, et al. A novel calibration procedure for a fiber optic solids concentration probe [J]. Powder Technology, 1998, 100(2/3): 260-272.
[13]TIAN Chen, WANG Qinhui, LUO Zhongyang, et al. Effect of riser geometry structure on local flow pattern in a rectangular circulating fluidized bed [C]∥Proceedings of the 20th International Conference on Fluidized Bed Combustion. Xi’an: Springer, 2009: 464-470.
[14] 黄卫星,漆小波,潘永亮,等. 气固循环床提升管内的局部颗粒浓度及流动发展[J]. 高校化学工程学报, 2002, 16(6): 626-630.
HUANG Weixing, QI Xiaobo, PAN Yongliang, et al. Local solidparticle concentration and flow development in a long CFB riser [J]. Journal of Chemical Engineering of Chinese Universities, 2002, 16(6): 626-630.
[15] 黄素华,陆继东,钱诗智. 矩形平壁循环流化床冷态流动特性研究[J]. 热能动力工程, 1995, 10(3): 144-148.
HUANG Suhua, LU Jidong, QIAN Shizhi. A study on the coldstate flow characteristics of a rectangular flat wall circulating fluidized bed [J]. Journal of Engineering for Thermal Energy and Power, 1995, 10(3): 144-148.

No related articles found!