Please wait a minute...
浙江大学学报(工学版)
J4  2009, Vol. 43 Issue (09): 1687-1691    DOI: 10.3785/j.issn.1008-973X.2009.
化学工程     
双峰聚乙烯颗粒临界流化速度的研究任
聪静,王靖岱,阳永荣
（浙江大学 化学工程与生物工程学系,化学工程联合国家重点实验室,浙江 杭州 310027）
Minimum fluidization velocity of bimodal polyethylene particles
REN Cong-jing, WANG Jing-dai , YANG Yong-rong
(State Key Laboratory of Chemical Engineering, Department of Chemical and Biochemical Engineering,
Zhejiang University, Hangzhou 310027, China) 
 全文: PDF(605 KB)   HTML
摘要：

针对环管和流化床串联的组合工艺中双峰聚乙烯黏性颗粒流化状况不佳的现状,利用压差法系统考察了温度和粒径对临界流化速度的影响,以及温度对粒径分布的影响.结果表明,压降-气速关系不符合经典轨迹,压降曲线波动较普通树脂显著,流化过程依次表现为颗粒流化和聚团流化两个过程.由于双峰聚乙烯中低相对分子质量部分的存在,聚合物颗粒间表现出较强的黏性,引起团聚现象,粒径分布变宽.表观最小流化速度与经典公式计算数据偏离较大,其数值随温度的升高呈增大趋势,且粒径越小,温度对最小流化速度的影响就越大.通过添加黏性力项,重新建立颗粒的力平衡,获得了具有较高精度的临界流化速度模型.
Abstract:

The influences of temperature and particle size on the minimum fluidization velocity and the influence of temperature on the particle size distribution were observed by pressure-drop method according to the abnormal fluidization of bimodal polyethylene sticky particles in the combined process of loop reactor and fluidized bed. Results showed that the pressure curves were different from the classical ones, which had remarkable fluctuation and two fluidization processes including particle fluidization and agglomeration fluidization. The polymer particles showed strong stickiness and had wider particle size distribution by agglomeration for the relative lower molecular mass part exist in bimodal polyethylene. The minimum fluidization velocity of the sticky bimodal particles was different with that from classical formula. The minimum fluidization velocity increased with temperature. The smaller particles were, the greater effect temperature played on the minimum fluidization velocity. A model to calculate the minimum fluidization velocity of bimodal polyethylene was deduced by adding a cohesion item to the particle force balance．
:  TQ 021.1  
基金资助:

国家自然科学基金资助项目（20676114，20736011）；国家“863”高技术研究发展计划资助项目（2007AA04Z182）.
通讯作者: 王靖岱，男，副教授.     E-mail: wangjd@zju.edu.cn
作者简介: 任聪静（1983-），女，浙江温州人，博士生，从事多相流的研究.
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　

引用本文:

任聪静, 王靖岱, 阳永荣. 双峰聚乙烯颗粒临界流化速度的研究任[J]. J4, 2009, 43(09): 1687-1691.

LIN Cong-Jing, WANG Jing-Dai, YANG Yong-Rong. Minimum fluidization velocity of bimodal polyethylene particles. J4, 2009, 43(09): 1687-1691.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2009.    或    http://www.zjujournals.com/eng/CN/Y2009/V43/I09/1687

[1]BASU P. A study of agglomeration of coal-ash in fluidized beds[J]. The Canadian Journal of Chemical Engineering, 1982, 60(6): 791-795.
[2]TARDOS G, MAZZONE D, PFEFFER R. Unsteady flow of a compressible gas through consolidated porous media:application to deaeration of hoppers[J]. The Canadian Journal of Chemical Engineering, 1985, 63(2): 384-389.
[3]李洪钟.气固流态化的散式化[M]. 北京: 化学工业出版社, 2002.
[4]REINA J, VELO E, PUIGJANER L. Predicting the minimal fluidization velocity of polydisperse mixture of scrap-wood particles[J]. Powder Technology, 2000, 111(3): 245-251.
[5]陈甘棠.化学反应工程[M]. 北京: 化学工业出版社, 1989.
[6]周勇, 梁华琼, 石炎福.超细颗粒流化机理和结块行为的研究[J].化学反应工程与工艺,2003,19 (4): 289-294.
ZHOU Yong, LIANG Hua-qiong, SHI Yan-fu. Study on fluidization mechanism and agglomerating behavior of ultrafine powders[J]. Chemical Reaction Engineering and Technology, 2003, 19(4): 289-294.
[7]ARASTOOPOUR H, HUANG C, WELL S. Fluidization behavior of sticky particles[J]. Particle Science and Technology, 1986, 4(3): 321-332.
[8]LISS B, BLAKE T, SQUIREL A. Incipient defluidization of sinterable solids[C]∥4th International Conference on Fluidization. Japan:[s. n.], 1984: 249-256.
[9]KUNII D, LEVENSPIEL O. Fluidization engineering [M]. Boston: Imprenta, 1962
[1] 孙婧元, 楼佳明, 黄正梁, 王靖岱, 蒋斌波, 阳永荣. 液体雾化效果的检测及流体力学模拟[J]. J4, 2012, 46(2): 218-225.
[2] 任聪静, 王靖岱, 阳永荣. 气固流化床中不同颗粒的流动模式及其转变[J]. J4, 2010, 44(2): 305-309.