Please wait a minute...
J4  2013, Vol. 47 Issue (11): 2038-2045    DOI: 10.3785/j.issn.1008-973X.2013.11.023
电气工程、电信技术     
 基于多个压电换能器的接口电路
霍新新1,2,褚金奎1,2,韩冰峰1,2,姚斐1,2
1.大连理工大学 精密与特种加工教育部重点实验室,辽宁 大连 116023;
2.辽宁省微纳米技术及系统重点实验室,辽宁 大连 116023  
Research on interface circuits of multiple piezoelectric generators
HUO Xin-xin1,2, CHU Jin-kui1,2,HAN Bing-feng1,2, YAO Fei1,2
1. Key Laboratory for Dalian University of Technology Precision & Non-traditional Machining of
Ministry of Education, Dalian University of Technology, Dalian 116023, China|2.Key Laboratory for Micro/Nano
Technology and System of Liaoning Province, Dalian University of Technology, Dalian 116023, China
 全文: PDF  HTML
摘要:

为了探究多压电换能器并联时的能量输出特性,以标准电路和同步电感电路(SSHI)为基础提出4种多压电换能器并联电路,对4种电路下的输出功率进行理论推导,并探讨激振力之间相位差对并联输出功率的影响.结果表明:如果多压电换能器采用先并联后整流的标准/SSHI电路,激振力之间相位差对输出功率有影响,并且最终的并联输出功率由相位差、激振频率及接口电路共同决定.如果多压电换能器采用先整流后并联的标准/SSHI电路,激振力之间相位差对并联输出功率没有影响,输出功率由激振频率和接口电路决定.对比4种接口电路,采用先整流后并联的SSHI接口电,输出功率峰值较高、带宽较宽,在4种电路中综合效果更好.

Abstract:

To explore the output power performance of multiple piezoelectric generators which are connected in parallel mode and work cooperatively, four kinds of parallel-connection interface circuits for multiple piezoelectric generators were proposed based on the standard circuit and the synchronized switch harvesting on inductor (SSHI) circuit. The output power in these four kinds of interface circuits was theoretically derived and the influence on it by the phase difference among the exciting forces was studied. The results show that for piezoelectric generators connected in parallel mode, if the piezoelectric generators are rectified after parallel connection and link with standard/ SSHI circuit, the phase difference between exciting forces has effect on the output power, and the output power is decided by the phase difference,the interface circuit and the excitation frequency. If piezoelectric generators are connected in parallel after rectifier bridges and link with standard/SSHI circuit, the phase difference has no effect on the output power and in this situation, the output power is decided by both the interface circuit and the excitation frequency. Compared among the four kinds of interface circuits, a system consists of multiple piezoelectric generators which are connected in parallel after rectifier bridges and link with SSHI circuit has higher output power and wider frequency bandwidth, so its comprehensive results are more acceptable.

出版日期: 2013-11-01
:     
基金资助:

国家自然科学基金资助项目(51175056);国家“973”重点基础研究计划资助项目(2011CB302105).

通讯作者: 褚金奎,男,教授、博导.     E-mail: chujk@dlut.edu.cn
作者简介: 霍新新(1988-)男,硕士生,从事新能源技术研究. E-mail:huoxinxin1122@126.com
服务  
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章  

引用本文:

霍新新,褚金奎,韩冰峰,姚斐.  基于多个压电换能器的接口电路[J]. J4, 2013, 47(11): 2038-2045.

HUO Xin-xin, CHU Jin-kui,HAN Bing-feng, YAO Fei. Research on interface circuits of multiple piezoelectric generators. J4, 2013, 47(11): 2038-2045.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2013.11.023        http://www.zjujournals.com/eng/CN/Y2013/V47/I11/2038

[1]POULIN G, SARRAUTE E, COSTA F. Generation of electrical energy for portable devices: comparative study of an electromagnetic and a piezoelectric system [J]. Sensors Actuators A:Physcial, 2004, 116(3): 46171.
[2] ROUNY S, WRIGHT P K. A piezoelectric vibration based generator for wireless electronics [J]. Smart Materials and Structures , 2004, 13(5): 113-142.
[3] DUTOIT N E, WARDLE B L, KIM S G. Design considerations for MEMS-scale piezoelectric mechanical vibration energy harvesters [J]. Integrated. Ferroelectrics, 2005, 71(1) : 12160.
[4] LEFEUVRE E, BADEL A, BENAYAD A, et al. A comparison between several approaches of piezoelectric energy harvesting [J]. Journal de Physique: An International Journal, 2005, 128(1): 17786.
[5] SHU Y C, LIEN I C. Analysis of power output for piezoelectric energy harvesting systems [J]. Smart Materials and Structures, 2006, 15(6): 1499512.
[6] GUYOMAR D, BADEL A, LEFEUVRE E. Toward energy harvesting using active materials and conversion improvement by nonlinear processing [J]. Ultrasonics, Ferroelectrics and Frequency Control, IEEE Transactions on, 2005, 52(4): 58495.
[7] BADEL A, GUYOMAR D, LEFEUVRE E, et al. Efficiency enhancement of a piezoelectric energy harvesting device in pulsed operation by synchronous charge inversion[J]. Journal of Intelligent Material Systems and Structures,2005, 16(10): 889-901.
[8] BADEL A, GUYOMAR D, LEFEUVRE E,et al. Piezoelectric energy harvesting using a synchronized switch technique [J]. Journal of Intelligent Material Systems and Structures, 2006, 17(8): 8319.
[9] MAKIHAR K, ONODA J, MIYAKAWA T. Low energy dissipation electric circuit for energy harvesting [J]. Smart Materials and Structures, 2006, 15(5): 14938.
[10] 阚君武,王淑云,彭少锋,等.多振子压电发电机的输出特性[J]. 光学精密工程,2011, 19(9): 210815.
KAN Jun-Wu, WANG Shu-Yun, PENG Shao-Feng, et al. Output performance of piezoelectric generators with multi-vibrators [J]. Optics and Precision Engineering, 2011, 19(9): 201815.
[11] LIEN I S, SHU Y C. Array of piezoelectric energy harvesters[C]∥SPIE Smart Structures and Materials Nondestructive Evaluation and Health Monitoring. San Diego, California, USA:International Society for Optics and Photonics, 2011:79770k-79770K-9.
[12] HAGOOD N W, CHUNG W H, FLOTOW A V. Modelling of piezoelectric actuator dynamics for active structural control[J]. Journal of Intelligent Material Systems and Structures, 1990, 1(3): 32754.
[13] WANG Q M, CROSS L E, Constitutive equations of symmetrical triple layer piezoelectric benders\
[J\]. Ultrasonics, Ferroelectrics and Frequency Control, IEEE Transactions on, 1999, 46(6): 1343-1351.

[1] 宁志华,何乐年,胡志成. 一种高压高可靠性开关电源控制芯片[J]. J4, 2014, 48(3): 377-383.
[2] 李林,陈家旺,顾临怡,王峰. 轴向柱塞泵/马达变量阀配流机构[J]. J4, 2014, 48(1): 29-34.
[3] 陈钊,余锋,陈婷婷. 基于日志结构的闪存均衡回收策略[J]. J4, 2014, 48(1): 92-99.
[4] 蒋湛,姚晓明,林兰芬. 基于特征自适应的本体映射方法[J]. J4, 2014, 48(1): 76-84.
[5] 陈迪仕 ,张宇,李平. 微小型无人直升机地面效应建模[J]. J4, 2014, 48(1): 154-160.
[6] 杨鑫,许端清,杨冰. 基于不规则性的并行计算方法[J]. J4, 2013, 47(11): 2057-2064.
[7] 王玉强,张宽地,陈晓东. 胶黏钢-混凝土组合梁的界面行为数值分析[J]. J4, 2013, 47(9): 1593-1598.
[8] 崔何亮, 张丹, 施斌.  布里渊分布式传感的空间分辨率及标定方法[J]. J4, 2013, 47(7): 1232-1237.
[9] 彭勇,徐小剑. 集料分布对沥青混合料劈裂强度影响数值分析[J]. J4, 2013, 47(7): 1186-1191.
[10] 伍晓榕,裘乐淼,张树有,孙良峰,郭传龙. 模糊语境下的复杂系统关联FMEA方法[J]. J4, 2013, 47(5): 782-789.
[11] 金波,陈诚,李伟. 具有半球形足端的六足机器人步态修正算法[J]. J4, 2013, 47(5): 768-774.
[12] 钟世英, 吴晓君, 蔡武军, 凌道盛, 蒋祝金, 王顺玉. 月面软着陆足垫水平拖曳模型试验装置研制[J]. J4, 2013, 47(3): 465-471.
[13] 袁幸,朱永生,张优云,洪军,祁文昌. 基于正反问题的滚动轴承损伤程度评估[J]. J4, 2012, 46(11): 1960-1967.
[14] 杨飞,朱株,龚小谨,刘济林. 基于三维激光雷达的动态障碍实时检测与跟踪[J]. J4, 2012, 46(9): 1565-1571.
[15] 王鹿军, 吕征宇. 基于LSSVM的电梯交通模式的模糊识别[J]. J4, 2012, 46(7): 1333-1338.