Please wait a minute...
浙江大学学报(工学版)
J4  2012, Vol. 46 Issue (6): 1090-1096    DOI: 10.3785/j.issn.1008-973X.2012.06.020
土木工程     
PBL剪力连接件的疲劳试验与分析
欧阳雯欣, 王清远, 石宵爽, 谭莲飞, 彭泽维
四川大学 建筑与环境学院, 四川 成都610065
Fatigue test and analysis of PBL shear connectors
OUYANG Wen-xin, WANG Qing-yuan, SHI Xiao-shuang, TAN Lian-fei, PENG Ze-wei
College of Architecture and Environment, Sichuan University, Chengdu 610065, China
 全文: PDF  HTML
摘要：

为了研究PBL (Perfobond Leiste)这种新型剪力连接件的抗疲劳性能,基于深圳南山大桥剪力连接件的尺寸和要求,设计并制作了6个PBL剪力连接件的推出试件进行疲劳试验.试验在MTS815机器上进行,采用常幅正弦波荷载,加载频率为3 Hz,试验应力比为0.1.通过对试件进行常幅荷载的循环加载,观察试件中钢与混凝土块的相对滑移、连接件的破坏模式、疲劳寿命以及应变的特征等.试验结果表明：主要开裂方向为连接件底部斜向下呈45°,裂缝的宽度同裂缝与竖向的夹角成反比；疲劳荷载作用时,PBL连接件的抗疲劳性能良好,孔径越大试件的疲劳寿命越长；试验从一定程度上说明腹板越厚和疲劳荷载幅值越小,滑移量的增长速度越慢,同时孔径越大和疲劳幅值越小,滑移量的增长速度也越慢.
Abstract:

 In order to study the anti-fatigue performance of a new shear connector: Perfobond Leiste(PBL), six launched specimens with PBL shear connectors were designed and produced to be carried on the fatigue test according to dimension and requirements of the shear connector used in Nanshan bridge in Shenzhen. Experiments were done on MTS815 under constant amplitude sine wave with 3 Hz load frequency and 0.1 stress rate. Through applying to the specimens by a constant amplitude cyclic loading, the slip of the steel and concrete block in specimen, failure modes of shear connectors, fatigue life and characteristics of strain and so on were observed. The results show that: the direction of the main crack is at the bottom of the connector under the 45° diagonal, while the crack width and the angle of the crack with vertical is inversely proportional; Under fatigue loading, PBL connector has a good fatigue resistance, the larger aperture the longer the fatigue life of specimens; the test to a certained extent explains that the thicker webs and the smaller amplitude of fatigue loading, the slip grew more slowly; meanwhile, the larger aperture and the smaller amplitude fatigue loading, the slip grew more slowly too.
出版日期: 2012-07-24
:  TU 398  
基金资助:

 国家自然科学基金资助项目(NSFC-50978174)；深圳市科技资助项目(JC200903130339A).
通讯作者: 王清远,男,教授.     E-mail: wangqy@scu.edu.cn
作者简介: 欧阳雯欣（1986—）,女,硕士生,从事组合结构及结构耐久性研究.E-mail: leng_ok@126.com
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　

引用本文:

欧阳雯欣, 王清远, 石宵爽, 谭莲飞, 彭泽维. PBL剪力连接件的疲劳试验与分析[J]. J4, 2012, 46(6): 1090-1096.

OUYANG Wen-xin, WANG Qing-yuan, SHI Xiao-shuang, TAN Lian-fei, PENG Ze-wei. Fatigue test and analysis of PBL shear connectors. J4, 2012, 46(6): 1090-1096.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2012.06.020    或    http://www.zjujournals.com/eng/CN/Y2012/V46/I6/1090

［1］ 刘玉擎,曾明根,陈艾荣.连接件在桥梁结构中的应用与研究［J］.哈尔滨工业大学学报,2003,35(8): 272-275.
LIU Yuqing,ZENG Minggen,CHEN Airong.Application and research of shear connectors in bridge structures［J］. Journal of Harbin Institute of Technology, 2003, 35(8): 272-275.
［2］ OGUEJIOFOR E C， HOSAIN M U. Numerical analysis of pushout specimens with perfobond rib connectors［J］. Computers & Structures, 1997,62(4): 617-624.
［3］ J da C VIANNA, L F COSTANEVES, P C G da S VELLASCO, et al. Structural behaviour of TPerfobond shear connectors in composite girders: an experimental approach［J］.Engineering Structures, 2008,30(9): 2381-2391.
［4］ ISABEL VALENTE, PAULO J S CRUZ. Experimental analysis of Perfobond shear connection between steel and lightweight concrete［J］. Journal of Constructional Steel Research, 2004,60: 465-479.
［5］ J P S CANDIDOMARTINS, L F COSTANEVES, P C G da S VELLASCO. Experimental evaluation of the structural response of Perfobond shear connectors［J］. Engineering Structures, 2010, 32(8): 1976-1985.
［6］ 聂建国,沈聚敏,袁彦声,等.钢混凝土组合梁中剪力连接件实际承载力的研究［J］.建筑结构学报,1996,17(2): 21-28.
NIE Jianguo,SHEN jumin,YUAN Yansheng,et al. The research of shear connectors practical bearing capacity in Steel and concrete composite beams［J］. Journal of Building Structures,1996,17(2): 21-28.
［7］ 刘晓琴. 波纹钢腹板预应力混凝土箱梁剪力连接件受力性能研究［D］.成都:西南交通大学,2009.
LIU Xiaoqin. Behaviour study of shear connector in prestressed concrete box girder with corrugated stee1 webs. ［D］.Chengdu: Southwest Jiaotong University, 2009.
［8］ 宗周红,车惠民.剪力连接件静载和疲劳试验研究［J］.福州大学学报：自然科学版,1999,27(6): 61-66.
ZONG Zhouhong,CHE Huimin.Static load and fatigue test research of shear connector［J］. Journal of Fuzhou University: Natural Science, 1999,27(6): 61-66.
［9］ SLUTTER R G, DRISCOLL G C. Flexural strength of steelconerete composite beams［J］. Journal of the Structural Division, ASCE, 1965,91(2): 71-99.
［10］ 方冬慧,刘永杰,陈宜言,等.Q345桥梁钢超长寿命疲劳性能研究［J］,中国科技论文在线,2009,4(7): 480-484.
FANG Donghui,LIU Yongjie,CHEN Yiyan, et al. Super long life fatigue behaviors of Q345 bridge steel［J］.Sciencepaper Online,2009,4(7): 480-484.
［11］ 刘玉擎.组合结构桥梁［M］.北京:人民交通出版社,2005: 38-39.
［12］ 徐国平,刘高,吴文明.开孔板连接件在钢混凝土结合部中的应用［C］∥第十八届全国桥梁学术会议论文集（上册）.北京:中国土木工程学会,2008: 460-465.
XU Guoping,LIU Gao,WU Wenming.The application of Perforated plate connections in steelconcrete junction［C］∥The 18th National Bridge Academic Conferences Proceedings(The first volume) . Beijing: China Civil Engineering Society,2008: 460-465.
No related articles found!