Please wait a minute...
J4  2010, Vol. 44 Issue (5): 1032-1037    DOI: 10.3785/j.issn.1008-973X.2010.05.033
电气工程     
水轮机定子铁芯冲片外移事故有限元分析
李蔚1, 张浩权2, 钱泱3, 蒋志强1, 盛德仁1
1.浙江大学 热工与动力系统研究所,浙江 杭州 310027; 2.浙江省电力公司,浙江 杭州 310012;
3.紧水滩水力发电厂,浙江 丽水 323000
Finite element analysis for outer-movement accidents of
stator core laminated sheets of hydro-generator
LI Wei1, ZHANG Hao-quan2, QIAN Yang3, JIANG Zhi-qiang1, SHENG De-ren1
1.Institute of Thermal Science and Power System, Zhejiang University, Hangzhou 310027, China; 2. Zhejiang
Electric Power Corporation, Hangzhou 310012, China; 3. Jinshuitan Hydro Electric Power Plant, Lishui 323000, China
 全文: PDF  HTML
摘要:

采用有限元分析法,建立完整的定子模型,并采用热结构耦合边界条件,对定子的温度场和应力场进行详细计算.计算结果表明,当定子铁芯两端施加的预紧力减弱、消失或冷却通风条件降低时,上、下两端冲片鸽尾槽的应力明显增大,从255 MPa增大到439 MPa;另外冲片鸽尾槽处的无过渡圆角设计,直接导致此处应力集中出现碎裂,在电磁拉力作用下发生冲片外移事故.建议同类型机组在检修时,应特别关注冲片的压紧程度,运行时应保持通风系统的清洁.

Abstract:

A complete model of the stator based on the actual structure was established by using the finite element method. The stator temperature field and the stress field were calculated under the thermalstructural coupledfield boundary conditions. The effects on the stress of dovetail grooves at the upper and lower ends were analyzed by changing the pretightening force at both ends of the stator and the internal cooling and ventilation conditions. The stress of dovetail grooves significantly increased from 255 MPa to 439 MPa, when the imposed preload of the stator weakened, disappeared, or when the cooling conditions became worse. The dovetail grooves were designed without obvious fillets, which directly leaded to the stress concentration and the outermovement accidents of stator core laminated sheets. The compression degree of the sheets should be concerned and the ventilation system must remain clean during the inspection of the same type units.

出版日期: 2012-03-19
:  TM 312  
通讯作者: 盛德仁,男,教授.     E-mail: shengdr@zju.edu.cn
作者简介: 李蔚(1974—),女,浙江兰溪人,讲师,从事发电厂在线监测和运行优化的研究.E-mail: energy@zju.edu.cn
服务  
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章  

引用本文:

李蔚, 张浩权, 钱泱, 蒋志强, 盛德仁. 水轮机定子铁芯冲片外移事故有限元分析[J]. J4, 2010, 44(5): 1032-1037.

LI Wei, ZHANG Gao-Quan, JIAN Yang, JIANG Zhi-Jiang, CHENG De-Ren. Finite element analysis for outer-movement accidents of
stator core laminated sheets of hydro-generator. J4, 2010, 44(5): 1032-1037.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2010.05.033        http://www.zjujournals.com/eng/CN/Y2010/V44/I5/1032

[1] 胡敏强,陈贤珍,周克定.定子铁芯三维温度场的有限元计算[J].华中理工大学学报,1990,18(4):1522.
HU Minqiang, CHEN Xianzhen, ZHOU Keding. Calculation of three dimensional temperature field in the stator core of large turboalterator by the finite element method[J]. Journal Huazhong University of Science and Technology, 1990, 18(4): 1522.
[2] 黄学良,胡敏强,周鹗.电机三维温度场新的有限元计算模型[J].中国电机工程学报,1998,18(2):7882.
HUANG Xueliang, HU Minqiang, ZHOU E. Novel FEM method to compute 3D thermal distribution of electrical machine[J]. Proceeding of the CSEE, 1998,18(2): 7882.
[3] 曹国宣.水内冷汽轮发电机转子温度场计算[J].电工技术学报,1993 (1): 1821.
CAO Guoxuan. The temperature field calculation on watercooled rotors of turbogenerator[J]. Transactions of China Electrotechnical Society, 1993(1): 1821.
[4] 姚若萍,饶芳权.蒸发冷却水轮发电机定子温度场研究[J].中国电机工程学报,2003,23(6): 8790.
YAO Ruoping, RAO Fangquan. Research on stator thermal field of evaporation cooling hydrogenerator[J]. Proceedings of the CSEE, 2003, 23(6): 8790.
[5] 姚若萍,侯小全,饶芳权.大型水轮发电机在各种工况下的端部磁场计算[J].上海交通大学学报,2002,36(2):234236, 242.
YAO Ruoping, HOU Xiaoquan, RAO Fangquan. New approach for field computation in the end zone of hydrogenerators[J]. Journal of Shanhai Jiaotong University, 2002,36(2): 234236, 242.
[6] 李伟力,付敏,周封,等.基于流体相似理论和三维有限元法计算大中型异步电动机的定子三维温度场[J].中国电机工程学报,2000,20(5):1417,2l.
LI Weili, FU Min, ZHOU Feng, et a1. Calculation of 3D temperature field of large and medium scale asynchronous motor on the basis of fluid similarity and 3D FEM[J]. Proceedings of the CSEE, 2000,20(5): 1417,2l.
[7] 李伟力,周封,侯云鹏,等. 大型水轮发电机转子温度场的有限元计算及相关因素的分析[J]. 中国电机工程学报,2002,22(10): 8590.
LI Weili,ZHOU Feng, HOU Yunpeng, et a1. Calculation of rotor temperature field for hydrogenerator as well as the analysis relevant factors[J]. Proceedings of the CSEE, 2002, 22(10):8590.
[8] 丁树业,李伟力,马贤好,等.特殊绕组结构的空冷汽轮发电机定子三维温度场计算与分析[J].中国电机工程学报,2006,26(22):140145.
DING Shuye, LI Weili, MA Xianhao, et al. Calculation and analysis of 3D stator temperature field for air cooled turbogenerator with special wingdings structure[J]. Proceedings of the CSEE, 2006, 26(22):140145.
[9] 李伟力,丁树业,靳慧勇.基于耦合场的大型同步发电机定子温度场的数值计算[J].中国电机工程学报,2005,25(13): 129134.
LI Weili, DING Shuye, JIN Huiyong. Numerical calculation of large synchronous generator stator temperature fields based on coupled fields[J]. Proceedings of the CSEE, 2005, 25(13): 129134.
[10] 丁树业,李伟力,靳慧勇,等.发电机内部冷却气流状态对定子温度场的影响[J].中国电机工程学报,2006,26(3): 131135.
DING Shuye, LI Weili, JIN Huiyong, et a1. Cooling air state inside generator effect on stator temperature fields[J]. Proceedings of the CSEE, 2006, 26(3):131135.
[11] 丁树业,李伟力.电网电压偏差对水轮发电机定子温度场的影响[J].电网技术,2006,30(14):3035.
DING Shuye, LI Weili. Impact of network voltage deviation on stator temperature field of water turbogenerator[J]. Power System Technology, 2006, 30(14): 3035.
[12] 李伟力,靳慧勇,丁树业,等.大型同步发电机定子多元流场与表面散热系数[J].中国电机工程学报,2005,25(23):138143.
LI Weili, JIN Huiyong, DING Shuye, et al. Numerical calculation and analysis of large synchronous generator stator multidimensioal fluid fields and surface heat transfer coefficients[J]. Proceedings of the CSEE, 2005, 25(23):138143.
[13] 杨世铭,陶文铨.传热学[M].北京:高等教育出版社,1998: 66.
[14] 付敏,孔祥春.水轮发电机定子三维温度场的有限元计算[J].电机与控制学报,2000,4(4): 193197.
FU Min, KONG Xiangchun. Calulation of 3D temperture field of hydroelectric generator stator by finite element method[J]. Electric Machines and Control, 2000, 4(4): 193197.

No related articles found!