Please wait a minute...
工程设计学报  2015, Vol. 22 Issue (3): 243-249    DOI: 10.3785/j.issn. 1006-754X.2015.03.007
建模、分析、优化和决策     
采煤机液压调姿牵引机构的力学特性与设计
刘春生,田  操
黑龙江科技大学 机械工程学院,黑龙江 哈尔滨 150022
The mechanical properties and design of shearer hydraulic adjustable posture traction mechanism
LIU Chun-sheng, TIAN Cao
School of Mechanical Engineering, Heilongjiang University of Science & Technology, Harbin 150022, China
 全文: PDF(1380 KB)   HTML
摘要: 为改善采煤机整机受力状态、优化导向滑靴导向支撑方式、降低牵引机构故障率、增强采煤机工作的安全性和可靠性,针对传统采煤机牵引机构特点,提出一种采煤机液压调姿牵引机构.给出了主要结构参数的设计计算方法,建立了液压调姿牵引机构的力学模型,确定了牵引机构传动箱壳体摆角范围为0~10°和实现机身调姿范围为0~30 mm,并分析了牵引负载变化对液压调姿牵引机构主要设计参数的影响.结果表明:当支撑点分别处于最高(θ=0°)和最低位置(θ=10°)时,牵引负载和油液可压缩性引起的相应牵引传动箱壳体摆动角度最大变化量分别为0.178°和0.0754°,支撑点高度最大变化量分别为0.009 5 mm和0.447 mm.研究表明,机身姿态受牵引负载变化和油液可压缩性共同作用的影响较小,液压调姿牵引机构可以满足对外负载变化的刚性需求.研究结果为采煤机液压调姿牵引机构的工程应用设计提供理论基础.
关键词: 采煤机牵引机构液压调姿力学模型设计    
Abstract: In order to improve the shearer stress state, optimize the support method of guiding sliding boots, reduce the failure rate of traction mechanism and enhance the safety and reliability of shearer, a shearer hydraulic adjustable posture traction mechanism against the traditional traction mechanism characteristics was presented. The main structural parameter calculation method was obtained and the mechanical model of hydraulic adjustable posture traction mechanism was established. The adjustment range of shearer fuselage was determined at 0-30 mm and the transmission case shell angular range was determined at 0-10°. And the impacts of the change of tractive on the main design parameters of hydraulic adjustable posture traction mechanism were analyzed. The result showed that due to the change of tractive and the compressibility of hydraulic oil, the maximum value of the angular range of transmission case shell was 0.178° and 0.0754° when support points in the highest (θ=0°) and the lowest position (θ=10°) respectively, and the measure of the change point height was 0.009 5 mm and 0.447 mm. The research indicated that the impacts of the change of tractive and the compressibility of hydraulic oil on shearer posture were small. The study provides the basis for the subsequent research of the shearer hydraulic adjustable posture traction mechanism.
Key words: shearer    traction mechanism    hydraulic adjustable posture    mechanical model    design
收稿日期: 2014-12-29 出版日期: 2015-06-28
基金资助:

国家自然科学基金资助项目(51274091);黑龙江省教育厅科学技术研究基金资助项目(12531006).

作者简介: 刘春生(1961—),男,山东牟平人,教授,从事机械设计和液压传动与控制方面的研究,E-mail: liu_chunsheng@163.com.
服务  
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章  

引用本文:

刘春生,田 操. 采煤机液压调姿牵引机构的力学特性与设计[J]. 工程设计学报, 2015, 22(3): 243-249.

LIU Chun-sheng, TIAN Cao. The mechanical properties and design of shearer hydraulic adjustable posture traction mechanism. Chinese Journal of Engineering Design, 2015, 22(3): 243-249.

链接本文:

https://www.zjujournals.com/gcsjxb/CN/10.3785/j.issn. 1006-754X.2015.03.007        https://www.zjujournals.com/gcsjxb/CN/Y2015/V22/I3/243

[1] 张嘉宁,张明路,李满宏,张坦. 面向灰库清理的超大伸缩比机械臂结构设计与刚度优化[J]. 工程设计学报, 2022, 29(4): 430-437.
[2] 孙光明,王奕苗,万仟,弓堃,汪文津,赵坚. 考虑装配变形的精密机床床身优化设计[J]. 工程设计学报, 2022, 29(3): 318-326.
[3] 廖红玉,邓梦洋,周敏,谢良喜,姚俊夫. 基于钢丝绳传动的自动抹灰机的轻量化设计[J]. 工程设计学报, 2022, 29(2): 196-201.
[4] 辛传龙,郑荣,任福琳,梁洪光. AUV接驳装置悬浮平衡分析与配重优化设计[J]. 工程设计学报, 2022, 29(2): 176-186.
[5] 徐云杰,沈俞,胡飞,贾良权,祁亨年. 基于TDLAS的批量种子活力检测装置设计[J]. 工程设计学报, 2022, 29(2): 231-236.
[6] 吴嘉懿, 岳阳, 李军业, 金志江, 钱锦远. 主给水调节阀节流窗口周向设计及其对流动特性的影响[J]. 工程设计学报, 2022, 29(1): 74-81.
[7] 王碧海, 张健, 陈永亮, 彭庆金, 顾佩华. 盾构螺旋输送机适应性设计智能决策[J]. 工程设计学报, 2022, 29(1): 1-9.
[8] 倪维宇, 张横, 姚胜卫. 基于多工况的汽车座椅骨架轻量化设计[J]. 工程设计学报, 2021, 28(6): 729-736.
[9] 倪子健, 李文强, 唐忠. 基于网络表示学习的本体语义挖掘与功能语义检索方法[J]. 工程设计学报, 2021, 28(5): 539-547.
[10] 叶锦涛, 刘凤丽, 郝永平, 刘双杰, 郭梦辉, 冯卓航. 一种超低空飞行的仿生扑翼飞行器的设计及分析[J]. 工程设计学报, 2021, 28(4): 473-479.
[11] 曹恩国, 王刚, 王琨, 高阳. 基于弹性装置驱动的外骨骼助行效能评价[J]. 工程设计学报, 2021, 28(4): 480-488.
[12] 刘晓瑜, 田颖, 张明路. 水下机械手动力学研究综述[J]. 工程设计学报, 2021, 28(4): 389-398.
[13] 陈振, 李涛, 薛晓伟, 周阳, 敬爽, 陈言. 基于模糊综合评价法的可控震源振动器平板疲劳可靠性分析与优化[J]. 工程设计学报, 2021, 28(4): 415-425.
[14] 张璞, 王峻峰, 高一聪, 张雪健. 集成ADTRIZ的箱式电梯防疫功能创新设计[J]. 工程设计学报, 2021, 28(3): 305-311.
[15] 白杨溪, 陈洪月, 陈洪岩, 王鑫, 李建刚. 基于滚筒载荷的采煤机滑靴振动分析及实验验证[J]. 工程设计学报, 2021, 28(3): 358-366.