Please wait a minute...
浙江大学学报(工学版)
J4  2012, Vol. 46 Issue (5): 929-934    DOI: 10.3785/j.issn.1008-973X.2012.05.025
    
Computation of transient fluid induced force of small clearance
flow in centrifugal pump
JIANG Qing-lei1，XING Gui-kun2，WU Da-zhuan1，WANG Le-qin1
1. Institute of Chemical Machinery Engineering,Zhejiang University,Hangzhou 310027, China；
2. China Huanqiu Contracting & Engineering Corporation,Beijing 100029, China
Download:   PDF(0KB) HTML
Export: BibTeX | EndNote (RIS)      

Abstract  

The small clearance flow was modeled based on turbulent lubrication theory.  Pressure distribution of small clearance flow which in laminar, transition and turbulent regime state were calculated and then compared with experiment results. Based on comparison results, small clearance flow model was optimized. A typical turbulent lubrication theory and a transition flow model were used to simulate superlaminar flow in small clearance channel. After optimization process the numerical results had a better agreement with experiment results. Pressure distribution of small clearance flow in transient process was obtained when whirling motion and amplitude changing of shaft were considered, and the results showed that peak values of pressure distribution increased markedly when transient effects were considered. Peak values of positive pressure region and negative pressure region in small clearance flow both increased linearly with increased angular velocity of whirling motion. When amplitude increase of whirling motion was considered, pressure curves of small clearance flow entirely up offset, which enhance stability of rotor systems. 

Published: 01 May 2012
CLC:  TH 311  
Service
E-mail this article
Add to my bookshelf
Add to citation manager
E-mail Alert
RSS
Articles by authors
Cite this article:

JIANG Qing-lei，XING Gui-kun，WU Da-zhuan，WANG Le-qin. Computation of transient fluid induced force of small clearance
flow in centrifugal pump. J4, 2012, 46(5): 929-934.

URL:

http://www.zjujournals.com/eng/10.3785/j.issn.1008-973X.2012.05.025     OR     http://www.zjujournals.com/eng/Y2012/V46/I5/929


离心泵内小间隙环流瞬态流体力计算

基于湍流润滑理论建立小间隙环流数学模型,计算层流假设时层流、过渡流及湍流3种流态下环流内压力分布情况,并与实验结果进行对比.结果显示采用层流模型进行计算时,层流工况下求得结果与实验吻合很好,但当雷诺数增加导致小间隙环流发展至过渡态及湍流状态时,数值计算结果与实验结果相比有较大偏差.利用几种典型湍流模型及过渡流模型对数值结果进行修正,修正后的数值结果与实验结果吻合较好；引用过渡区域摩擦因子对模型进行修正后的计算结果可修正采用层流模型和湍流模型时产生的误差,更接近于实验结果.针对离心泵启动的瞬态过程,求解考虑转子涡动角速度及涡动幅值变化时小间隙环流内压力分布,结果显示,涡动角速度及涡动幅值的变化对环流内正压区及负压区分布均有明显影响.

［1］ DIEWALD W, NORDMANN R. Dynamic analysis of centrifugal pump rotors with fluid mechanical interaction［J］.Journal of Vibration and Acoustics, 1998, 111(6): 269-267.
［2］ LOMAKIN A A. Calculation of critical speed and securing of dynamic stability of hydraulic highpressure pumps with reference to the forces arising in the gap seals ［J］. Energomashinostroenie, 1958, 4(1): 1158-1162．
［3］ HIRS G. Fundamentals of a bulkflow theory for turbulent lubricant films ［D］. Delft: University of technology delft, 1970: 82-90．
［4］ HIRS G. A bulkflow theory for turbulence in lubricant films ［J］. ASME Journal of lubrication technology, 1973,95(1): 137-146．
［5］ CHILDS D W. Dynamic analysis of turbulent annular seals based on hirs lubrication equation ［J］. ASME Journal of lubrication technology, 1983,105(3): 429-436．
［6］ CHILDS D W , CHANG H K. Analysis and testing for rotordynamic coefficients of turbulent annular seals with different, directionallyhomogeneous surfaceroughness treatment for rotor and stator elements ［J］. ASME Journal of Tribology, 1985, 107(3): 296-306．
［7］ BASKHARONE E A. Rotordynamic effects of the shroudtohousing leakage flow in centrifugal pumps［J］. ASME journal of fluids engineering, 1994, 116(7): 558-563．
［8］ AKIRA H, YOSHINOBU T. Theoretical analysis of fluid forces on an opentype centrifugal impeller in whirling motion［J］. ASME journal of fluids engineering, 2002, 124(2): 242-247．
［9］ 张新敏,夏延秋,赵清, 等. 离心泵稳态密封间隙力的计算分析［J］. 润滑与密封, 2004, 164(3):63-65．
ZHANG Xinmin, XIA Yanqiu, ZHAO Qin,et al. Analysis of static hydraulic forces in annular seal ［J］. Lubrication Engineering, 2004, 164(3): 63-65．
［10］ 张直明. 论紊流润滑理论中的Hirs法的理论基础［J］. 西安交通大学学报, 1978, 53(4): 25-28．
ZHANG Zhiming. On the theoretical basis of the hirs meteod in the theory of lubrication ［J］. Journal of Xi’an Jiaotong University, 1978, 53(4): 25-28．
［11］ 孙晓林 于慎波 曹玉林. 离心泵密封口环动力学特性系数计算［J］. 润滑与密封, 1998,23(6): 44-46．
SUN Xiaolin, YU Shenbo, CAO Yulin. Calculation on dynamic coefficients of annular seals in centrifugal pumps ［J］. Lubrication Engineering, 1998, 23(6): 44-46．
［12］ 孙启国, 虞烈, 谢友柏. 间隙环流中同心涡动转子动特性的研究［J］. 机械强度. 2003,25(1): 21-24．
SUN Qiguo, YU Lie, XIE Youbo. Study on dynamic characteristics of whirling rotor immersed in concentric annular flow［J］. Journal of Mechanical Strength, 2003, 25(1): 21-24．
［13］ TAYLOR G I. Stability of viscous flow contained between two rotating cylinders ［J］. Philosophical Transactions of Royal Society, 1923,223(4): 289-343．
［14］ TAYLOR C M, DOWSON D. Turbulent lubrication theoryapplication to design ［J］. ASME Journal of Lubrication Technology, 1974,96(4): 36-47．
［15］ CONSTAMTINESCU V N. On turbulent lubrication［J］. Proceedings of the Institution of Mechanical Engineers, 1959,173(38):881-889．
［16］ NG C W, PAN C H T. A linearised turbulence to calculation of lubrication flows ［J］. ASME Journal of Basic Engineering, 1965, 87(4): 675-688．
［17］ BLACK H F, WALTON M H. Theoretical and experimental investigation of a short 360°journalbearing in the transition superlaminar regime ［J］. Journal of Mechanical Engineering Science, 1974, 16(5): 286-297．
［18］ MASON P J. An investigation of journalbearing behaviour in the superlaminar flow regime ［D］. Bridlington: University of Sussex, 1983：101-103．
［19］ ROBERTS J B, MASON P J. An experimental investigation of pressure distributions in a journal bearing operating in the transition regime ［J］. Proceedings of Institution Mechanical Engineers, 1986, 200(4): 251-264．
［20］ ROBERTS J B, HINTON R E. Pressure distributions in a superlaminar journal bearing ［J］. ASME Journal of lubrication technology, 1982, 104(1): 187-195．
［21］ 陈伯贤, 裘祖干, 张慧生,等. 流体润滑理论及其应用［M］.北京: 机械工业出版社, 1991：37-47．
[1] SUN You-bo, CHEN Tao, YANG Shuai, WU Da-zhuan, WANG Le-qin. Improvement design of hydraulic components and structure of
vertical self-priming pump[J]. J4, 2013, 47(2): 332-338.
[2] WU Da-zhuan, XU Bin-jie, WU Peng, LI Zhi-feng, WANG Le-qing. Internal clearance flow and leakage loss in multi-stage
centrifugal pump[J]. J4, 2011, 45(8): 1393-1398.