|
|
Catalytic synthesis of N,N,N′,N′-tetramethylethylenediamine
in fixed-bed reactor |
ZHANG Tao1, CHEN Han-geng1, ZHANG Xu1, WEI Long-wu2,
QIAN Chao1, CHEN Xin-zhi1 |
1. State Key Laboratory of Chemical Engineering, Department of Chemical and Biological Engineering, Zhejiang
University, Hangzhou 310027, China; 2. Ninbo Yongshun Fine Chemical Co.Ltd., Ningbo 315204, China |
|
|
Abstract N,N,N′,N′-tetramethylethylenediamine was obtained by dehydration of dimethyl amine and glycol in a fixed-bed reactor under the selfmade supported metal catalysts. First, three types of catalysts (Cu-Ni, Cu-Cr, Cu-Zn) were prepared through impregnation method with γ-Al2O3 as the carrier and Cu, Ni, Cr, Zn as the active components. The performance of these catalysts, which was evaluated by the conversion of glycol and the selectivity of tetramethylethylenediamine, was investigated under the same condition. The results indicated the best performance of Cu-Ni type. A series of parallel experiments were carried out to find out the appropriate range of temperature, the molar ratio of ethyl diamine/glycol and volume velocities. The experimental conditions were eventually optimized by response surface methodology (Design Expert) and the optimal values were: 204.81 ℃, molar ratio of ethyl diamine/glycol of 5.27, velocity of 0.29 h-1, with the highest yield of 79.84%.
|
Published: 01 December 2010
|
|
|
Cite this article:
ZHANG Tao, CHEN Han-geng, ZHANG Xu, WEI Long-wu,QIAN Chao, CHEN Xin-zhi. Catalytic synthesis of N,N,N′,N′-tetramethylethylenediamine
in fixed-bed reactor. J4, 2010, 44(12): 2401-2405.
URL:
http://www.zjujournals.com/eng/10.3785/j.issn.1008-973X.2010.12.028 OR http://www.zjujournals.com/eng/Y2010/V44/I12/2401
|
固定床催化合成N,N,N′,N′-四甲基乙二胺的研究
通过自制备的金属负载型催化剂,以二甲胺和乙二醇为原料,在气固固定床反应器中合成了N,N,N′,N′-四甲基乙二胺.以γ-Al2O3为载体,Cu、Ni、Cr、Zn等金属为活性组分,通过浸渍法制备了3种二元金属负载型催化剂:Cu-Ni型、Cu-Zn型、Cu-Cr型.在相同条件下对3种催化剂的催化性能进行了考察,对乙二醇转化率及四甲基乙二胺的选择性进行了分析,结果表明:Cu-Ni型催化剂的催化效果最佳.通过平行实验对反应温度、胺醇的物质的量比及体积空速进行了研究,获得了较优的条件区间范围.根据平行实验结果,采用响应面实验设计方法(Design Expert软件)对反应条件进行了优化,获得了最优的反应条件:以Cu-Ni为活性组分的催化剂进行催化,反应温度为204.81 ℃,胺醇的物质的量比为5.27,体积空速为0.29 h-1,最佳产率可以达到79.84%.
|
|
[1] 赵丽平, 游静, 李一峻, 等. N, N, N′, N′四甲基乙二胺为中性载体的PVC膜氢离子传感器的研制[J]. 分析实验室, 2006, 25(7): 115-118.
ZHAO Liping, YOU Jing, LI Yijun, et al. A potentiometric sensor for hydrogen ion based on N,N,N′,N′tetramethyl ethylenediamine neutral carrier in a poly (vinyl chloride) membrane [J]. Chinese Journal of Analysis Laboratory, 2006, 25(7): 115-118.
[2] ROSENAU T, POTTHAST A, RHRLING J, et al. A solventfree and formalinfree eschweilerclarke methylation for amines [J]. Synthetic Communications, 2002, 32(3): 457-465.
[3] ZOTTO A D, BARATTA W, SANDRI M, et al. Cyclopentadienyl RuII Complexes as highly efficient catalysts for the Nmethylation of alkylamines by methanol [J]. European Journal of Inorganic Chemistry, 2004(3): 524-529.
[4] MARSELLA J A. Homogeneously catalyzed synthesis of αamino alcohols and vicinal diamines from ethylene glycol and 1, 2Propanediol [J]. Journal of Organic Chemistry, 1987, 52: 467-468
[5] 毛筱媛, 陈新志. 固定床催化管式合成N, N二甲基丁胺的研究[J]. 浙江大学学报:工学版, 2003, 37(3): 307-309.
MAO Xiaoyuan, CHEN Xinzhi. Synthesis of N,NDimethylbutamine by fixed catalytic bed reactor [J]. Journal of Zhejiang University: Engineering Science, 2003, 37(3): 307-309.
[6] 吕养心, 钱超, 刘建青, 等. CuO/NiO/γAl2O3催化剂合成环己胺[J]. 化学反应工程与工艺, 2004, 20(2): 134-138.
LU Yangxin, QIAN Chan, LIU Jianqing, et al. Synthesis of Cyclohexylamine with CuO/NiO/γAl2O3 Catalyst [J]. Chemical Reaction Engineering and Technology, 2004, 20(2): 134-138.
[7] BECKER J, NIEDERER J P M, KELLER M, et al. Amination of cyclohexanone and cyclohexanol/ cyclohexanone in the presence of ammonia and hydrogen using copper or a group VIII metal supported on a carrier as the catalyst [J]. Applied Catalysis A: General, 2000, 197: 229-238.
[8] BAIKER A, CAPREZ W, HOLSTEIN W L. Catalytic amination of aliphatic alcohols in the gas and liquid phases: kinetics and reaction pathway [J]. Industrial & Engineering Chemistry Product Research and Development, 1983, 22(2): 217-225.
[9] BAIKER A, KIJENSKI J. Catalytic synthesis of higher aliphatic amines from the corresponding alcohols [J]. Catalysis Reviews Science Engineering, 1985, 27(4): 653-697.
[10] 范克雷维伦. 聚合物的性质: 性质的估算及其化学结构的关系[M]. 2版. 北京: 科学出版社, 1981: 336-340.
[11] MONTGOMERY D C. 实验设计与分析[M]. 北京: 中国统计出版社, 1998: 589-640.
[12] 朱作华, 张海燕, 吴天祥, 等. 响应面法优化芭蕉芋酒精发酵工艺条件[J]. 酿酒科技, 2007(8): 29-32.
ZHU Zuohua, ZHANG Haiyan, WU Tianxiang, et al. Response surface methodology to optimize ethanol fermentation from canna edulis Ker [J]. Liquormaking Science and Technology, 2007(8): 29-32.
[13] 胡成旭, 侯欣彤, 冯永宁, 等. 响应面法优化云芝多糖提取条件的研究[J]. 食品工业科技, 2007(7): 125-130.
HU Chenxu, HOU Xintong, FENG Yongning, et al. RSM to optimize polysaccharides extraction from coriolus versicolor [J]. Science and Technology of Food Industry, 2007(7): 125-130. |
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
|
Shared |
|
|
|
|
|
Discussed |
|
|
|
|