Please wait a minute...
浙江大学学报(工学版)
J4  2011, Vol. 45 Issue (11): 1922-1926    DOI: 10.3785/j.issn.1008-973X.2011.11.006
机械工程     
长行程水平向振动台的滑台防牵拉技术
何闻1,郑建毅1,3,于梅2,沈润杰1,4,贾叔仕1
1.浙江大学 流体动力与机电系统国家重点实验室,浙江省先进制造技术重点实验室, 浙江 杭州 310027；
2.中国计量科学研究院,北京 100013； 3. 厦门大学 机电工程系, 福建 厦门 361005；
4. 同济大学 电子与信息工程学院, 上海 201804
Anti-tension technology of slipway in long-stroke horizontal
vibration table
HE Wen1, ZHENG Jian-yi1,3, YU Mei2, SHEN Run-jie1,4, JIA Shu-shi1
1. The State Key Laboratory of Fluid Power Transmission and Control，Zhejiang Province Key Laboratory of Advanced
Manufacturing Technology, Zhejiang University, Hangzhou 310027, China; 2. National Institute of Metrology, Beijing
100013, China; 3. Department of Mechanical and Electrical Engineering, Xiamen University, Xiamen 361005, China;
4. School of Electronics and Information, Tongji University, Shanghai 201804, China
 全文: PDF  HTML
摘要：

为了解决长行程水平向振动台中管线对滑台牵拉引起的输出波形失真问题，提出一种带动管线跟踪滑台同步运动的随动装置设计方法.建立管线牵拉力作用下的水平向振动台机电耦合动力学模型，计算管线牵拉力对振动台输出波形失真度的影响；设计一种基于光栅尺的滑台随动装置，带动随动平台与滑台做同步运动，滑台上的管线经随动平台后引出，此时管线的牵拉力直接作用在随动平台上，而滑台上受到的牵拉力趋于零.试验结果表明，通过增设滑台随动装置，水平向振动台在做超低频大行程振动时的输出波形失真度得到极大的改善.
Abstract:

In order to solve the problem of output waveform distortion due to the pipes and wires' tension in a long-stroke horizontal vibration table, a follow-up-gear design technology was put forward which drove the pipes and wires to move synchronously with the slipway. The electromechanical coupling kinetic model of a horizontal vibration table was analyzed considering the tension of pipes and wires in it, and the influences of tension forces of the pipes and wires on the output waveform distortion of the horizontal vibration table was calculated. A follow-up gear for the slipway was developed based on a precise linear encoder, and drove a following table moving synchronously with the slipway. And the pipes and wires on the slipway were led out through the following table, on which the tension forces directly acted, but the tension force on the slipway drove to zero. The experimental results indicate that the output waveform distortion improves greatly after adding the follow-up gear when the horizontal vibration table works in long-stroke and ultra-low-frequency motion.
出版日期: 2011-12-08
:  TB 936  
基金资助:

新世纪优秀人才支持计划资助项目（NCET-08-0494）；浙江省“钱江人才计划”资助项目（2009R10026）;浙江省重点科技创新团队建设资助项目(2009R50008).
作者简介: 何闻（1969-），男，教授，博导，从事振动计量等方面的研究．E-mail:hewens@263.net
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
作者相关文章　　

引用本文:

何闻,郑建毅,于梅,沈润杰,贾叔仕. 长行程水平向振动台的滑台防牵拉技术[J]. J4, 2011, 45(11): 1922-1926.

HE Wen, ZHENG Jian-yi, YU Mei, SHEN Run-jie, JIA Shu-shi. Anti-tension technology of slipway in long-stroke horizontal
vibration table. J4, 2011, 45(11): 1922-1926.

链接本文:

https://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2011.11.006    或    https://www.zjujournals.com/eng/CN/Y2011/V45/I11/1922

［1］ JJG 1342003.磁电式速度传感器检定规程［S］.北京：中国计量出版社,2004．
JJG 1342003.Verification regulation of electromagnetic velocity transducer ［S］.Beijing：China Metrology Publishing House,2004．
［2］ JJG 2332008.压电加速度计检定规程［S］.北京：中国计量出版社,2009．
JJG 2332008. Verification regulation for piezoelectric accelerometer ［S］.Beijing：China Metrology Publishing House,2008．
［3］ ISO 16063111999.Methods for the calibration of vibration and shock transducers  Part 11:Primary vibration calibration by laser interferometry ［S］.Switzerland:International Organization for Standardization,1999．
［4］ JJG 2982005.中频标准振动台（比较法）检定规程［S］.北京：中国计量出版社,2005．

JJG 2982005.Verification regulation of standard vibrator in middle frequency band (comparison method) ［S］.Beijing：China Metrology Publishing House,2005．
［5］ OHM W S,WU Lixue,HANES P,et al.Generation of lowfrequency vibration using a cantilever beam for calibration of accelerometers ［J］.Journal of Sound and Vibration,2006,289（1/2）：192-209．
［6］ GEORGE F L.Electrodynamic shaker fundamentals ［J］.Sound and Vibration,1997,31（4）：14-23．
［7］ 韩冬.地震计校准用超低频标准振动系统关键技术的研究［D］.杭州：浙江大学,2007．
HAN Dong.Study on key techniques of ultralow frequency standard vibration system for seismometer calibration ［D］.Hangzhou:Zhejiang University,2007．
［8］ （美）绪方胜彦.系统动力学［M］.北京：机械工业出版社,1983:21,117．
［9］ HE W,ZHU C P,MA F.Realization of lowdistortion ultralow frequency Vibration based on feedback control technology ［C］∥ 2005 IEEE Networking,Sensing and Control Proceeding.California:IEEE,2005:795-798．
［10］ 沈润杰,何闻.大型宽频带水下振动台流固耦合动力学特性的研究［J］.浙江大学学报：工学版,2006,40（4）：724-728．
Shen Runjie,HE Wen.Study on fluidsolid coupling dynamic characteristics of large widefrequencyrange underwater vibration tables ［J］.Journal of Zhejiang University∶Engineering Science,2006,40（4）：724-728．
［11］ 张逸波,齐晓军,张丽新.200 kN振动台动圈建模与仿真分析 ［J］.航天器环境工程,2009,26（3）：244-247．
Zhang Yibo,Qi Xiaojun,Zhang Lixin.Modeling of armature of 200 kN shaker and its simulation ［J］.Spacecraft Environment Engineering,2009,26（3）：244-247．
No related articles found!