Please wait a minute...
浙江大学学报(工学版)
J4  2014, Vol. 48 Issue (3): 377-383    DOI: 10.3785/j.issn.1008-973X.2014.03.001
计算机技术，无线电电子学     
一种高压高可靠性开关电源控制芯片
宁志华,何乐年,胡志成
浙江大学 超大规模集成电路研究所,浙江 杭州 310027
A high voltage high stability switching-mode controller chip
NING Zhi-hua, HE Le-nian, HU Zhi-cheng
Institute of VLSI Design, Zhejiang University, Hangzhou 310027, China
 全文: PDF(1900 KB)   HTML
摘要：

为了增强电源系统的可靠性,提出一种高压高可靠性开关电源控制芯片,该芯片引入一种新型的故障保护电路,通过同时监测误差放大器（EA）输出和峰值电流信号来检测过流和短路等故障.当EA输出电压超过4.2 V或者峰值电压信号（由采样电阻得到）连续4个周期超过0.75 V时,保护电路会及时切断控制器,保护变换器免受损害,同时降低了电路损耗.芯片还集成了软启动、限流保护、过压欠压保护和脉宽调制/跳脉冲调制（PWM/PSM）模式切换电路，该芯片采用CSMC 0.5 μm 60 V BCD 工艺进行设计,已经成功流片.将该芯片应用于反激式转换器中,转换器可以将34～60 V的输入电压转化成5 V输出.测试表明：当故障发生时,控制芯片能够迅速切断控制器以保护整个转换器,而当故障消除后该控制器仍然可以自行重新启动；反激转换器最大输出电流为2.6 A,静态电流小于1 mA,最大效率为83.5%,线性调整率和负载调整率分别为0.02%/V和0.03%/A,具有良好的瞬态响应能力.
Abstract:

A  switching-mode controller chip was proposed to enhance the reliability of power system. This chip introduces a novel fault protection circuit, which monitoring both error amplifiers (EAs) output and peak current to detect the fault such as over-current and short-circuit. If EAs output is larger than 4.2 V or the peak voltage (generated by sampling resistor) surpasses 0.75 V in 4 cycles, the protection circuit will shut down the controller to protect the converter from damage, which also saves the power. The chip integrates circuits of soft-start, current-limit, under-voltage and over-voltage protection and pulse width modulation/pulse skipping modulation (PWM/PSM) mode switching. This chip was implemented in CSMC 0.5 μm 60 V BCD process and was applied in a flyback converter which deliverd an output of 5 V with input voltage ranging from 34-60 V. Measurement results show that this controller chip can shut down the controller as soon as the fault occurs, protecting the converter from damage. The controller can self-restart when the fault is removed. The converter has a maximum load ability of 2.6 A while its quiescent current is no more than 1 mA. The maximum power efficiency is 83.5%. The line regulation and load regulation is only 0.02%/V and 0.03%/A respectively. The converter also presents an outstanding transient performance．
出版日期: 2018-06-10
:     
通讯作者: 何乐年,男,教授.     E-mail: helenian@vlsi.zju.edu.cn
作者简介: 宁志华(1987-),男,博士生,从事模拟集成电路和电源管理芯片研究.E-mail:nzhzju@gmail.com
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　

引用本文:

宁志华,何乐年,胡志成. 一种高压高可靠性开关电源控制芯片[J]. J4, 2014, 48(3): 377-383.

NING Zhi-hua, HE Le-nian, HU Zhi-cheng. A high voltage high stability switching-mode controller chip. J4, 2014, 48(3): 377-383.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2014.03.001    或    http://www.zjujournals.com/eng/CN/Y2014/V48/I3/377

［1］ 刘布民,蔡伟,陆铁军,等. 低功耗无损电流检测技术的分析与设计 ［J］. 电子科技大学学报,2008,37(3)：393-396．
LIU Bu-min, CAI Wei, LU Tie-jun, et al. Low-power lossless current sensing in DC/DC converter［J］. Journal of University of Electronic Science and Technology of China, 2008, 37(3)：393-396．
［2］ AHN Y, NAM H, ROH J. A 50 MHz fully integrated low-swing buck converter using packaging inductors ［J］. IEEE Transactions on Power Electronics, 2012, 27(10): 4347-4356．
［3］ YAN Wei, LI Wen-hong, LIU Ran. A noise-shaped buck DC-DC converter with improved light-load efficiency and fast transient response ［J］. IEEE Transactions on Power Electronics, 2011, 26(12): 3908-3924．
［4］ IEEE 802 LAN/MAN Standards Committee. IEEE Std 802.3af-2003, Telecommunications and information exchange between systems - local and metropolitan area networks ［S］. New York:IEEE, Computer Society, 2003．
［5］ MA Feng-fei, CHEN Wei-zen, WU Jin-chuan. A monolithic current-mode buck converter with advanced control and protection circuits ［J］. IEEE Transactions on Power Electronics, 2007, 22(5): 1836-1846．
［6］ LI Yan-ming, MAO Xiang-yu, WANG Hong-yi, et al. An improved hiccup mode short-circuit protection technique with effective overshoot suppression for DC-DC converters ［J］. IEEE Transactions on Power Electronics, 2013, 28(2): 877-885．
［7］ MARTINS M M. Soft-start system for voltage regulator and the method of implementing soft-start: US, 0,027,106 ［P］. ［2004-02-12］．
［8］ GRAY P R, HURST P J, LEWIS S H, et al. Analysis and design of analog integrated circuits ［M］. 4th ed. Beijing: Higher Education Press, 2005．
［9］ RODRIGUEZ M, LAMAR D G, AZPEITIA M A P, et al. A novel adaptive synchronous rectification system for low output voltage isolated converters ［J］. IEEE Transactions on Industrial Electronics, 2011, 58(8): 3511-3520．
［10］ TORU S, YASUHIRO S. A method for realizing a fast response time for the output current change of a MOS current-mode buck DC-DC converter which utilizes a quadratic and Vin-dependent compensation slope ［C］∥ IEEE Asian Solid-State Circuits Conference. Tokyo: ［s. n.］, 2009: 337-340．
[1] 李林,陈家旺,顾临怡,王峰. 轴向柱塞泵/马达变量阀配流机构[J]. J4, 2014, 48(1): 29-34.
[2] 陈钊,余锋,陈婷婷. 基于日志结构的闪存均衡回收策略[J]. J4, 2014, 48(1): 92-99.
[3] 蒋湛,姚晓明,林兰芬. 基于特征自适应的本体映射方法[J]. J4, 2014, 48(1): 76-84.
[4] 陈迪仕 ,张宇,李平. 微小型无人直升机地面效应建模[J]. J4, 2014, 48(1): 154-160.
[5] 霍新新,褚金奎,韩冰峰,姚斐.  基于多个压电换能器的接口电路[J]. J4, 2013, 47(11): 2038-2045.
[6] 杨鑫,许端清,杨冰. 基于不规则性的并行计算方法[J]. J4, 2013, 47(11): 2057-2064.
[7] 王玉强,张宽地,陈晓东. 胶黏钢-混凝土组合梁的界面行为数值分析[J]. J4, 2013, 47(9): 1593-1598.
[8] 崔何亮, 张丹, 施斌.  布里渊分布式传感的空间分辨率及标定方法[J]. J4, 2013, 47(7): 1232-1237.
[9] 彭勇,徐小剑. 集料分布对沥青混合料劈裂强度影响数值分析[J]. J4, 2013, 47(7): 1186-1191.
[10] 伍晓榕,裘乐淼,张树有,孙良峰,郭传龙. 模糊语境下的复杂系统关联FMEA方法[J]. J4, 2013, 47(5): 782-789.
[11] 金波,陈诚,李伟. 具有半球形足端的六足机器人步态修正算法[J]. J4, 2013, 47(5): 768-774.
[12] 钟世英, 吴晓君, 蔡武军, 凌道盛, 蒋祝金, 王顺玉. 月面软着陆足垫水平拖曳模型试验装置研制[J]. J4, 2013, 47(3): 465-471.
[13] 袁幸,朱永生,张优云,洪军,祁文昌. 基于正反问题的滚动轴承损伤程度评估[J]. J4, 2012, 46(11): 1960-1967.
[14] 杨飞,朱株,龚小谨,刘济林. 基于三维激光雷达的动态障碍实时检测与跟踪[J]. J4, 2012, 46(9): 1565-1571.
[15] 王鹿军, 吕征宇. 基于LSSVM的电梯交通模式的模糊识别[J]. J4, 2012, 46(7): 1333-1338.