Please wait a minute...
J4  2014, Vol. 48 Issue (2): 342-347    DOI: 10.3785/j.issn.1008-973X.2014.02.023
能源工程     
塑料缸盖罩透射及结构辐射噪声
郑康, 郝志勇, 王连生, 刘功文, 朱君亮, 陶大源
浙江大学 汽车与发动机振动噪声实验室,浙江 杭州 310027
Research on transmission and structural radiation noise of  plastic engine cover
ZHENG Kang, HAO Zhi-yong, WANG Lian-sheng, LIU Gong-wen, ZHU Jun-liang, TAO Da-yuan
Department of Energy Engineering, Zhejiang University, Hangzhou 310027, China
 全文: PDF(1504 KB)   HTML
摘要:

为了研究缸盖罩透射噪声及结构辐射噪声之间的关系,对某典型四缸汽油机的塑料缸盖罩在最大功率工况下(6 000 r/m)靠近螺栓处的表面振动速度进行测量,利用多体动力学计算整机振动得到该处振动速度结果并与试验进行对比,证明计算结果与试验基本吻合,通过该仿真结果计算出缸盖罩声压级.利用覆盖法对能对顶面声压带来影响的部件进行屏蔽,只保留缸盖罩不屏蔽,对缸盖罩在相同工况下进行声压级的测量.将计算所得声压级(结构辐射噪声)与测试所得声压级(总辐射噪声)结果进行对比分析.结果表明,透射噪声主要分布于频率1 500~3 000 Hz,结构辐射噪声主要分布于500~1 500 Hz利用有限元法及边界元法计算缸盖罩隔声量对该结论进行验证,得到缸盖罩隔声量在1 500~3 000 Hz处迅速下降,与分析结果吻合.

Abstract:

To obtain the relationship between transmission and structural radiation noise, the vibration velocity near bolts of a plastic engine cover of typical 4-cylinder gasoline engine was measured in the max power work case (6 000 r/min). Multi-body dynamics method was used to calculate the surface velocity of the engine cover and the calculation result matched the test result and was used to calculate the sound pressure level. Every part of the engine top except the engine cover was covered and the sound pressure level of the top was tested in the same work case. The sound pressure level results from calculation (structural radiation noise) and test (total radiation noise) were compared and analyzed. The conclusion is that structural radiation contributes more in 500~1 500 Hz while transmission noise contributes more in 1 500~3 000 Hz. The transmission loss of the plastic engine cover was also calculated FEM& BEM and the result shows the loss decreases rapidly in 1 500~3 000 Hz and the situation matched the conclusion that transmission noise contributes more in 1 500~3 000 Hz.

出版日期: 2014-02-01
:  U 263  
通讯作者: 郝志勇,男,博导.     E-mail: Haozy@zju.edu.cn
作者简介: 郑康(1986—),男,博士,从事内燃机NVH及强度等研究工作. E-mail:10927035@zju.edu.cn
服务  
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章  

引用本文:

郑康, 郝志勇, 王连生, 刘功文, 朱君亮, 陶大源. 塑料缸盖罩透射及结构辐射噪声[J]. J4, 2014, 48(2): 342-347.

ZHENG Kang, HAO Zhi-yong, WANG Lian-sheng, LIU Gong-wen, ZHU Jun-liang, TAO Da-y. Research on transmission and structural radiation noise of  plastic engine cover. J4, 2014, 48(2): 342-347.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2014.02.023        http://www.zjujournals.com/eng/CN/Y2014/V48/I2/342

[1] 庞剑,谌刚,何华. 汽车噪声与振动-理论与应用[M]. 2006.6: 150-152.
[2] 张磊,任海军,艾晓玉,等. 发动机薄壁件结构振动优化[J]. 振动工程学报,2010,23(6): 687-695.
ZHANG Lei, REN Hai-jun, AI Xiao-yu, et al. Vibration optimization on engine covers [J]. Journal of Vibration Engineering, 2010, 23(6): 687-695.
[3] 贾维新,郝志勇,杨金才. 虚拟预测方法在柴油机低噪声设计中的应用[J]. 浙江大学学报:工学版,2007,41(3): 490-493.
JIA Wei-xin, HAO Zhi-yong, YANG Jin-cai. Application of virtual prediction method to low-noise diesel engine design [J]. Journal of Zhejiang University :Engineering Science, 2007, 41(3): 490-493.
[4] 贾维新,郝志勇,杨金才. 基于形貌优化的低噪声油底壳设计研究[J]. 浙江大学学报:工学版,2007, 41(5): 770-773.
JIA Wei-xin, HAO Zhi-yong, YANG Jin-cai. Low noise design of oil pan based on topography optimization [J]. Journal of Zhejiang University :Engineering Science, 2007, 41(5): 770-773.
[5] 刘月辉,郝志勇,付鲁华,等. 车用发动机表面辐射噪声的研究[J]. 汽车工程,2002, 24(3): 213-216.
LIU Yue-hui, HAO Zhi-yong, FU Lu-hua, et al. A Study on Engine Radiated Noise [J]. Automotive Engineering, 2002, 24(3): 213-216.
[6] 杨陈,郝志勇,陈馨蕊. 柴油机机体辐射噪声预测及低噪声改进设计[J]. 江苏大学学报:自然科学版,2008, 29(4): 302-303.
YANG Chen, HAO Zhi-yong, CHEN Xin-rui. Prediction of engine block’s radiation noise and low-noise design [J]. Journal of Jiangsu University: Natural Science Edition, 2008, 29(4): 302-303.
[7] 贾维新,郝志勇,杨金才. 发动机油底壳辐射噪声预测方法的研究[J]. 内燃机学报,2005, 23(3): 270-271.
JIA Wei-xin, HAO Zhi-yong, YANG Jin-cai. Research on prediction method of radiated noise of engine oil pan [J]. Transactions of Csice, 2005, 23(3): 270271.
[8] 韩松涛,郝志勇. 6102B型柴油机曲轴三维有限元模态分析与试验研究[J]. 农业机械学报, 2001, 32(4): 74-75.
HAN Song-tao, HAO Zhi-yong. Mode analysis of three-dimensional finite element and experimental study on a 6102B diesel engine crankshaft [J]. Transactions of the Chinese Society of Agricultural Machinery, 2001, 32(4): 74-75.
[9] 郭磊. 车用动力总成结构振动噪声的虚拟预测与分析技术研究[D].杭州:浙江大学,2009: 1214,54-55.
GUO lei. Investigation on powertrain structure’s vibration and noise performance Based on Virtual Forecast Technology [D]. Hangzhou: Zhejiang University. 2009: 1214, 54-55.
[11] 舒歌群,马维忍,梁兴雨,等. 柴油机薄壁件表面辐射噪声的研究[J]. 内燃机工程. 2009, 30(2): 25-26.
SHU Ge-qun, MA Wei-ren, LIANG Xing-yu, et al. Radiation noise of external thin-wall components in diesel engine [J]. Chinese Internal Combustion Engine Engineering, 2009, 30(2): 25-26.
[12] 梁新华. 汽车车身薄壁件阻尼复合结构振动-声学分析与优化[D]. 上海:上海交通大学, 2007: 44-47.
LIANG Xin-hua. Vibro-acoustic analysis and optimization of damping panel in auto-body [D]. Shanghai: Shanghai Jiaotong University. 2007: 44-47.
[13] 盛美萍,王敏庆,孙进才. 噪声与振动控制技术基础[M]. 北京 : 科学出版社, 2001: 68-75.

No related articles found!