Please wait a minute...
浙江大学学报(工学版)
J4  2012, Vol. 46 Issue (3): 503-508    DOI: 10.3785/j.issn.1008-973X.2012.03.019
能源工程     
污泥结合水测量方法和水分分布特性
谢浩辉,麻红磊,池涌,马增益
浙江大学 能源清洁利用国家重点实验室, 浙江 杭州 310027
Bound water measurement methods and moisture distribution within sewage sludge
XIE Hao-hui, MA Hong-lei, CHI Yong, MA Zeng-yi
State Key Laboratory of Clean Energy Utilization, Zhejiang University, Hangzhou 310027, China
 全文: PDF  HTML
摘要：

为了实现污泥高效脱水,对污泥水分分布特征与脱水性能变化的关系进行研究.分别利用热干燥法、抽滤法、压滤法、水活度法和膨胀计法测定同一市政污泥的结合水相对质量分数,通过分析比较测量数据和应用原理,总结出各种方法的优缺点和适用条件.基于膨胀计法对污泥水分能量状态进行了分析,构建了污泥水分分布特征曲线,并阐明污泥在不同水分质量分数时的机械脱水效果.研究表明：5种方法的结合水质量分数（结合水/干基）测量结果差异明显,其中抽滤法测量值最大为628%,水活度法测量值最小,只有34%；膨胀计法操作快捷、原始数据容易处理,优于其余4种测量方法.当污泥水分相对质量分数(全水分/干基)大于183%时,适当提高设备的脱水强度能够较好地改善脱水效果.
Abstract:

Relationship between sludge moisture distribution and dewatering performance was studied to achieve effective dewatering of sewage sludge. Five measurement methods, including drying test, filtration test, expression test, sorption isotherms test and dilatometric test were applied to determine the bound water content within a typical sewage sludge sample. Features and applicable conditions of each method were obtained via analysis and comparison of their measurement data and theories. A sludge moisture distribution curve was constructed via analysis of the sludge moisture energy status in dilatometric method, which could be utilized to elucidate the sludge dewatering performance at different moisture contents. The experimental results indicate that the sludge bound water measurement results from five methods are different, and the maximum data of 628% mass fraction of the sludge bound water (bound water/ dry water) measurement result is obtained from filtration test whereas the minimum data of 34% from sorption isotherms test. The dilatometric method is preferable to the other methods due to its rapid operation and easy processing of raw experimental data. When the sludge moisture content (moisture/ dry solid) is larger than 183%, better dewatering performance can be achieved by slightly increasing of the strength of dewatering device．
出版日期: 2012-03-01
:  X 705  
基金资助:

水体污染控制与治理科技重大专项资助项目(2009ZX07317-003)；浙江省重大科技专项资助项目(2006C11009,2007C03003)
通讯作者: 池涌，男，教授，博导     E-mail: chiyong@cmee.zju.edu.cn
作者简介: 谢浩辉(1985-)，男，硕士生，主要从事污泥水分分布特性和热水解的研究.E-mail: xhh_85@163.com
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　

引用本文:

谢浩辉,麻红磊,池涌,马增益. 污泥结合水测量方法和水分分布特性[J]. J4, 2012, 46(3): 503-508.

XIE Hao-hui, MA Hong-lei, CHI Yong, MA Zeng-yi. Bound water measurement methods and moisture distribution within sewage sludge. J4, 2012, 46(3): 503-508.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2012.03.019    或    http://www.zjujournals.com/eng/CN/Y2012/V46/I3/503


[1\] FYTILI D, ZABANIOTOU A. Utilization of sewage sludge in EU application of old and new methods: a review\
[J\]. Renewable and Sustainable Energy Reviews, 2008,12(1): 116-140.
\
[2\] 肖本益, 刘俊新. 不同预处理方法对剩余污泥性质的影响研究\
[J\]. 环境科学, 2008, 29(2)：327-331.
XIAO Benyi, LIU Junxin. Impacts of different pretreatment on characteristics of excess sludge\
[J\]. Environmental Science, 2008, 29(2) : 327-331.
\
[3\] 荀锐, 王伟, 乔玮. 水热改性污泥的水分分布特征与脱水性能研究\
[J\]. 环境科学, 2009, 30(3)：851-856.
XUN Rui, WANG Wei, QIAO Wei. Water distribution and dewatering performance of the hydrothermal conditioned sludge\
[J\]. Environmental Science, 2009, 30(3) : 851-856.
\
[4\] VAXELAIRE J, CEZAC P. Moisture distribution in activated sludges: a review\
[J\]. Water Research, 2004,38(9): 2215-2230.
\
[5\] 朱敬平, 李笃中. 污泥处置（Ⅲ）：污泥后处理\
[J\]. 台大工程, 2001, 83: 59-81.
ZHU Jingping, LI Duzhong. Sludge management (III): sludge posttreatment\
[J\]. Bulletin of the College of Engineering of National Taiwan University, 2001, 83: 59-81.
\
[6\] CHEN G W, HUNG W T, CHANG I L, et al. Continuous classi cation of moisture content in waste activated sludges\
[J\]. Environmental Engineering, 1997, 123(3): 253-258.
\
[7\] SMITH J K, VESILIND P A. Dilatometric measurement of bound water in wastewater sludge\
[J\]. Water Research, 1995, 29(12): 2621-2626.
\
[8\] COLIN F, GAZBAR S. Distribution of water in sludges in relation to their mechanical dewatering\
[J\]. Water Research, 1995, 29(8): 2000-2005.
\
[9\] LEE D J, LAI J Y, MUJUMDAR. Moisture distribution and dewatering efficiency for wet materials\
[J\]. Drying Technology, 2006, 24(1):1201-1208.
\
[10\] GOULA A M, KARAPANTSIOS T D, ACHILIAS D S, et al. Water sorption isotherms and glass transition temperature of spray dried tomato pulp\
[J\]. Journal of Food Engineering, 2008, 85(1): 73-83.  
\
[11\] LEE D J, LEE S F. Measurement of bound water content in sludge: the use of differential scanning calorimetry\
[J\]. Chemical Technology and Biotechnology, 1995, 62(4): 359-365.
\
[12\] WU C C, HUANG P, LEE D J. Bound water content and water binding strength on sludge flocs\
[J\]. Water Research, 1998, 32(3): 900-904.
[1] 符成龙,麻红磊,池涌,严建华,倪明江. 热水解处理制革污泥过程中总Cr的转移与稳定性研究[J]. J4, 2013, 47(9): 1631-1636.
[2] 翁焕新, 章金骏, 曹彦圣, 马学文. 污泥陶粒的性能特征与烧制工艺[J]. J4, 2011, 45(10): 1877-1883.
[3] 王勤, 严建华, 潘新潮, 池涌, 高飞. 利用热等离子体熔融垃圾焚烧飞灰[J]. J4, 2011, 45(1): 141-145.
[4] 蒋旭光, 李春雨, 池涌, 俞恺, 傅娟娟. 医疗废物焚烧过程中无机溴的迁移特性研究[J]. J4, 2010, 44(9): 1787-1792.
[5] 马学文, 翁焕新. 温度与颗粒大小对污泥干燥特性的影响[J]. J4, 2009, 43(09): 1661-1667.