高静水压力作用下深海油气管道的局部屈曲

doi:10.3785/j.issn.1008-973X.2012.01.03

2012, Vol. 46

Issue (1): 14-19 DOI: 10.3785/j.issn.1008-973X.2012.01.03

土木工程

高静水压力作用下深海油气管道的局部屈曲

龚顺风1,陈源1,金伟良1,白勇1,李志刚2,赵冬岩2

1.浙江大学结构工程研究所,浙江杭州 310058；2.海洋石油工程股份有限公司,天津 300452

Local buckling of deepwater oil-gas pipeline under high hydrostatic pressure

GONG Shun-feng1, CHEN Yuan1, JIN Wei-liang1, BAI Yong1,
LI Zhi-gang2, ZHAO Dong-yan2

1. Institute of Structural Engineering, Zhejiang University, Hangzhou 310058, China;
2. Offshore Oil Engineering Co. Ltd., Tianjin 300452, China

全文: PDF HTML

摘要：

以有初始缺陷的厚壁钢管为研究对象,开展外部高静水压力作用下管道结构的模型试验和有限元数值模拟分析. 通过在压力缸内泵入水的方式对钢管试件施加均匀外部压力,测得钢管发生局部屈曲时的压力峰值. 基于ABAQUS软件,数值模拟分析试验钢管在静水压力作用下的屈曲和后屈曲行为,得到钢管的失稳压力和屈曲后的形态,与试验结果相比吻合较好. 利用建立的数值模拟方法,分析不同材料性能、径厚比和初始椭圆率对钢质管道屈曲的影响. 结果表明：材料硬化系数较大的管道,失稳压力较大；随着初始椭圆率的增加,管道的失稳压力显著减小；对于深水或超深水油气管道的屈曲失稳压力,国外规范的计算公式偏保守,而且不能解释不同材料硬化系数的影响.

Abstract:

The special studies were focused on the defective thick-walled steel pipe, and the model test and numerical simulation of the pipe structures were respectively conducted under external high hydrostatic pressure. The uniform external pressure was applied on the pipe specimen by squeezing water into the pressure cylinder, and the peak pressure was measured when the local buckling occurred. The numerical simulation on buckling and post-buckling behaviors of experimental steel pipe under hydrostatic pressure was conducted based on the software ABAQUS. The collapse pressure and deformation shape of the steel pipe after buckling accorded well with the test results. The effects of different material property, ratio of diameter to thickness and initial ellipticity on the buckling of pipe were analyzed by using the established method of numerical simulation. Results show that the larger the material hardening coefficient is, the greater the collapse pressure of pipe becomes; as the initial ellipticity increases, the collapse pressure of pipe remarkably decreases; as to the collapse pressure of deepwater and ultra-deepwater oil-gas pipeline, the formula from the current specifications is somewhat conservative, and takes no into account the effect of material hardening coefficient.

出版日期: 2012-02-22

TE 973.1

基金资助:

国家自然科学基金资助项目（51009122）；国家“863”高技术研究发展计划资助项目（2006AA09A105）；中央高校基本科研业务费专项资金资助项目（2010QNA4030）.

作者简介: 龚顺风(1975－)，男，副教授，博导，从事深海油气管道屈曲和失稳的研究. E-mail:sfgong@zju.edu.cn

	服务
	把本文推荐给朋友
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章

引用本文:

龚顺风,陈源,金伟良,白勇,李志刚,赵冬岩. 高静水压力作用下深海油气管道的局部屈曲[J]. J4, 2012, 46(1): 14-19.

GONG Shun-feng, CHEN Yuan, JIN Wei-liang, BAI Yong, LI Zhi-gang, ZHAO Dong-yan. Local buckling of deepwater oil-gas pipeline under high hydrostatic pressure. J4, 2012, 46(1): 14-19.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2012.01.03 或 http://www.zjujournals.com/eng/CN/Y2012/V46/I1/14

［1］ KYRIAKIDES S, CORONA E. Mechanics of submarine pipelines ［M］. Oxford: Elsevier, 2007: 89-130．
［2］ TIMOSHENKO S E, GERE J M. Theory of elastic stability ［M］. New York: McGrawHill, 1961: 289-296．
［3］ TAMANO T, MIMAKI T, YAGANIMOTO S. New empirical formula for collapse resistance of commercial casing ［C］// Proceedings of the 2nd Interntaional Offshore Mechanics and Arctic Engineering Symposium. Houston: ASME, 1983: 489-495．
［4］ API RP 1111: design, construction, operation and maintenance of offshore pipelines (limit state design) ［S］. 4th ed. Washington: API, 2009．
［5］ PARK T D, KYRIAKIDES S. On the collapse of dented cylinders under external pressure ［J］. International Journal of Mechanical Sciences, 1995, 38(5): 557-578．
［6］ SAKAKIBARA N, KYRIAKIDES S, CORONA E. Collapse of partially corroded or worn pipe under external pressure ［J］. International Journal of Mechanical Sciences, 2008, 50(12): 1586-1597．
［7］ XUE J, HOO FATT M S. Buckling of a nonuniform, long cylindrical shell subjected to external hydrostatic pressure ［J］. Engineering Structures, 2002, 24(8): 1027-1034．
［8］ YUAN L, GONG S F, JIN W L. Analysis on buckling performance of submarine pipelines during deepwater pipelaying operation ［J］. China Ocean Engineering, 2008, 516(12): 4070-4075．
［9］ HUANG X, MIHSEIN M, KIBBLE K, et al. Collapse strength analysis of casing design using finite element method ［J］. International Journal of Pressure Vessels and Piping, 2000, 77(7): 359-367．
［10］ ASSANELLI A P, TOSCANO R G, JOHNSON D H, et al. Experimental/numerical analysis of the collapse behavior of steel pipes ［J］. Engineering Computations, 2000, 17(4): 459-485．
［11］ CORRADI L, LUZZI L, TRUDI F. Plasticityinstability coupling effects on the collapse of thick tubes ［J］. International Journal of Structural Stability and Dynamics, 2005, 5(1): 1-18．
［12］党学博, 龚顺风, 金伟良,等. 深水海底管道极限承载能力分析［J］. 浙江大学学报：工学版, 2010, 44(4): 778-782．
DANG Xuebo, GONG Shunfeng, JIN Weiliang, et al. Analysis on ultimate bearing capacity of deepwater submarine pipe ［J］. Journal of Zhejiang University: Engineering Science, 2010, 44(4): 778-782．
［13］ DNVOSF101， Offshore standardsubmarine pipeline systems ［S］. Hovik,Norway: DNV, 2007．
［14］ API Specifications 5L， Specifications for line pipe ［S］. 43rd ed. Washington: API, 2004．
［15］ PALMER A C, KING R A. Subsea pipeline engineering ［M］. Tulsa: PennWell, 2008: 327-360．

[1]	龚顺风,徐普,钟文军,何宁,燕晖. 深水S型铺管收弃管作业分析[J]. J4, 2013, 47(11): 1904-1910.

Viewed

Full text

Abstract

Cited

Shared

Discussed