Please wait a minute...
J4  2013, Vol. 47 Issue (7): 1232-1237    DOI: 10.3785/j.issn.1008-973X.2013.07.015
通信工程、自动化技术     
 布里渊分布式传感的空间分辨率及标定方法
崔何亮1,2, 张丹1, 施斌1
1.南京大学 地球科学与工程学院,江苏 南京 210093;2.国家电力监管委员会大坝安全监察中心,浙江 杭州 310014 
Spatial resolution and its calibration method for Brillouin scattering based distributed sensors
CUI He-liang1,2, ZHANG Dan1, SHI Bin1
1.School of Earth Sciences and Engineering, Nanjing University, Nanjing 210093, China;2. Large Dam Safety
Supervision Center, State Electricity Regulatory Commission, Hangzhou 310014, China  
 全文: PDF 
摘要:

针对基于布里渊散射原理的分布式光纤传感技术的重要参数之一——空间分辨率,通过分析定荷拉伸试验的结果,对比2种不同空间分辨率下实测的定点拉伸光纤的应变分布,说明了空间分辨率对测量结果的影响,探讨标定空间分辨率的10%~90%温度台阶法和温度热点法及其适用性.提出异种光纤串法,即将2种不同峰值频率的光纤、按不同长度交替熔接而成的光纤串,通过分析光纤串的测量结果对空间分辨率进行标定.试验表明,与温度台阶法和温度热点法相比,异种光纤串法具有准确、客观、测试结果的可对比性强等特点.

关键词: 空间分辨率标定异种光纤串法分布式光纤传感BOTDRBOTDA布里渊    
Abstract:

Spatial resolution is one of the important parameters for Brillouin scattering based distributed optical fiber sensing. The results of constant tensile load test were analyzed, and the strain distributions of point-by-point fixed fiber measured by two different spatial resolution respectively were compared. Then the influence of spatial resolution on measured strain was analyzed. Two spatial resolution calibration methods, including 10%~90% step-function method and hot-spot method, and their applicability were discussed. The dissimilar-fiber-splicing method was proposed to calibrate the spatial resolution. Dissimilar-fiber-splicing means two variant peak frequency fibers are alternately spliced in series with segments of different length. The calibration experiment shows that dissimilar-fiber-splicing method is accurate, objective, and comparative.

Key words: spatial resolution    calibration    dissimilar-fiber-splicing method    distributed optical fiber sensing    BOTDR    BOTDA    Brillouin
出版日期: 2013-08-15
:     
基金资助:

国家自然科学基金青年科学基金资助项目(40702045);国家“973”重点基础研究发展规划资助项目(2011CB710605) ;中央高校基本科研业务费专项资金资助项目(1116020605).

通讯作者: 张丹,男,副教授.     E-mail: zhangdan@nju.edu.cn
作者简介: 崔何亮(1980-),男,博士生,从事大坝安全管理和工程监测技术的研究.E-mail: cuiheliang@gmail.com
服务  
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章  

引用本文:

崔何亮, 张丹, 施斌.  布里渊分布式传感的空间分辨率及标定方法[J]. J4, 2013, 47(7): 1232-1237.

CUI He-liang, ZHANG Dan, SHI Bin. Spatial resolution and its calibration method for Brillouin scattering based distributed sensors. J4, 2013, 47(7): 1232-1237.

链接本文:

http://www.zjujournals.com/xueshu/eng/CN/10.3785/j.issn.1008-973X.2013.07.015        http://www.zjujournals.com/xueshu/eng/CN/Y2013/V47/I7/1232

[1] OHNO H, NARUSE H, KIHARA M, et al. Industrial application of the BOTDR optical fiber strain sensor [J]. Optical Fiber Technology, 2001, 7(1): 45-64.
[2] 施斌, 徐洪钟, 张丹, 等. BOTDR应变监测技术应用在大型基础工程健康诊断中的可行性研究[J]. 岩石力学与工程学报, 2004, 23(3): 493-499.
SHI Bin, XU Hong-zhong, ZHANG Dan, et al. Feasibility study on application of BOTDR to health monitoring for large infrastructure engineering [J]. Chinese Journal of Rock Mechanics and Engineering, 2004, 23(3): 493-499.
[3] 金伟良, 毛江鸿, 何勇. 混凝土内部应变分布式光纤实时检测方法及试验研究[J]. 土木建筑与环境工程, 2011, 33(1): 1-6.
JIN Wei-liang, MAO Jiang-hong, HE Yong. Experimental analysis on real-time distributed strain measurement in concrete [J]. Journal of Civil Architectural and Environmental Engineering, 2011, 33(1): 16.
[4] 刘永莉, 孙红月, 于洋, 等. 抗滑桩内力的BOTDR监测分析[J]. 浙江大学学报:工学版, 2012, 46(2): 243-249.
LIU Yong-li, SUN Hong-yue, YU Yang, et al. BOTDR monitoring analysis of anti-sliding pile internal force [J]. Journal of Zhejiang University: Engineering Science, 2012, 46(2): 243-249.
[5] 隋海波, 施斌, 张丹,等. 边坡工程分布式光纤监测技术研究[J]. 岩土力学与工程学报,2008,22(增2): 37253731.
SUI Hai-bo, SHI bin, ZHANG Dan, et al. Study on distributed optical fiber sensor-based monitoring for slope engineering [J]. Chinese Journal of Rock Mechanics and Engineering, 2008, 22(suppl.2): 3725-3731.
[6] BAO X Y, CHEN L. Recent progress in Brillouin scattering based fiber sensors [J]. Sensors, 2011(11): 4152-4187.
[7] 张在宣, 金尚忠, 王剑锋, 等. 分布式光纤拉曼光子温度传感器的研究进展[J]. 中国激光, 2010, 37(11): 27492761.
ZHANG Zai-xuan, JIN Shang-zhong, WANG Jian-feng, et al. Distributed optical fiber Raman photon sensor research review [J]. Chinese Journal of Lasers, 2010, 37(11): 2749-2761.
[8] 刘, 邹健, 黄尚廉. 分布式光纤温度传感器系统分辨率确定的理论分析[J]. 光子学报, 1996, 25(7): 635-639.
LIU Yan, ZOU Jian, HUANG Shang-lian. Theoretic analysis for determining the resolutions of distributed optical fiber temperature sensing system [J]. ACTA Photonica Sinica, 1996, 25(7): 635-639.
[9] ZHANG Dan, XU Hong-zhong, SHI Bin, et al. Brillouin power spectrum analysis for partially uniformly strained optical fiber [J]. Optics and Lasers in Engineering, 2009, 47(9): 976-981.
[10] 张旭苹, 王峰, 路元刚. 基于布里渊效应的连续分布式光纤传感技术[J]. 激光与光电子学进展, 2009, 46(11): 14-20.
ZHANG Xu-ping, WANG Feng, LU Yuan-gang. Fully distributed optical fiber sensor based on Brillouin effect [J]. Laser and Optoelectronics Progress, 2009, 46(11): 14-20.
[11] BAO X Y, BROWN A, DEMERCHANT M, et al. Characterization of the Brillouin-loss spectrum of single-mode fibers by use of very short (<10 ns) pulses [J]. Optics Letters, 1999, 24(8): 510-512.
[12] GALNDEZ C A, LPEZ-HIGUERA J M. Decimeter spatial resolution by using differential preexcitation BOTDA pulse technique [J]. IEEE Sensors Journal, 2011, 11(10): 2343-2348.
[13] BROWN A, COLPITTS B, BROWN K. Distributed sensor based on dark-pulse Brillouin scattering [J]. IEEE Photonics Technology Letters, 2005, 17(7): 1501-1503.
[14] FOALENG S M, TUR M, BEUGNOT J C, et al. High spatial and spectral resolution long-range sensing using Brillouin echoes [J]. IEEE Journal of Lightwave Technology, 2010, 28(20): 2993-3003.
[15] KISHIDA K, LI C H, LIN S B, et al. Pulsed pre-pump method to achieve centimeter order spatial resolution in Brillouin distributed measuring technique [J]. Technical Report of IEICE OFT, 2004, 104(341): 15-20.
[16] KOYAMADA Y, SAKAIRI Y, TAKEUCHI N, et al. Novel technique to improve spatial resolution in Brillouin optical time-domain reflectometry [J]. IEEE Photonics Technology Letters, 2007, 19(23): 1910-1912.
[17] HARTOG A H, LEACH A P, GOLD M P. Distributed temperature sensing in solid-core fibers [J]. Electronics Letters, 1985, 21(23): 1061-1062.

[1] 杜锦华, 薛运田, 刘全威. 永磁起动/发电机系统的参数匹配标定与实现[J]. 浙江大学学报(工学版), 2017, 51(9): 1851-1860.
[2] 王青, 余小光, 乔明杰, 赵安安, 程亮, 李江雄, 柯映林. 基于序列二次规划算法的定位器坐标快速标定方法[J]. 浙江大学学报(工学版), 2017, 51(2): 319-327.
[3] 崔仁洁, 蒙涛, 霍俊海, 金仲和. 微纳卫星动态剩磁在轨标定技术[J]. 浙江大学学报(工学版), 2017, 51(12): 2444-2450.
[4] 张阿龙, 章明, 乔明杰, 朱伟东, 梅标. 基于视觉测量的环形轨底座位姿标定方法[J]. 浙江大学学报(工学版), 2016, 50(6): 1080-1087.
[5] 马子昂,项志宇. 光流测距全向相机的标定与三维重构[J]. 浙江大学学报(工学版), 2015, 49(9): 1651-1657.
[6] 袁康正,朱伟东,陈磊,薛雷,戚文刚. 机器人末端位移传感器的安装位置标定方法[J]. 浙江大学学报(工学版), 2015, 49(5): 829-834.
[7] 杨廷俊, 朱博, 刘雨. 基于优化顶点弹簧模型的半沉浸环境标定算法[J]. 浙江大学学报(工学版), 2015, 49(4): 676-682.
[8] 杨力, 刘俊毅, 王延长, 刘济林. 基于全景相机和全向激光雷达的致密三维重建[J]. 浙江大学学报(工学版), 2014, 48(8): 1481-1487.
[9] 盖宇春, 朱伟东, 柯映林. 三坐标定位器部件刚度配置方法[J]. 浙江大学学报(工学版), 2014, 48(8): 1434-1441.
[10] 向甜,王昊,蒙涛,金仲和. 三轴磁强计与MEMS陀螺的在轨实时标定方法[J]. J4, 2014, 48(3): 541-547.
[11] 徐嵩,孙秀霞,何衍. 利用直线段成像特性的摄像机畸变迭代标定方法[J]. J4, 2014, 48(3): 404-413.
[12] 杨力, 朱株, 刘济林. 一种嵌入式汽车鸟瞰全景图拼接算法[J]. J4, 2014, 48(2): 292-296.
[13] 林颖, 龚小谨, 刘济林. 基于单位视球的鱼眼相机标定方法[J]. J4, 2013, 47(8): 1500-1507.
[14] 刘永莉,孙红月,于洋,詹伟,尚岳全. 基于BOTDR监测技术抗滑桩上滑坡推力确定[J]. J4, 2012, 46(5): 798-803.
[15] 吕品,吴锋,张永光,张翼,钱啸君. 标定系统中多ECU分时下载研究[J]. J4, 2012, 46(3): 494-498.