Please wait a minute...
浙江大学学报(工学版)
J4  2012, Vol. 46 Issue (8): 1382-1389    DOI: 10.3785/j.issn.1008-973X.2012.08.005
机械工程     
挖掘机电液流量匹配控制系统流量补偿试验
徐兵1, 刘伟1,2, 杨华勇1, 张圣峰1
1. 浙江大学 流体动力与机电系统国家重点实验室,浙江 杭州 310027；
2. 中联重科股份有限公司,湖南 长沙 410013
Experiment study on flow compensation of electro-hydraulic flow
matching control system in hydraulic excavator
XU Bing1, LIU Wei1,2, YANG Hua-yong1, ZHANG Sheng-feng1
1. State Key Laboratory of Fluid Power Transmission and Control, Zhejiang University, Hangzhou 310027, China；
2. Zoomlion Heavy Industry Science and Technology Co., Ltd., Changsha 410013, China
 全文: PDF 
摘要：

为改善挖掘机液压系统的操控性和节能性,采用电比例泵和电比例多路阀同步控制方式的电液流量匹配控制系统.以2 t挖掘机试验样机为研究对象,分析电液流量匹配控制系统的结构原理和特点；针对挖掘机轻重负载不同工况,测试系统的压力和流量特性,通过试验研究基于压力特性的开环流量补偿方法.利用实时检测的油缸速度间接实现流量闭环控制,试验分析动臂、铲斗单执行器动作和复合动作的速度控制特性,并对系统进行变负载、变速度工况测试.试验结果表明：采用流量补偿方法提高系统的流量控制精度；电液流量匹配控制系统与负载敏感系统相比,泵的压力裕度减小0.6～0.7 MPa,提高了系统的节能性和动态响应性.
关键词： 电液流量匹配控制;  挖掘机;  流量补偿;  负载敏感系统    
Abstract:

In order to obtain an advanced operation performance and an improved energy efficiency of hydraulic systems in excavators, electro hydraulic flow matching control (EFMC) systems were introduced, in which electro-proportional valves and electro-proportional pumps worked in a synchronous control mode. The principle and characteristics of EFMC systems were analyzed in the experimental prototype of 2-ton excavator that installed an EFMC system. Based on the characteristics of system pressure and flow rate, the open-loop flow compensation of the excavator was experimentally studied under the conditions of light and heavy loads. Real-time velocity was monitored and used to carry out flow closed-loop control indirectly. Both on the boom and bucket, the velocity characteristics of single and compound action were experimentally investigated with different loads and reference velocities. The experimental results indicate that the accuracy of flow control is improved by the use of flow compensation methods. Compared with the load-sensing system, the EFMC system has a more improved capability. The pressure margin of the EFMC system is reduced by more than 0.6-0.7 MPa, and the systemic performance of dynamic response and energy efficiency are improved.
Key words: electro-hydraulic flow matching control    excavator    flow compensation    load-sensing system
出版日期: 2012-09-03
:  TH 137.5  
基金资助:

国家“863”高技术研究发展计划资助项目(2010AA044401)；中央高校基本科研业务费专项资金资助项目；贵州省重大科技专项资助项目.
作者简介: 徐兵（1971—），男，教授，博导，主要从事机电液控制及流体动力元件与系统方面的研究. E-mail: bxu@zju.edu.cn
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　

引用本文:

徐兵, 刘伟, 杨华勇, 张圣峰. 挖掘机电液流量匹配控制系统流量补偿试验[J]. J4, 2012, 46(8): 1382-1389.

XU Bing, LIU Wei, YANG Hua-yong, ZHANG Sheng-feng. Experiment study on flow compensation of electro-hydraulic flow
matching control system in hydraulic excavator. J4, 2012, 46(8): 1382-1389.

链接本文:

http://www.zjujournals.com/xueshu/eng/CN/10.3785/j.issn.1008-973X.2012.08.005    或    http://www.zjujournals.com/xueshu/eng/CN/Y2012/V46/I8/1382

［1］ LANTTO B. On fluid power control with special reference to multiload conditions in load sensing systems ［D］. Linkoping: Linkoping University, 1992: 2-40.
［2］ 王庆丰,魏建华,吴根茂,等.工程机械液压控制技术的研究进展与展望［J］.机械工程学报,2003,39(12): 51-56.
WANG Qingfeng, WEI Jianhua, WU Genmao, et al. Progress and prospects in the research of hydraulic control for construction machine ［J］. Chinese journal of mechanical engineering, 2003, 39(12): 51-56.
［3］ 孔晓武.带长管道的负载敏感系统研究［D］.杭州:浙江大学,2003: 5-30.
KONG Xiaowu. Research on the loadsensitive system with long tipe ［D］. Hagnzhou: Zhejiang University, 2003: 5-30.
［4］ CETINKUNT S, PINSOPON U, CHEN C. Positive flow control of closedcenter electrohydraulic implementbywire systems for mobile equipment applications ［J］. Mechatronics, 2004, (14): 403-420.
［5］ FEDDE T, HARMS H H. An adaptive hydraulic system for mobile applications ［C］∥Proceedings of the 5th International Fluid Power Conference. Aachen, Germany: IFK, 2006: 95-106.
［6］ FEDDE T, LANG T, HARMS H H. An adaptable hydraulic system for tractors ［C］∥Proceedings of Power Transmission and Motion Control. BATH, UK: PTMC, 2005: 307-316.
［7］ DUROVIC M, HELDUSER S. New control strategies for electrohydraulic load sensing ［C］∥Proceedings of the Bath Workshop on Power Transmission and Motion Control. BATH, UK: PTMC, 2004: 201-210.
［8］ HELDUSER S, DJUROVIC M. Control strategies for loadsensing in mobile machinery ［C］∥Proceedings of the 6th International Conference on Fluid Power Transmission and Control. Hangzhou: ICFP, 2005: 32-42.
［9］ FINZEL R., HELDUSER S. New electrohydraulic control systems for mobile machinery ［C］∥Proceedings of the Fluid Power and Motion Control FPMC 2008. BATH, UK: FPMC, 2008: 309-321.
［10］ GROSBRINK B, HARMS T. Control concept for an advanced loadsensing system ［C］∥Proceedings of the 7th International Conference on Fluid Power Transmission and Control. Hangzhou: ICFP, 2009: 201-204.
［11］ FINZEL R, HELDUSER S, JANG D S. Electrohydraulic control systems for mobile machinery with low energy consumption ［C］∥Proceedings of the 7th International Conference on Fluid Power Transmission and Control. Hangzhou: ICFP,2009: 214-219.
［12］ 张栋,许纯新,金立生,等.挖掘机单神经元比例积分微分节能控制系统［J］.西安交通大学学报,2004,38(5): 529-532.
ZhANG Dong, XU Chunxin, JIN Lisheng, et al. Research on energy saving control system of hydraulic excavator based on selfadaptive single neuron proportionintegraldifferential ［J］. Journal of Xi’an Jiaotong University, 2004, 38(5): 529-532.
[1] 师建鹏, 权龙, 张晓刚, 熊晓燕. 进出口独立复合控制挖掘机的动臂速度位置特性[J]. 浙江大学学报(工学版), 2017, 51(9): 1797-1807.
[2] 赵鹏宇,陈英龙,周华,杨华勇. 油液混合动力挖掘机势能回收及能量管理策略[J]. 浙江大学学报(工学版), 2016, 50(5): 893-901.
[3] 王飞, 管成, 肖扬, 李威. 挖掘机动臂势能回收系统的压力滑模控制[J]. 浙江大学学报(工学版), 2016, 50(2): 201-208.
[4] 肖扬,管成,王飞. 扭矩耦合式油液混合动力挖掘机能量管理[J]. 浙江大学学报(工学版), 2016, 50(1): 70-77.
[5] 管成,王飞,解泽哲,肖扬. 功率差值补偿式挖掘机液压混合动力系统[J]. 浙江大学学报(工学版), 2015, 49(5): 813-820.
[6] 陈进,庆飞,庞晓平. 基于组合挖掘的反铲液压挖掘机工作装置优化设计[J]. 浙江大学学报(工学版), 2014, 48(9): 1654-1660.
[7] 刘伟, 徐兵, 杨华勇, 朱晓军. LUDV多路阀的挖掘机电液流量
匹配控制系统特性[J]. J4, 2012, 46(8): 1360-1368.
[8] 管成,徐晓,林潇,王守洪. 液压挖掘机回转制动能量回收系统[J]. J4, 2012, 46(1): 142-149.
[9] 林潇, 管成, 潘双夏, 等. 并联式混合动力液压挖掘机动力源特性研究[J]. J4, 2010, 44(2): 353-357.
[10] 管成, 王向炜, 王冬云. 混合动力挖掘机用镍氢电池SOC估算策略[J]. J4, 2010, 44(12): 2370-2375.
[11] 王冬云, 潘双夏, 林潇, 等. 并联混合动力挖掘机动力源匹配方法研究[J]. J4, 2009, 43(10): 1783-1788.
[12] 肖清 王庆丰 张彦廷 付强. 液压挖掘机混合动力系统建模及控制策略研究[J]. J4, 2007, 41(3): 480-483.
[13] 黎业飞 邱清盈 冯培恩. 基于刚-柔混合建模的时变结构动力学分析[J]. J4, 2007, 41(2): 311-314.