Please wait a minute...
浙江大学学报(工学版)
JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE)
    
Dynamic distribution method of multi-axle vehicle’s driving axle load on test bench
YANG Yong1, ZHOU Xiao-jun1, YANG Chen-long1, MO Jin-qiu2
1. The State Key Laboratory of Fluid Power Transmission and Control, Zhejiang University, Hangzhou 310027, China; 2. Mechanical Engineering School, Shanghai Jiao Tong University, Shanghai 200240, China
Download:   PDF(679KB) HTML
Export: BibTeX | EndNote (RIS)      

Abstract  

When a multi-axle vehicle was tested in a test bench, due to the equal distribution of load, the driving-axles’ load of vehicle applied by the dynamometer-motor kept the same and no dynamical changes were observed according to the different driving statuses. So a method of dynamical load distribution was put forward, by which the distribution of the driving-axles’ load is close to that in the real driving statuses. A dynamical model was built for the multi-axle vehicle, by which different driving status were analyzed. The computing methods of the defined coefficients of the load’s distribution under different running statuses, such as stationary, starting, acceleration, neutral taxiing and breaking were given. By using the new distribution method, the simulated analyses of the whole test system showed that as different as the driving status was, the different coefficients of the load’s distribution were. The driving-axles’ load applied by the dynamometer-motor varied well with the variations of the distribution coefficients, and thus the dynamic load distribution of the driving-axles was achieved.

Published: 01 April 2015
CLC:  U 461  
  U 467  
Service
E-mail this article
Add to my bookshelf
Add to citation manager
E-mail Alert
RSS
Articles by authors
Cite this article:

YANG Yong, ZHOU Xiao-jun, YANG Chen-long, MO Jin-qiu. Dynamic distribution method of multi-axle vehicle’s driving axle load on test bench. JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE), 2014, 48(6): 1080-1085.

URL:

http://www.zjujournals.com/eng/10.3785/j.issn.1008-973X.2014.06.016     OR     http://www.zjujournals.com/eng/Y2014/V48/I6/1080


多轴车辆台架试验驱动轴载荷的动态分配方法

多轴驱动车辆在台架试验中进行电惯量模拟时,载荷的平均分配方法使得车辆各个驱动轴的载荷在整个试验过程中无法根据车辆的行驶状态进行动态变化.为此针对载荷平均分配法的不足,提出一种多轴驱动车辆在台架试验时的驱动轴载荷动态分配方法.该方法可使多轴车辆在台架试验时,各个驱动轴的载荷分配更接近于实际行驶中的载荷分配情况.通过对多轴驱动车辆进行动力学建模,及对多轴车辆各种行驶情况进行分析,给出了多轴车辆在静止、启动、加速、空挡滑行及制动情况下载荷分配系数的计算方法.通过对该分配方法进行整个试验系统的仿真分析,结果表明：车辆的行驶状态不同,通过分配模型计算出的各驱动轴载荷分配系数也不同；并且各驱动轴的测功电机所施加的负载能较好的跟随载荷分配系数的变化而变化，从而实现了各驱动轴载荷的动态分配.

［1］ YAMAKAWA J, KOJIMA A, WATANABE K. A method of torque control for independent wheel drive vehicles on rough terrain ［J］. Journal of Terramechanics, 2007, 44: 371-381.
［2］ OSBORN R P, SHIM T. Independent control of all-wheel-drive torque distribution ［J］. Vehicle System Dynamics: International Journal of Vehicle Mechanics and Mobility, 2006, 44(7): 529-546.
［3］ 范晶晶,罗禹贡,张弦,等.多轴独立电驱动车辆驱动力的协调控制［J］. 清华大学学报: 自然科学版, 2011, 51(4): 478-481.
FAN Jing-jing, LUO Yu-gong, ZHANG Xian, et al. Coordinated control of driving torque for multi-axles independent driving vehicles ［J］. Journal of Tsinghua University: Science and Technology, 2011, 51(4): 478-481.
［4］ 李宗帅.基于驱动电机-负载电机试验平台的机械负载动力学模拟控制算法研究［D］.北京: 北京交通大学, 2007.
LI Zong-shuai. Control algorithm research on the dynamic emulation of mechanical loads based on the driver machine-load machine set ［D］. Beijing: Beijing Jiaotong University, 2007.
［5］ RODIC M, JEZERNIK K, TRLEP M. Dynamic emulation of mechanical loads: an advanced approach ［J］. Electric Power Applications， IEE Proceedings, 2006, 153 (2): 159-166.
［6］ 万振,高峰,丁靖,等.多轴车辆制动的动力学模型及制动性能分析［J］.中国机械工程, 2008, 19(3): 365-369.
WAN Feng, GAO Feng, DING Jing, et al. Dynamics model and braking performance analysis of multi-axle vehicle ［J］. China Mechanical Engineering,2008, 19(3): 365-369.
[1] LIU Gang, JIN Li qiang, WANG Yi. Vehicle stability control system based on active disturbance-rejection control strategy[J]. JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE), 2016, 50(12): 2289-2296.
[2] ZHU Shao peng, LIN Ding, XIE Bo zhen, YU Xiao li, HAN Song. Driving force hierarchical control strategy of electric vehicle[J]. JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE), 2016, 50(11): 2094-2099.
[3] YU Xiao-yong, WEI Yan-ding, HUANG Mang-mang, ZHOU Xiao-jun, YANG Chen-long. Precise timing of HLA-based hardware-in-loop simulation for vehicles[J]. JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE), 2012, 46(7): 1195-1200.
[4] WU Can,WANG Wei-rui,XU Bo-hou,LI Xing-lin,JIANG Wei-guang. Chaotic behavior of hysteretic suspension model
excited by road surface profile[J]. JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE), 2011, 45(7): 1259-1264.
[5] TUN Can, WANG Wei-Dui, CHEN Ying, et al. Simulation and validation of three-dimensional road surface spectrum[J]. JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE), 2009, 43(10): 1935-1938.