Please wait a minute...
J4  2013, Vol. 47 Issue (1): 94-101    DOI: 10.3785/j.issn.1008973X.2013.01.014
    
Simulation on noise reduction of tandem axial piston pump
utilizing indexing angle
XU Bing, ZHANG Jun-hui, YANG Hua-yong, YE Shao-gan
State Key Laboratory of Fluid Power Transmission and Control, Zhejiang University, Hangzhou 310027, China
Download:   PDF(0KB) HTML
Export: BibTeX | EndNote (RIS)      

Abstract  

 A noise reduction method of tandem axial piston pump utilizing indexing angle was proposed. A theoretical model of axial piston pump was conducted in order to analyze the theory on occurrence of noise excitation source. The comparison between simulation results and experimental results based on the test rig for measurement of flow ripple of axial piston pump showed that the mathematical model had high accuracy. Then the influences of indexing angle on the fluctuation rate and amplitude of out flow and torque applied on swash plate were investigated. The indexing angle was optimized to decrease the amplitude of excitation source to the greatest extent. The influences of load pressure and rotation speed of axial piston pump on the noise reduction effect of indexing angle were analyzed. Results indicated that the fluctuation rates of out flow and torque applied on swash plate were reduced respectively by more than 55% and 65% because of the superposition of waves that had a certain phase difference. The noise reduction effect was less sensitive to the operating parameters of pump. The power ratio of axial piston pump was not reduced meanwhile the noise excitation source was reduced.



Published: 01 January 2013
CLC:  TH 137.5  
Cite this article:

XU Bing, ZHANG Jun-hui, YANG Hua-yong, YE Shao-gan. Simulation on noise reduction of tandem axial piston pump
utilizing indexing angle. J4, 2013, 47(1): 94-101.

URL:

http://www.zjujournals.com/eng/10.3785/j.issn.1008973X.2013.01.014     OR     http://www.zjujournals.com/eng/Y2013/V47/I1/94


基于串联式轴向柱塞泵转位角降噪方法仿真

 提出基于串联式轴向柱塞泵转位角的降噪方案.建立轴向柱塞泵理论模型以分析轴向柱塞泵噪声的产生机理,对比仿真结果和从流量脉动测试试验台测试得到的实验结果,表明理论模型具有高精度.分析转位角对轴向柱塞泵出口流量脉动率、出口流量及斜盘转矩脉动幅值的影响.通过优化转位角,使其降低轴向柱塞泵噪声激振源强度达到效果最佳.分析轴向柱塞泵负载压力和工作转速对基于串联式轴向柱塞泵转位角的降噪效果的影响.研究结果表明,由于2个转子结构的激振源波形具有固定相位差,在波形叠加时产生平均效应,与同排量传统单轴向柱塞泵相比,具有转位角的串联式轴向柱塞泵的出口流量脉动降低55%以上、斜盘转矩脉动降低65%以上,且降噪效果受工作参数的影响相对较小.在激振源强度大幅度降低的同时,轴向柱塞泵的功率密度基本上不受影响.

[1]SEENIRAJ G K. Model based on optimization of axial piston machines focusing on noise and efficiency [D]. Indiana:Purdue University, 2009: 116.
[2]杨华勇, 马吉恩,徐兵. 轴向柱塞泵流体噪声的研究现状[J]. 机械工程学报,2008,44(2): 230-238.
YANG Hua-yong, Ma Ji-en, XU Bing. Current research on the study of axial piston pump fluid-borne noise [J]. Chinese Journal of Mechanical Engineering, 2008, 44(2): 230-238.
[3]SEENIRAJ G K, IVANTYSYNOVA M. Noise reduction in axial piston pump machines based on multi-parameter optimization [C]∥Proceedings of 4th FPNI-PhD Symposium. Sarasota, USA: [s.n.], 2006: 235-246.
[4] PALMEN A. Noise reduction of an axial piston pump by means of structural modification [J]. lhydraulic und Pneumatik, 2004, 48(4): 1-11.
[5]RICHARD D S. Silencer for hydraulic piston pump pressure pulsations [C]∥International Off-Highway and Powerplant Congress and Exposition, SAE Technical Paper Series. Milwaukee: SAE, 1991: 135-141.
[6]MA Ji-en, FANG You-tong, XU Bing, et al. The optimization of valve plate cross angle based on the pumping dynamics mode [J]. Journal of Zhejiang University: Science A, 2010, 11(3): 181-190.
[7]IVANTYSYNOVA M, SEENIRAJ G, HUANG C. Comparison of different valve plate designs focusing on oscillating forces and flow pulsation [C]∥Proceeding of the 9th Scandinavian International Conference on Fluid power. Link-ping: SICFP, 2005: 116.
[8]NAFZ T, MURRENHOFF H, RUDIK R. Active systems for noise reduction and efficiency improvement of axial piston pumps [C]∥Proceeding of Fluid Power and Motion Control. Bath: PTMC, 2008: 327-340.
[9]CHO J. Dynamic modeling and analysis for swash-plate type axial pump control utilizing indexing indexing valve plate [D]. Kansas: University of Missouri-Columbia, 2000: 19.
[10]SEENIRAJ G K, IVANTYSYNOVA M. Impact of valve plate design on noise, volumetric efficiency and control effort in axial piston pump [C]∥ Proceedings of International Mechanical Engineering Congress and Exposition. Chicago: ASME, 2006: 18.
[11] 那成烈. 从A4V看现代轴向柱塞泵抗噪声型配流盘的发展趋势 [J]. 甘肃工业大学学报, 1988,14(3):21-29.
NA Cheng-lie. Development trend of anti-noise valve plate of modern axial piston pump viewing from the A4V [J]. Journal of Gansu University of Technology, 1988, 14(3): 21-29.
[12] 马吉恩. 轴向柱塞泵流量脉动及配流盘优化设计研究[D]. 杭州:浙江大学, 2009: 99-115.
MA Ji-en. Study on flow ripple and valve plate optimization of axial piston pump [D]. Hangzhou: Zhejiang University, 2009: 99-115.
[13] IVANTYSYNOVA J, IVANTYSYNOVA M. Hydrostatic pumps and motors [M]. India: Akademia Books International, 2001: 346-425.    

[1] XU Bing, SONG Yue-chao, YANG Hua-yong. Optimization of swash-plate cross angle noise-reduction structure for swash-plate-type axial piston pump[J]. J4, 2013, 47(6): 1043-1050.
[2] XU Bing, LIU Wei, YANG Hua-yong, ZHANG Sheng-feng. Experiment study on flow compensation of electro-hydraulic flow
matching control system in hydraulic excavator
[J]. J4, 2012, 46(8): 1382-1389.
[3] LIU Wei, XU Bing, YANG Hua-yong, ZHU Xiao-jun. The characteristics of electrohydraulic flow matching control
systems for excavators based on LUDV multi-way valve
[J]. J4, 2012, 46(8): 1360-1368.
[4] ZHANG Bin, XU Bing, YANG Hua-Yong, et al. Study on control performance of digital piston pump based on virtual prototype technology[J]. J4, 2010, 44(1): 1-7.
[5] WANG Hang-Zhou, QIN Hua-Wei, YANG Can-Jun, et al. Fatigue life of PEEK poppet for deep-sea hydrothermal fluid sampling valve[J]. J4, 2010, 44(1): 14-18.