|
|
|
The effect of splitters layout at variable cross-section
inclined flue on AIG inlet flow field |
MAO Jian-hong, JIANG Xin-wei, ZHONG Yi, SONG Hao, WU Wei-hong,
PAN Shu-ping, GAO Xiang, LUO Zhong-yang, CEN Ke-fa |
| State Key Laboratory of Clean Energy Utilization, Zhejiang University, Hangzhou 310027, China |
|
|
|
Abstract To optimize the velocity distribution of AIG inlet, the design for splitters of variable cross-section flue at the AIG upstream was researched in a coal fire plant selective catalytic reaction(SCR) system. The velocity distribution of AIG upstream with variable crosssection flue was simulated by Fluent software, the effect of uniform splitters installation angle and different installation angle in variable cross-section flue on flow field of AIG inlet was researched and the change of flow field distribution was analyzed. The results show that in the condition of uniform installation angle, the guiding effect of splitters makes the velocity distribution at the two walls perform inverse trends, these two conteracting trends nullify the effect of the splitters and make the Cv value lowest, 15.4% at installation angle of 64°. However, the velocity distribution near two walls at the Z direction is still not uniform. Then a new optimization design method using different installation angle near two walls is put forward, the results show that the optimization design can improve the uniformity of velocity distribution near two walls and makes the Cv value decrease from 15.4% to 12.4%.
|
|
Published: 08 September 2011
|
|
|
变截面倾斜烟道导流板对AIG入口流场的影响
结合某实际电厂选择性催化还原（SCR）系统,对该系统喷氨格栅（AIG）上游变截面烟道处导流板的布置进行研究,以优化AIG入口的速度流场分布.基于fluent软件,对带有变截面烟道的AIG上游的速度流场进行数值模拟,研究变截面处导流板等角度布置方案和变角度布置方案对AIG入口流场的影响,并分析流场分布变化的原因.结果表明,在等角度布置的条件下,导流板的引流作用使Z向两壁面处的速度分布随角度变化呈现相反的趋势,并在布置角度为64°时标准偏差系数Cv值最低达到15.4%,但靠近两壁面处的速度分布仍不均匀.针对这种情况对导流板进行了变角度优化布置,结果发现,优化方案可以提高两壁面处速度分布以及AIG上游整体速度分布的均匀性Cv值从15.4%降至12.4%.
|
|
| ［1］ 闫志勇,骆仲泱,高翔,等.NH3选择性催化还原NO数学模型［J］.浙江大学学报：工学版,2007,41(12): 2093-2097.
YAN Zhiyong, LUO Zhongyang, GAO Xiang, et al. Mathematic model of selective catalytic reduction of NO with NH3 in experimentscale reactor ［J］. Journal of Zhejiang University: Engineering Science, 2007, 41(12): 2093-2097.
［2］ WANG Zhihua, ZHOU Junhu, ZHANG Yanwei, et al. Experiment and mechanism investigation on advanced reburning for NOx reduction: influence of CO and temperature ［J］. Journal of Zhejiang University Science: Life Science, 2005, 6B(3): 187-194.
［3］ 董建勋,李辰飞,王松岭,等.还原剂分布不均匀对SCR脱硝性能影响的模拟分析［J］.电站系统工程,2007,23(1): 21-24.
DONG Jianxun, LI Chenfei, WANG Songling, et al. Simulation of effect of nonuniformity of reagent distribution on SCR DeNOx performance ［J］. Power System Engineering, 2007, 23(1): 21-24.
［4］ 雷达,金保升.喷氨格栅处烟气速度场对高效SCR均流与还原剂混合性能的影响［J］.热能动力工程,2009,24(1): 113-119.
LEI Da, JIN Baosheng. Influence of the flue gas velocity field at an ammoniainjection grid on uniform flows and reducingagent mixing performance of a highefficiency SCR Device ［J］. Journal of Engineering for Thermal Energy & Power, 2009, 24(1): 113-119.
［5］ 张彦军,高翔,骆仲泱,等.SCR脱硝系统入口烟道设计模拟研究［J］.热力发电,2007,36(1)： 15-23.
ZHANG Yanjun, GAO Xiang, LUO Zhongyang, et al. Simulation study on design of inlet flue duct for SCR denitrification system ［J］. Thermal Power Generation, 2007, 36(1): 15-23.
［6］ KEVIN R, MEL A, MICHAEL V. Numerical modeling for design optimization of SCR applications ［C］∥ ICAC NOx Forum. Washington: ICAC, 2000: 1-6.
［7］ ADAMS B, CREMER M, VALENTINE J, et al. Use of CFD modeling for design of NOx reduction systems in utility boilers ［C］∥ Proceedings of IJPGC02. Phoenix: ASME Digital Library, 2002: 695-702.
［8］ 沈丹,仲兆平,过小玲.600MW电厂SCR烟气脱硝反应器内不同导流板的流场数值模拟［J］.电力环境保护.2007,23(1): 42-45.
SHEN Dan, ZHONG Zhaoping, GUO Xiaoling. Numerical simulation of different guide plates in selective catalytic reduction denitrification reactor of 600MW power plant ［J］. Electric Power Environmental, 2007, 23(1): 42-45. |
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
| |
Shared |
|
|
|
|
| |
Discussed |
|
|
|
|
