[1] BOOT R, RICHERT J, SCHUTTE H, et al. Automated test of ECUs in a hardwareintheloop simulation environment [C]∥ Proceedings of the 1999 IEEE International Symposium on Computer Aided Control System Design. Hawaii: IEEE, 1999: 587-594. [2] CEBI A, GUVENC L, DEMIRCI M, et al. A low cost, portable engine electronic control unit hardwareintheloop test system [C]∥ Proceedings of the 2005 IEEE International Symposium on Industrial Electronics. Dubrovnik, Croatia: IEEE, 2005: 293-298. [3] 朱澄, 龚依民, 陈志超. 汽车发动机曲轴和凸轮轴信号及汽缸压力信号模拟系统 [J].仪器仪表与检测技术, 2005, 24(6): 67-69. ZHU Cheng, GONG Yimin, CHEN Zhichao. Crankshaft signal and camshaft signal simulation based on a singlechip computer [J]. Instrumentation and Measurement, 2005, 24(6): 67-69. [4] 王宇明, 张付军, 刘波澜, 等. 便携式发动机工况模拟器的设计与开发[J]. 内燃机工程, 2006, 27(6): 63-67. WANG Yuming, ZHANG Fujun, LIU Bolan, et al. Design and exploitation of a mobile engine operation condition signal simulator [J]. Chinese Internal Combustion Engine Engineering, 2006, 27(6): 63-67. [5] 刘永涛. 电控发动机曲轴上止点数据采集系统设计 [D]. 大连: 大连理工大学, 2005: 20-21. LIU Yongtao. Design of crank’s top dead centre data acquisition system of electronic controlled engine [D]. Dalian: Dalian University of Techonlogy, 2005: 20-21. [6] 邹博文, 吴锋, 俞小莉, 等. 汽油机分组喷射和点火定时同步控制策略研究 [J]. 内燃机工程, 2006, 27(1): 15-17. ZOU Bowen, WU Feng, YU Xiaoli, et al. Research on timing synchronizing control strategy of grouping injection and ignition for gasoline engine [J]. Chinese Internal Combustion Engine Engineering, 2006, 27(1): 15-17. [7] 杨涤, 李立涛, 杨旭. 系统实时仿真开发环境与应用[M]. 北京: 清华大学出版社, 2002. [8] CAO Yunpeng, TENG Wanqing, ZHANG Huijie. Dynamic modeling and hardwareintheloop simulation testing for LPG engine [C]∥ Proceedings of the 2007 IEEE International Conference on Mechatronics and Automation. Harbin: IEEE, 2007: 2093-2098. [9] 赵亚明, 马旭东. Simulink/RTW下xPC Target的S函数驱动模块开发[J]. 机械工程与自动化, 2007, 6(3): 50-52. ZHAO Yaming, MA Xudong. Development of Sfunction driver model of xPC target under Simulink/RTW [J]. Mechanical Engineering and Automation, 2007, 6(3): 50-52. [10] 苗立东, 邹广德, 石沛林, 等. 基于xPC的汽车测控系统的开发[J]. 汽车工程, 2008, 30(3): 235-238. MIAO Lidong, ZHOU Guangde, SHI Peilin, et al. Development of automotive measure and control system based on xPC toolbox [J]. Automotive Engineering, 2008, 30(3): 235-238. |