|
|
|
| Distributed electro-thermal RF-LDMOS model |
| SUN Xiao-hong1,3, ZHANG Xiao-dong2, HU Shan-wen1,3, DAI Wen-hua4, GAO Huai1,3 |
1.National ASIC System Engineering Research Center, Southeast University, Nanjing 210096, China;
2.Suzhou Innotion Tech. Co., Ltd.,Suzhou 215123,China;3.High Frequency & High Power Device and Integrated
Technology Research Center, Research Institute of Southeast University at Suzhou, Suzhou 215123, China;
4.Infineon Technologies North America Corp, 18275 Serene Drive,Morgan Hill, CA 95037 United States |
|
|
|
Abstract To develop an accurate RF-LDMOS large signal model, temperature distribution across a multi-finger device was researched. Using the three dimensional image method, temperature distribution across a finger was easily calculated. Furtherly, for multiple fingers, lateral temperature distribution could be obtained under the superposition principle. A thermal matrix was used to describe the model and the thermal parameters were obtained by fitting with the calculation results. Compared with the traditional thermal model, this model can be used to characterize the heat transferring horizontally by using mutual thermal resistances between fingers and the average thermal resistance network is replaced by distributed thermal RC network to model the multi-fingers. The calculation results show that it can present the temperature distribution and predict the average thermal resistance of scaling devices more accurately．
|
|
Published: 24 November 2011
|
|
|
用于RF-LDMOS的分布式电热耦合模型
为建立精确的RF-LDMOS大信号模型,提出分布式电热耦合模型.通过采用三维镜像法简单计算单指条的温度分布,进一步使用叠加原理计算得到多指条温度的横向分布,此模型的解析式使用热矩阵方程来表示,通过对计算结果的拟合提取热模型参数.与传统热模型相比,此热模型通过使用指条之间的互热阻表征横向热流的相互作用,同时以分布的热RC网络为多指条建模,代替平均热电阻网络模型.计算结果表明,使用分布式电热耦合模型不仅能更精确反映温度的分布效应,而且可用于等比例缩放时更准确的预测平均热电阻.
|
|
| ［1］ 袁义生,钱兆明. 分析传导EMI的功率MOSFET建模［J］. 浙江大学学报：工学版,2003,37(2)：198-204．
YUAN Yisheng, QIAN Zhaoming. Modeling of power MOSFET for conducting EMI analysis ［J］. Journal of Zhejiang University: Engineering Science, 2003, 37(2):198-204．
［2］ COLLANTES J M, RAOUX J J, QUERE R. New measurementbased technique for RF LDMOS nonlinear modeling ［J］. IEEE Microwave and Guided Wave Letters, 1998, 8(10): 345-347．
［3］ CURTICE W R, PLA J A, BRIDGES D, et al. A new dynamic electrothermal nonlinear model for silicon RF LDMOSFETs［C］∥1999 IEEE MTTS Digest. Anaheim, CA, USA: IEEE, Piscataway, NJ, 1999: 419-422．
［4］ ROBLIN P, AKHTAR S, STRAHLER J. New nonquasistatic theory for extracting smallsignal parameters applied to LDMOSFETs ［J］. IEEE Microwave and Guided Wave Letters, 2000, 10(8): 322-324．
［5］ AKHTAR S, ROBLIN P, STRAHLER J. Isothermal DC and microwave characterizations of power RF silicon LDMOS ［J］. IEEE Transactions on Electron Devices, 2001, 12(48):2785-2789．
［6］ HSU J T, QUOC L V. A rational formulation of thermal circuit models for electrothermal simulation part I: finite element method ［J］. IEEE Transactions on Circuits and SystemsI: Fundamental Theory and Applications, 1996, 43(9): 721-732．
［7］ FUKAHORI K, GRAY P R. Computer simulation of integrated circuits in the presence of electrothermal interaction ［J］. IEEE Transactions on SolidState Circuits, 1987, 11(6): 834-846.
［8］ LETURCQ P, DORKEL J M, NAPIERALSKI A, et al. A new approach to thermal analysis of powerdevices and circuits ［J］. IEEE Transaction on Electron Devices, 2002, 49(4): 679-68.
［9］ RINALDI N. Generalized image method with application to the thermal modeling of power devices ［J］. IEEE Transactions on Electron Devices, 1987, 34(5): 1147-1156． |
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
| |
Shared |
|
|
|
|
| |
Discussed |
|
|
|
|
