Please wait a minute...
浙江大学学报(工学版)
浙江大学学报(工学版)  2019, Vol. 53 Issue (1): 78-88    DOI: 10.3785/j.issn.1008-973X.2019.01.009
土木工程     
考虑轴重相关的随机车流荷载效应
李明1, 刘扬1, 杨兴胜2
1. 长沙理工大学 桥梁工程安全控制技术与装备湖南省工程技术研究中心, 湖南 长沙 410114;
2. 四川交通职业技术学院, 四川 成都 611130
Random vehicle flow load effect considering axle load
LI Ming1, LIU Yang1, YANG Xing-sheng2
1. Hunan Province Research Center for Safety Control Technology and Equipment of Bridge Engineering, Changsha University of Science and Technology, Changsha 410114, China;
2. Sichuan Vocational and Technical College of Communications, Chengdu 611130, China
 全文: PDF(3487 KB)   HTML
摘要：

为了给桥梁验算的设计荷载提供参考，基于宜泸高速WIM实测数据，分析随机车流参数尤其是轴重相关性. 应用MATLAB平台编制随机车流模拟程序，采用影响线法分析随机车流的荷载效应，探讨考虑轴重相关与不考虑时荷载效应的差别. 研究结果表明：轴重具有多峰分布的特点，轴重之间具有较强的相关性，当模拟随机车流时，若不考虑车辆参数的相关性，则会造成较大误差；采用非参数核密度估计-Copula方法，利用t-Copula函数作为连接函数的轴重联合分布函数，可以较准确地描述车辆轴重联合分布；考虑轴重相关情况下的荷载效应代表值比不考虑时高约45%，与实测车流荷载效应代表值更加接近；各车道随机车流对简支梁桥的荷载效应代表值差别不大，但均已超过现行规范公路-I级车道荷载的荷载效应，效应比最大值为1.34.
Abstract:

The random vehicle flow parameters especially axle load correlation were analyzed based on the measured data of YI LU highway WIM in order to provide reference for the design load of bridge checking computations. A random vehicle flow simulation program was worked out by MATLAB. The load effect of random vehicle flow was analyzed by the influence line method, and the difference of load effect between considering the axle load correlation and without considering was discussed. Results show that axle load has the characteristics of multimodal distribution. There is a strong correlation between axle loads. Greater error will be caused when simulating random vehicle flow without considering the axle load correlation. The joint distribution function of vehicle axle load can accurately describe the joint distribution of vehicle axle load by using the nonparametric kernel density estimation-Copula method and using the t-Copula function as the connection function. The load effect considering the axle load correlation is 45% bigger than without considering, and it is closer to the representative value of measured traffic load effect. There is no significant difference between representative values of the load effect of the each lane random vehicle flow on the simply-supported beam bridge. Representative values of the load effect have exceeded the load effect of the current specification highway level I lane load, and the maximum effect ratio is 1.34.
收稿日期: 2017-08-18 出版日期: 2019-01-07
CLC:  U441  
基金资助:

国家“973”重点基础研究发展规划资助项目（2015CB057701，2015CB057704，2015CB057705）；国家自然科学基金资助项目（51378081，51308071，51308073）；长沙理工大学桥梁工程领域开放基金资助项目（18KC01）
通讯作者: 刘扬,男,教授,博导.orcid.org/0000-0001-8683-9015.     E-mail: liuyangbridge@163.com
作者简介: 李明(1981-),男,博士,从事桥梁结构可靠度评估与安全控制研究.orcid.org/0000-0003-0335-2725.E-mail:20519271@qq.com
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
作者相关文章　　

引用本文:

李明, 刘扬, 杨兴胜. 考虑轴重相关的随机车流荷载效应[J]. 浙江大学学报(工学版), 2019, 53(1): 78-88.

LI Ming, LIU Yang, YANG Xing-sheng. Random vehicle flow load effect considering axle load. JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE), 2019, 53(1): 78-88.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2019.01.009    或    http://www.zjujournals.com/eng/CN/Y2019/V53/I1/78

[1] MAYRAI G. Development of a reliability-based deflection limit state for steel girder bridges[D]. New Jersey:The State University of New Jersey, 2004.
[2] CASTILLO E, MENÉNDEZ J M, SÁNCHEZ-CAMBRONERO S, et al. A hierarchical optimization problem:estimating traffic flow using Gamma random variables in a Bayesian context[J]. Computers and Operations Research, 2014, 41:240-251.
[3] JABARI S E, LIU H X. A stochastic model of traffic flow:theoretical foundations[J]. Transportation Research Part B:Methodological, 2012, 46(1):156-174.
[4] 余志武, 朱红兵, 蒋丽忠, 等. 公路桥梁车辆荷载随机过程模型[J]. 中南大学学报:自然科学版, 2011, 42(10):3131-3135 YU Zhi-wu, ZHU Hong-bing, JIANG Li-zhong, et al. Vehicles load stochastic process model of highway bridges[J]. Journal of Central South University:Science and Technology, 2011, 42(10):3131-3135
[5] 孙守旺, 孙利民. 基于实测的公路桥梁车辆荷载统计模型[J]. 同济大学学报:自然科学版, 2012, 40(2):198-204 SUN Shou-wang, SUN Li-min. Statistic model of vehicle loads for highway bridges[J]. Journal of TongJi University:Science and Technology, 2012, 40(2):198-204
[6] 郭彤, 李爱群, 赵大亮. 用于公路桥梁可靠性评估的车辆荷载多峰分布概率模型[J]. 东南大学学报:自然科学版, 2008, 38(5):763-766 GUO Tong, LI Ai-qun, ZHAO Da-liang. Multiple peaked probability vehicle load model for highway bridge reliability assessment[J]. Journal of Southeast University:Natural Science Edition, 2008, 38(5):763-766
[7] 宗周红, 李峰峰, 夏叶飞, 等. 基于WIM的新沂河大桥车辆荷载模型研究[J]. 桥梁建设, 2013, 43(5):29-36 ZONG Zhou-hong, LI Feng-feng, XIA Ye-fei, et al. Study of vehicle load models for Xinyi river bridge based on WIM data[J]. Bridge Construction, 2013, 43(5):29-36
[8] NOWAK A S, NASSIF H. Live load models based on WIM data[C]//Probabilistic Mechanics and Structural and Geotechnical Reliability. New York:ASCE, 2015.
[9] 梅刚, 秦权, 林道锦. 公路桥梁车辆荷载的双峰分布概率模型[J]. 清华大学学报:自然科学版, 2003, 43(10):1394-1396 MEI Gang, QIN Quan, LIN Dao-jin. Bi-model probabilistic model of highway and bridge vehicle loads[J]. Journal of Tsinghua University:Science and Technology, 2003, 43(10):1394-1396
[10] SKLAR A. Fonctions de repartition n dimensions et leurs marges[J]. Publication de l'Institut de Statistique de L Université de Paris, 1959(8):229-231.
[11] PAPAEFTHYMIOU G, KUROWICKA D. Using Copula for modeling stochastic dependence in power system uncertainty analysis[J]. IEEE Transactions on Power Systems, 2009, 24(1):40-49.
[12] 谢中华. MATLAB统计分析与应用:40个案例分析[M]. 北京:北京航空航天大学出版社, 2010.
[13] 公路桥梁车辆荷载研究课题组. 公路桥梁车辆荷载研究[R]. 北京:中交公路规划设计院, 1997. Research Group of Vehicle Loads. Research for Highway Bridge. Vehicle loads research for highway bridge[R]. Beijing:China Highway Planning and Design Institutes, 1997.
[14] 阮欣, 周军勇, 石雪飞. 桥梁汽车荷载响应的极值外推方法综述[J]. 同济大学学报:自然科学版, 2015, 43(9):1339-1346 RUAN Xin, ZHOU Jun-yong, SHI Xue-fei. Review on extreme extrapolation methods for bridge traffic load response[J]. Journal of Tongji University:Natural Science, 2015, 43(9):1339-1346
[15] 公路工程技术标准:JTG B01-2014[S]. 北京:中华人民共和国交通运输部, 2014.
[16] 公路工程技术标准:JTG B01-2003[S]. 北京:中华人民共和国交通运输部, 2003.
[1] 叶肖伟, 刘坦, 董传智, 陈斌. 基于卡尔曼滤波和中性轴位置的结构损伤识别[J]. 浙江大学学报(工学版), 2017, 51(10): 2012-2018.
[2] 陈嘉毅, 谢旭, 徐爱敏, 等. 大跨预应力混凝土箱梁锚固区局部应力研究[J]. J4, 2009, 43(6): 1077-1082.