Please wait a minute...
浙江大学学报(工学版)
J4  2012, Vol. 46 Issue (2): 199-205    DOI: 10.3785/j.issn.1008-973X.2012.02.003
电气工程     
感应耦合电能传输系统的设计
林宁, 姚缨英, 李玉玲, 高慧
浙江大学 电气工程学院,浙江 杭州 310027
Design of inductively coupled energy transfer system
LIN Ning, YAO Ying-ying, LI Yu-ling, GAO Hui
College of Electrical Engineering, Zhejiang University, Hangzhou 310027, China
 全文: PDF  HTML
摘要：

针对感应耦合电能传输系统(ICETS)的互感模型,提出设计ICETS的三要素法：即通过耦合系数、可分离变压器原副边自感比值和副边能量接收电路的品质因数三要素设计ICETS.该方法在谐振状态下,将ICETS的特性参数表示为三要素的函数,根据可分离变压器的传输效率和器件应力要求进行系统设计.论文分析比较ICETS的4种补偿电路,并以原边串联补偿、副边并联补偿（SP）电路为例,设计输出功率为100 W的ICETS样机.结果表明,用三要素法设计ICETS,可分离变压器效率高,补偿电容电压应力小，样机实验证明所提三要素法的正确性.
Abstract:

 According to mutual inductance model of inductively coupled energy transfer system (ICETS), a three-factor method was proposed for designing ICETS. In this method, coupling coefficient, primary and secondary selfinductance ratio of separable transformer, and quality factor of energy receiver circuit were  three factors, which were used to design ICETS. Characteristic parameters of the ICETS were expressed as functions of the three factors under resonant state. Based on transfer efficiency of separable transformer and requirement of device stress, the ICETS were designed. Characteristics of four different compensation circuits were analyzed and compared, the circuit with primary series compensation and secondary parallel compensation (SP) was selected, a prototype with output power 100 W was designed. Results show ICETS were layout by the three-factor method, High transfer efficiency of separable transformer and low voltage stress of compensation capacitor are obtained. Experiments of prototype verify the validity of the proposed three-factor method.
出版日期: 2012-03-20
:  TM 724  
基金资助:

国家自然科学基金资助项目（50707030）.
通讯作者: 姚缨英(1962—), 女, 教授, 博导.     E-mail: yingying_yao@zju.edu.cn
作者简介: 林宁(1985—), 男, 硕士, 从事无线电能传输的研究. E-mail: linn@zju.edu.cn
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　

引用本文:

林宁, 姚缨英, 李玉玲, 高慧. 感应耦合电能传输系统的设计[J]. J4, 2012, 46(2): 199-205.

LIN Ning, YAO Ying-ying, LI Yu-ling, GAO Hui. Design of inductively coupled energy transfer system. J4, 2012, 46(2): 199-205.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2012.02.003    或    http://www.zjujournals.com/eng/CN/Y2012/V46/I2/199

［1］ LIU X, HUI S Y. Optimal design of a hybrid winding tructure for planar contactless battery charging platform［J］. IEEE Transactions on Power Electronics, 2008, 23(1): 455-463.
［2］ WANG C S, STIELAU O H, COVIC G A. Design considerations for a contactless electric vehicle battery charger ［J］. IEEE Transactions on Industrial Electronics, 2005, 52(5): 1308-1314.
［3］ ARAI S, MIURA H, SATO F, et al. Examination of circuit parameters for stable high efficiency TETS for artificial hearts［J］. IEEE Transactions on Magnetics, 2005, 41(10): 4170-4172.
［4］ CHAN T S, CHEN C L. LLC resonant Converter for wireless energy transmission system with PLL control［C］∥ IEEE ICSET 2008. Singapore: \
[s. n.\], 2008: 136-139.
［5］ SERGEANT P, BOSSCHE A V D. Inductive coupler for contactless power transmission ［J］. IET Electric Power Applications, 2008, 2(1): 1-7.
［6］ WANG C S, STIELAU O H, COVIC G A. Investigating an LCL load resonant inverter forinductive power transfer applications ［J］. IEEE Transactions on Power Electronics, 2004, 19(4): 995-1002.
［7］ ECKLEBE A, LINDEMANN A. Analysis and design of a contactless energy transmission system with flexible inductor positioning for automatedguided vehicles［C］∥ IEEE IECON 2006. Paris: \
[s. n.\], 2006: 1721-1726.
［8］ 马皓,周雯琪. 电流型松散耦合电能传输系统的建模分析［J］. 电工技术学报: 2005, 20(10): 66-71.
MA Hao, ZHOU Wenqi. Modeling analysis of inductively coupled power transfer systems based on current source resonant converter［J］. Transactions of China Electrotechnical Society,2005, 20(10): 66-71.
［9］ 武瑛,严陆光,徐善纲. 新型无接触电能传输系统的稳定性分析［J］. 中国电机工程学报: 2004, 24(5): 63-66.
WU Ying, YAN Luguang, XU Shangang. Stability analysis of the new contactless power delivery system ［J］. Proceedings of the CSEE， 2004, 24(5): 63-66.
［10］ CHOI B, NHO I, CHA H, et al. Design and implementation of lowprofile contactless battery charger csing planar printed circuit board windings as energy transfer device ［J］. IEEE Transacions on Industrial Electronics, 2004, 51(1): 140-147.
［11］ ZHUO F, SHEN X, QIU Y, et al. Study of detachable transformer using FEM on contactless power transmission system［C］∥ IEEE PESC 2008. Rhodes: \
[s. n.\], 2008: 4333-4336.
［12］ TSAI C C, CHEN B S, TSAI C M. Design of wireless transcutaneous energy transmission system for totally artificial hearts ［C］∥ IEEE APCCAS. Tianjin: \
[s. n.\], 2000: 646-649.
［13］ VALTCHEV S, BORGES B, BRANDISHY K, et al. Resonant contactless energy transfer with improved efficiency ［J］. IEEE Transactions on Power Electronics, 2009, 24(3): 685-699.
［14］ NISHIMURA M, KAWAMURA A, KURODA G, et al. high efficient contactless power transmission system for the high speed trains［C］∥ IEEE PESC’05. Recife: \
[s. n.\], 2005: 547-553.
［15］ 张卫平. 开关变换器的建模与控制［M］. 北京: 中国电力出版社, 2006: 258.
No related articles found!