Please wait a minute...
浙江大学学报(工学版)
J4  2009, Vol. 43 Issue (7): 1273-1278    DOI: 10.3785/j.issn.1008-973X.2009.
力学与机械工程     
微型超声波电机定子振动特性有限元分析
王光庆
（浙江工商大学 信息与电子工程学院,浙江 杭州 310018）
Finite element analysis of vibration performances for micro-ultrasonic motor stator
 WANG Guang-Qiang
(College of Information and Electronics Engineering, Zhejiang Gongshang University, Hangzhou 310018, China)
 全文: PDF(911 KB)   HTML
摘要：

利用有限元法对齿状环形行波型微超声波电机定子的振动特性进行了计算分析.建立了定子弹性体和压电体耦合的有限元模型,利用SOLID45单元将定子编制成ANSYS有限元软件的宏文件,以便于改变定子尺寸并自动生成相应的有限元模型；探讨了不同结构参数对压电定子动态性能的影响,得到了各结构参数对压电定子模态频率的影响曲线.研究结果表明,定子弹性体与压电体之间的胶粘层对定子模态频率的影响很小,在分析过程中可以忽略；定子的振动主要以弯曲模态为主,其振动频率随压电陶瓷和定子环厚度的增加而增大,随定子齿高、齿数和内径的增加而减小.
Abstract:

The finite element (FEM) method was presented to analyze the vibration performances of the annular stator with teeth of the micro-ultrasonic motor (MUSM). The coupling FEM model of the elastic body and the piezoelectric body (PZT) of the stator was derived, and then a macro document of ANSYS software of the stator was created with SOLID45 elements to automatically generate an FEM model when the structure parameters of the stator were changed. The influences of the changes of the structure parameters on the dynamical performances of the stator were discussed. The mechanical characteristics of the contact surface between the stator and the rotator were executed by numerical analysis. The research results showed that the effect of the adhesive layer between the elastic body and the PZT to the stator performance was so little that it could be ignored, and the vibrating frequency increased with the increasing of the thickness of the PZT and the stator body, but it decreased with the increasing of the height, the number of the teeth and the inner radius of the stator．
出版日期: 2009-07-01
:  TM356  
基金资助:

浙江省教育厅资助项目(20070626);浙江省自然科学基金资助项目（Y1080037）
作者简介: 王光庆(1975-)，男，江西泰和人，讲师，博士，主要从事振动控制和压电超声波电机的研究.
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　

引用本文:

王光庆. 微型超声波电机定子振动特性有限元分析[J]. J4, 2009, 43(7): 1273-1278.

WANG Guang-Qiang. Finite element analysis of vibration performances for micro-ultrasonic motor stator. J4, 2009, 43(7): 1273-1278.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2009.    或    http://www.zjujournals.com/eng/CN/Y2009/V43/I7/1273

［1］ 陈永校, 郭吉丰. 超声波电机 ［M］. 杭州：浙江大学出版社, 1993.
［2］ LELETTY R, CLAEYSSEN F, GONNARD P, et al. Combined finite element-normal mode expansion methods for ultrasonic motor modeling ［C］ ∥ Proceedings of Ultrasonics Symposium. Cannes, France: IEEE, 1994, 531534．
［3］ KROME J W, WALLASCHEK J. Finite element models for the piezoelectric actuation in the ultrasonic trave-ling wave motors ［J］. Journal of Intelligent Material Systems and Structure, 1996, 7(2):157161．
［4］ 杨东平,马昊学,杨志刚, 等. 梳状齿环行压电振子振动的有限元分析［J］.压电与声光,2000,22(4):266269．
YANG Dong-ping, MA Hao-xue, YANG Zhi-gang, et al. Finite-element-method analyses of the ring-type piezoelectric vibrator with comb teeth［J］. Piezoelectrics and Acoustooptics, 2000, 22(4): 266269．
［5］ 曲建俊, 周铁英, 张志谦. 超声波电动机定子和转子接触状态的数值分析［J］. 机械工程学报, 2002, 38(3): 7478．
QU Jian-jun, ZHOU Tie-ying, ZHANG Zhi-qian. Numerical simulation of contact state of stator and rotor in ultrasonic motor［J］. Proceeding of the CSEE, 2002, 38(3): 7478．
［6］ 王光庆. 行波型超声波电机的若干关键问题研究［D］. 杭州：浙江大学,2006．
WANG Guang-qing. Researches on the several key problems the traveling-wave type ultrasonic motor［D］. Hangzhou: Zhejiang University, 2006．
［7］ 王光庆,沈润杰,郭吉丰. 预压力对超声波电机特性的影响研究［J］. 浙江大学学报: 工学版, 2007, 41 (3): 436440．
WANG Guang-qing, SHEN Run-jie, GUO Ji-feng. Researches on effects to ultrasonic motors performance of preload［J］. Journal of Zhejiang University: Engineering Science, 2007, 41 (3) : 436440．
No related articles found!