Please wait a minute...
Chinese Journal of Engineering Design  2009, Vol. 16 Issue (4): 281-286    DOI:
    
Research and application on multiple fault diagnosis strategy
 WANG  Zi-Ling1, XU  Ai-Qiang2, NIU  Shuang-Cheng2
1.Department of  Electronic and Information Engineering, Naval Aeronautical and Astronautical 
University, Yantai 264001, China; 2.Department of Scientific Research, 
Naval Aeronautical and Astronautical University, Yantai 264001, China
Download: HTML     PDF(415KB)
Export: BibTeX | EndNote (RIS)      

Abstract  Aiming at the problem that it is difficult to diagnose multiple faults by optimal single fault sequential test, a new sequential testing algorithm for multi-fault diagnosis based on optimal single fault test strategy is presented by employing the concepts of multi-fault ambiguity groups put forward by Grunberg etc. This algorithm takes the minimal hitting sets of multi-fault state sets as fault states to generate the optimal singlefault strategy. By taking the multifault state sets of each leaf node in decision-making tree as evaluating standards, system state can be determined, and then system diagnosis under the assumption of multiple faults is completed. Compared with the strategy of successively employing single-fault diagnosis, the efficiency of diagnosis is increased. Finally the real system on some active spacecraft was taken as an instance to demonstrate the validity of the strategy. 

Key wordsfault diagnosis      sequential testing algorithm      multiple-fault ambiguity group      minimal hitting set     
Published: 28 August 2009
Cite this article:

WANG Zi-Ling, XU Ai-Qiang, NIU Shuang-Cheng. Research and application on multiple fault diagnosis strategy. Chinese Journal of Engineering Design, 2009, 16(4): 281-286.

URL:

https://www.zjujournals.com/gcsjxb/     OR     https://www.zjujournals.com/gcsjxb/Y2009/V16/I4/281


基于多故障假设的诊断策略研究与应用

针对工程中最优单故障序贯测试难以隔离的多故障问题,利用Grunberg等人提出的多故障模糊组的概念,以最优单故障测试策略为基础,构造了一种多故障假设下的序贯测试算法.该算法以多故障状态集的最小碰集作为生成最优单故障策略的故障状态,生成最优单故障策略;以诊断决策树中各叶节点的多故障状态集为评判标准,确定系统的状态,完成多故障假设下的系统故障诊断;与连续使用单故障策略的方法相比,该方法提高了测试效率.以某型机载电子设备为例给出算例分析,验证了该算法隔离多故障的有效性.

关键词: 故障诊断,  序贯测试,  多故障模糊组,  最小碰集 
[1] Chao JI,Liang WANG,Xiao-jing WANG,Xiao-bing LI,Wen CAO. Design of cable tunnel fault warning system based on MSSA-SVM[J]. Chinese Journal of Engineering Design, 2023, 30(1): 109-116.
[2] WU Guo-pei, YU Yin-quan, TU Wen-bing. Review of research on fault diagnosis of permanent magnet synchronous motor[J]. Chinese Journal of Engineering Design, 2021, 28(5): 548-558.
[3] SHANG Zhi-wu, ZHOU Shi-qi. Research on micropipetting technology based on image monitoring[J]. Chinese Journal of Engineering Design, 2021, 28(4): 495-503.
[4] NI Hong-qi, JIN Chi, FENG Fei. Development of fault diagnosis system for corrugated compensator[J]. Chinese Journal of Engineering Design, 2019, 26(3): 354-363.
[5] MA Tian-bing, WANG Xiao-dong, DU Fei, WANG Xin-quan. Fault diagnosis for rigid guide based on GA-SVM[J]. Chinese Journal of Engineering Design, 2019, 26(2): 170-176.
[6] HU Yi-yao, ZHU Bin, ZHANG Wei, HE Wei, SHEN Ping-sheng. Design and implementation of knowledge base building tool software[J]. Chinese Journal of Engineering Design, 2018, 25(4): 367-373.
[7] LI Xiao-huo, WENG Zheng-yang, QIANG Ya-sen, SHI Shang-wei, LI Yan. Fault diagnosis of hydraulic breaking hammer based on Fruit Fly Algorithm optimized fuzzy RBF neural network[J]. Chinese Journal of Engineering Design, 2015, 22(6): 540-545.
[8] LI Ling-Ling, JING Li-Ting, MA Dong-Juan, LI Zhi-Gang. Improved evidence theory and its application in fault diagnosis of power system[J]. Chinese Journal of Engineering Design, 2012, 19(6): 485-488.
[9] HAN Hai-tao,MA Hong-guang,HAN Kun,ZHENG Geng-le. Multitone stimulus signal design for identifying volterra frequency domain kernels[J]. Chinese Journal of Engineering Design, 2012, 19(2): 123-127.
[10] HAO Zhi-Yong, LIU Wei, XIA Wei, YAN Chuang. Fault diagnosis of the fan with air suction based on BP neural network[J]. Chinese Journal of Engineering Design, 2012, 19(1): 57-60.
[11] HAN Hai-Tao, MA Hong-Guang, LI Fei, ZHANG Jia-Liang-. Research on nonlinear system based on output frequency response functions[J]. Chinese Journal of Engineering Design, 2011, 18(5): 373-376.
[12] GUO Yu-Xiu, NI Xiao-Hong, WANG Yu-Tian. Study on the fault diagnosis of rolling mills based
on the chaos weak signal detection method
[J]. Chinese Journal of Engineering Design, 2011, 18(3): 218-221.
[13] WANG Cheng-Gang, WANG Xue-Wei, YANG Zhi-Yong, ZENG Ru-Wei. Study on correlation algorithm of failure mode rates in testability modeling[J]. Chinese Journal of Engineering Design, 2009, 16(4): 252-255.
[14] CHEN Yong, LIANG Jun. Slide—m odel M PCA approach with applications in fault detecting of m ultiVariable nonlinear process[J]. Chinese Journal of Engineering Design, 2003, 10(3): 131-135.
[15] CHEN Yong, LIANG Jun, LU Hao. Monitoring and fault diagnosis based on PCA for multivariable control system[J]. Chinese Journal of Engineering Design, 2002, 9(5): 257-260.