Please wait a minute...
Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering)  2016, Vol. 17 Issue (7): 525-540    DOI: 10.1631/jzus.A1600238
Articles     
Time- and stress-dependent model for predicting moisture retention capacity of high-food-waste-content municipal solid waste: based on experimental evidence
Hui Xu, Liang-tong Zhan, He Li, Ji-wu Lan, Yun-min Chen, Hai-yan Zhou
MOE Key Laboratory of Soft Soils and Geoenvironmental Engineering, Zhejiang University, Hangzhou 310058, China; Shanghai Laogang Wastes Disposal Co., Ltd., Shanghai 201302, China
Download:     PDF (0 KB)     
Export: BibTeX | EndNote (RIS)      

Abstract  Moisture retention capacity (MRC) is a key parameter for the prediction of leachate production of a municipal solid waste (MSW) pile. In this paper, five sets of laboratory tests were conducted in compression cells to characterize the variation of MRC with degradation time and overburden stress. Set A was conducted on the fresh high-food-waste-content (HFWC)-MSW under different degradation conditions and a sustained stress; Set B was on the fresh HFWC-MSW by alternation of degradation time and incremental stresses; Sets C, D, and E were on fresh HFWC-MSW, zero-food-waste-content (NFWC)-MSW, and decomposed MSW, respectively, being subjected to incremental stresses. The following findings were obtained from the test results: (1) The MRC of fresh HFWC-MSW decreased exponentially with degradation time under a sustained stress. The higher waste temperature or oxygen introduction would result in a faster declining of MRC. (2) The MRCs decreased linearly with a logarithmic increase of stress for all the MSW samples with different food waste contents. The MRC of HFWC-MSW was higher than that of NFWC-MSW under a given stress, and the decomposed MSW took the second place. (3) The variation of MRC appeared to be independent of stress path in terms of stress and degradation time. Based on the test results, the dependencies of the MRC of HFWC-MSW on degradation and stress were interpreted. Then, a time- and stress-dependent model was proposed for predicting the MRC of HFWC-MSW. The model was relatively simple and convenient for design purposes, and was verified by the measured data of leachate production at the pretreatment container of Laogang Incineration Plant. Finally, the model was developed to evaluate the dewatering effect of the HFWC-MSW pile. The strategy of combining the degradation-enhancing measures with stress-increasing measures is recommended in a rapid dewatering project.

Key wordsMoisture retention capacity (MRC)      Municipal solid waste (MSW)      Stress      Degradation     
Received: 14 March 2016      Published: 05 July 2016
CLC:  TU411  
Cite this article:

Hui Xu, Liang-tong Zhan, He Li, Ji-wu Lan, Yun-min Chen, Hai-yan Zhou. Time- and stress-dependent model for predicting moisture retention capacity of high-food-waste-content municipal solid waste: based on experimental evidence. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2016, 17(7): 525-540.

URL:

http://www.zjujournals.com/xueshu/zjus-a/10.1631/jzus.A1600238     OR     http://www.zjujournals.com/xueshu/zjus-a/Y2016/V17/I7/525

[1] Chih-Hung Chen, Hsuan-Teh Hu, Fu-Ming Lin, Hsin-Hsin Hsieh. Residual stress analysis and bow simulation of crystalline silicon solar cells[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2017, 18(1): 49-58.
[2] She-rong Zhang, An-kui Hu, Chao Wang. Three-dimensional inversion analysis of an in situ stress field based on a two-stage optimization algorithm[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2016, 17(10): 782-802.
[3] Xi-shu Wang, Xing-wu Guo, Yuzo Nakamura, Hui-hui Yang, Pan Pan. Evaluation of the critical stress of anodized coating-AZ91D substrate using SEM in-situ technology[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2016, 17(1): 65-75.
[4] Xiang-yu Shang, Guo-qing Zhou, Yong Lu. Stress-dependent undrained shear behavior of remolded deep clay in East China[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2015, 16(3): 171-181.
[5] Yong Zhang, Yan-yong Xiang. A semi-analytical method and its application for calculating the thermal stress and displacement of sparsely fractured rocks with water flow and heat transfer[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2015, 16(11): 922-934.
[6] Chun-xiao Zhan, Yi-hua Liu. Plane elasticity solutions for beams with fixed ends[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2015, 16(10): 805-819.
[7] Kun Xie, Xiang-xue Wang, Zheng-jie Liu, Ahmed Alsaedi, Tasawar Hayat, Xiang-ke Wang. Synthesis of flower-like α-Fe2O3 and its application in wastewater treatment[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2014, 15(8): 671-680.
[8] Zhong-ying Han, Xiao-guang Huang, Yu-guang Cao, Jin-quan Xu. A nonlinear cumulative evolution model for corrosion fatigue damage[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2014, 15(6): 447-453.
[9] Jian Zhou, Jia-jia Yan, Zheng-yi Liu, Xiao-nan Gong. Undrained anisotropy and non-coaxial behavior of clayey soil under principal stress rotation[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2014, 15(4): 241-254.
[10] Zeng-hui Zhao, Wei-ming Wang, Xin Gao. Evolution laws of strength parameters of soft rock at the post-peak considering stiffness degradation[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2014, 15(4): 282-290.
[11] Yuan-chun Liu, Yu-rong He, Jia-qi Zhu, Jie-cai Han, Dong-liang Quan. Numerical simulation of aerodynamic heating and stresses of chemical vapor deposition ZnS for hypersonic vehicles[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2014, 15(3): 185-196.
[12] Devi Chandra, Judha Purbolaksono, Yusoff Nukman, Haw-ling Liew, Singh Ramesh, Mohsen-abdel Hassan. Fatigue growth of a surface crack in a V-shaped notched round bar under cyclic tension[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2014, 15(11): 873-882.
[13] Wu-jun Chen, Jin-yu Zhou, Jun-zhao Zhao. Computational methods for the zero-stress state and the pre-stress state of tensile cable-net structures[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2014, 15(10): 813-828.
[14] Chuan-xun Li, Kang-he Xie. One-dimensional nonlinear consolidation of soft clay with the non-Darcian flow[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2013, 14(6): 435-446.
[15] Chun-yang Zhu, Ying-hua Zhao, Shuang Gao, Xiao-fei Li. Mechanical behavior of concrete filled glass fiber reinforced polymer-steel tube under cyclic loading[J]. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 2013, 14(11): 778-788.