Please wait a minute...
工程设计学报
工程设计学报  2001, Vol. 8 Issue (4): 191-194    
工程设计理论、方法与技术     
热轧钢坯喷号机的研制
 姜晓勇, 项占琴, 梁剑新
浙江大学生产工程研究所,浙江杭州310027
Research and Development of Hot Steel Rolling Printer
 JIANG  Xiao-Yong, XIANG  Zhan-Qin, LIANG  Jian-Xin
Institute of Manufacture Engineering, Zhejiang University, Hangzhou 310027, China
 全文: PDF(105 KB)   HTML
摘要： 介绍了计算机及PLC控制热轧钢坯喷号机的结构原理及控制系统,研究、开发了七段码喷号方式.喷号机系统能自动完成到位的检测、去氧化皮、喷号、清洗等工作.用水基耐高温涂料喷射,可以较低的成本完成喷号任务,这为进一步的推广应用创造了条件.
关键词： 热轧钢坯;  喷号机;  七段码喷号;  红外探头    
Abstract:  It' s an introduction to the configuration of the automatic printer and its control system,as well as a new printing method——“seven-segment dope jet”. The system performs position sensing, oxide-removing, numeral printing and self-washing automatically. Making use of water based dope reduces the cost of the printer, the system turns out to be stable and accurate, which is fatal before it can be widely used.
Key words:  hot steel rolling printer    seven-segment dope jet    infrared detector
出版日期: 2001-12-15
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　
姜晓勇
项占琴
梁剑新

引用本文:

姜晓勇, 项占琴, 梁剑新. 热轧钢坯喷号机的研制[J]. 工程设计学报, 2001, 8(4): 191-194.

JIANG Xiao-Yong, XIANG Zhan-Qin, LIANG Jian-Xin. Research and Development of Hot Steel Rolling Printer[J]. Chinese Journal of Engineering Design, 2001, 8(4): 191-194.

链接本文:

https://www.zjujournals.com/gcsjxb/CN/    或    https://www.zjujournals.com/gcsjxb/CN/Y2001/V8/I4/191

No related articles found!