Please wait a minute...
工程设计学报
工程设计学报  2005, Vol. 12 Issue (5): 308-312    
工程设计理论、方法与技术     
微量润滑条件下Si3N4陶瓷白口铸铁的摩擦学性能研究
 项忠霞1, 董刚2, 沈兆光1, 林彬1
1.天津大学 机械工程学院，天津 300072；
2.天津职业大学 机电学院，天津 300402
Research on tribology property of Si3N4 ceramic and chilled iron under oilless lubrication
 XIANG  Zhong-Xia1, DONG  Gang2, SHEN  Zhao-Guang1, LIN  Bin1
1. School of Mechanical Engineering, Tianjin University, Tianjin 300072, China;
2. School of Mechatronics, Tianjin Professional College, Tianjin 300402, China
 全文: PDF(517 KB)   HTML
摘要： 采用块盘式摩擦磨损试验方法，在MG200摩擦磨损试验机上对Si3N4陶瓷白口铸铁摩擦副进行了微量润滑条件下的摩擦磨损试验，同时根据试件的SME照片和能谱成分分析了摩擦磨损机理，为陶瓷材料的制备及减少磨损提供理论依据。试验和分析结果表明：微量润滑条件下Si3N4陶瓷的磨损率和摩擦系数要比干摩擦条件下小得多；Si3N4陶瓷的磨损率随载荷的增大而增大，滑动速度对磨损率的影响要小于载荷对其的影响；Si3N4陶瓷白口铸铁的摩擦系数随速度的增大而减小，载荷的变化对摩擦系数的影响不大；Si3N4陶瓷的磨损是化学磨损、机体物质脱落和磨粒磨损共同作用的结果，其中化学磨损起主导作用。
关键词： Si3N4陶瓷;  白口铸铁;  微量润滑;  干摩擦;  摩擦系数;  磨损率    
Abstract: A series of tests on friction and wear of Si3N4 ceramic and chilled iron under oilless lubrication were conducted on MG200 Friction Wear Machine by adopting blockondisc wear test method, during which the values of wear rate and friction coefficient of Si3N4 ceramic and chilled iron were achieved. Additionally the friction and wear behaviors were analyzed through SME images and percentage of different chemical elements distributed on friction surface. The result indicated wear rates of Si3N4 ceramic and friction coefficient between Si3N4 ceramic and chilled iron under oilless lubrication are much less than wear rates and friction coefficient under dry friction condition. Wear rate of Si3N4 ceramic rose with the increase of loads between Si3N4 ceramic and chilled iron while the effect of relative sliding speed on wear rate of Si3N4 ceramic is not as significant as that of load. For the friction coefficient between Si3N4 ceramic and chilled iron, it decreased with the increase of relative sliding speed and the change on load had little influence on it. Wear of Si3N4 ceramic was caused by interaction of chemical wear, abrading wear and particle’s peeling off, among which the chemical one was dominant.
Key words: Si3N4 ceramic    chilled iron    oilless lubrication    dry friction    friction coefficient    wear rate
出版日期: 2005-10-28
基金资助:

天津市高等学校科技发展基金资助项目(20030723)
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　
项忠霞
董刚
沈兆光
林彬

引用本文:

项忠霞, 董刚, 沈兆光, 林彬. 微量润滑条件下Si3N4陶瓷白口铸铁的摩擦学性能研究[J]. 工程设计学报, 2005, 12(5): 308-312.

XIANG Zhong-Xia, DONG Gang, SHEN Zhao-Guang, LIN Bin. Research on tribology property of Si3N4 ceramic and chilled iron under oilless lubrication[J]. Chinese Journal of Engineering Design, 2005, 12(5): 308-312.

链接本文:

https://www.zjujournals.com/gcsjxb/CN/    或    https://www.zjujournals.com/gcsjxb/CN/Y2005/V12/I5/308

[1] 黄泽好, 张振华, 黄旭, 雷伟. 鼓式制动器制动不稳定时变特性分析[J]. 工程设计学报, 2019, 26(6): 714-721.
[2] 李松梅, 邱世凯. 三叉杆式万向联轴器的平均传动效率分析[J]. 工程设计学报, 2019, 26(4): 379-384.
[3] 姚永琪, 郭乙木, 朱凌, 汪小芳. 高速切削时摩擦系数对切削影响的数值模拟[J]. 工程设计学报, 2004, 11(1): 31-36.