Please wait a minute...
工程设计学报
工程设计学报  2016, Vol. 23 Issue (4): 385-390    DOI: 10.3785/j.issn.1006-754X.2016.04.014
通用零部件设计     
基于抗振动疲劳的薄板加筋设计分析
刘文光, 林炜彦, 颜龙, 舒斌
南昌航空大学 航空制造工程学院, 江西 南昌 330063
Analysis on stiffen design of a skin plate by anti-vibration fatigue
LIU Wen-guang, LIN Wei-yan, YAN Long, SHU Bin
School of Aeronautic Manufacturing Engineering, Nanchang Hangkong University, Nanchang 330063, China
 全文: PDF(2257 KB)   HTML
摘要：

振动是航空薄板常见的载荷形式，通常采用加强筋来减小振动幅度，从而提高薄板寿命.研究薄板的抗振动疲劳加筋方法，探讨加强筋与板的连接方式以及加强筋的布置方向对薄板振动与疲劳的影响机制.首先，基于振动理论和板筋变形协调条件，建立加筋薄板的运动方程.然后，建立铆接、点焊和滚焊连接形式的加筋薄板有限元模型，探讨连接单元的动力学建模方法；在此基础上，研究连接形式和加筋安装方向对薄板结构动力学特性的影响；最后，结合动力响应分析探讨板筋连接方式和加筋安装方向对疲劳寿命的影响.研究结果表明，双向加筋薄板在低频振动时刚度高于单向加筋薄板，双向加筋有利于提高结构抗疲劳强度，铆接单向加筋薄板的振动疲劳寿命最短.
关键词： 加筋薄板;  动力学特性;  振动疲劳    
Abstract:

Vibration is one of the common loading types to aircraft plate.It is frequent to use the stiffen method to reduce the vibration amplitude so as to improve the vibration fatigue life of thin plate.In order to study the anti-vibration fatigue method by stiffen,it is aimed to reveal the impacts of connecting method and connecting direction of stiffen on the vibration fatigue life of a thin plate.Firstly,the kinetic equation of a stiffen plate was set up by combining the vibration theory of thin plate and the deformation compatibility condition of plate and stiffen.Then the typical stiffen plate was employed to study the modeling method of the link element between the plate and the stiffen beam via building up the finite element dynamics model of stiffened plate structure with rivet,spot-weld and rolling-weld.Therefore,the dynamics properties of single-direction and double-direction stiffened plate were studied and the impacts of stiffen on the vibration properties were discovered.Finally,the fatigue life of the structure was estimated based on the analysis of the dynamic response.Meanwhile,the influence of the connection mode and the direction of the connection on the fatigue life was studied.Results indicate that the stiffness of the single-direction stiffened plate is higher than that of the double-direction stiffened plate.Double-direction stiffened plate is benefit to the strength of vibration fatigue for the thin plate and the fatigue life of the rivet stiffened plate is the minimum.
Key words: stiffened plate    dynamics characteristic    vibration fatigue
收稿日期: 2015-09-24 出版日期: 2016-08-28
CLC:  V215.4  
基金资助:

国家自然科学基金资助项目（51565039）.
作者简介: 刘文光(1978—),男,江西泰和人,副教授,博士,从事飞行器结构动力学及疲劳寿命预测研究,E-mail:liuwg14@nchu.edu.cn.http://orcid.org//0000-0002-4218-0287
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　
刘文光
林炜彦
颜龙
舒斌

引用本文:

刘文光, 林炜彦, 颜龙, 舒斌. 基于抗振动疲劳的薄板加筋设计分析[J]. 工程设计学报, 2016, 23(4): 385-390.

LIU Wen-guang, LIN Wei-yan, YAN Long, SHU Bin. Analysis on stiffen design of a skin plate by anti-vibration fatigue. Chinese Journal of Engineering Design, 2016, 23(4): 385-390.

链接本文:

https://www.zjujournals.com/gcsjxb/CN/10.3785/j.issn.1006-754X.2016.04.014    或    https://www.zjujournals.com/gcsjxb/CN/Y2016/V23/I4/385

[1] 刘文光,陈国平,贺红林,等.结构振动疲劳研究综述[J].工程设计学报,2012,19(1):1-8. LIU Wen-guang,CHEN Guo-ping,HE Hong-lin,et al.Review of studying on vibration fatigue [J].Chinese Journal of Engineering Design,2012,19(1):1-8.
[2] 周江贝,孙秦.复合材料薄壁加筋结构局部稳定性分析的谱单元法[J].机械科学与技术,2014,33(2):1912-1915. ZHOU Jiang-bei,SUN Qin.The spectral element method of the local stability for the stiffened thin-walled structure of the composite [J].Mechanical Science and Technology for Aerospace Engineering,2014,33(2):1912-1915.
[3] 杨竣博,宋笔锋,钟小平.曲加筋条壁板优化设计研究[J].机械强度,2014,36(6):904-910. YANG Jun-bo,SONG Bi-feng,ZHONG Xiao-ping.Research on optimal design of curvilinearly stiffened panels [J].Journal of Mechanical Strength,2014,36(6):904-910.
[4] 郑洁,任善.复合材料加筋壁板稳定性分析方法研究[J].航空科学技术,2015,26(3):44-48. ZHENG Jie,REN Shan.Study on stability analysis method of composite stiffened plates [J].Aeronautical Science and Technology,2015,26(3):44-48.
[5] 王富生,张钧然,郑涵天,等.复合材料加筋壁板鸟撞动响应分析[J].振动与冲击,2013,32(4):6-10. WANG Fu-sheng,ZHANG Jun-ran,ZHENG Han-tian,et al.Dynamic response of a composite reinforced panel to bird strike [J].Journal of Vibration and Shock,2013,32(4):6-10.
[6] SAKANO M,WAHAB M A.Fatigue strength of welded transverse stiffener joints under variable amplitude loading[J].International Journal of Pressure Vessels and Piping,1998,75(15):1037-1045.
[7] 刘文光,贺红林.单向双筋板结构件共振疲劳试验及分析[J].实验力学,2012,27(3):361-367. LIU Wen-guang,HE Hong-lin.Resonance fatigue testing and analysis of one-way double-stiffened plate [J].Journal of Experimental Mechanics,2012, 27(3):361-367.
[8] 刘文光.考虑结构裂纹扩展的振动疲劳寿命计算方法[J].振动工程学报,2012,25(1):79-82. LIU Wen-guang.Calculation method of vibration fatigue life with structure crack growth [J].Journal of Vibration Engineering,2012,25(1):79-82.
[9] 顾超林.加筋板连接件的振动疲劳仿真研究[D].南京:南京航空航天大学航空宇航学院,2009:1-69. GU Chao-lin.Research on vibration fatigue of stiffened aluminum alloy panel [D].Nanjing:Nanjing University of Aeronautics and Astronautics,College of Aerospace Engineering,2009:1-69.
[10] 廉政.典型结构件的振动疲劳分析[D].南京:南京航空航天大学航空宇航学院,2010:1-55. LIAN Zheng.Vibration fatigue analysis of typical structure [D].Nanjing:Nanjing University of Aeronautics and Astronautics,College of Aerospace Engineering,2010:1-64.
[11] 王佳莹.考虑温度影响下结构振动疲劳寿命估算[D].南昌:南昌航空大学航空制造工程学院,2012:1-56. WANG Jia-ying.Estimation of structural vibration fatigue life with temperature involved [D].Nanchang:Nanchang Hangkong University,School of Aeronautic Manufacturing Engineering,2012:1-56.
[12] 濮良贵,纪名刚.机械设计[M].7版.北京:高等教育出版社,2001:1-210. PU Liang-gui,JI Ming-gang.Design of machinery[M]. 7th ed. Beijing:Higher Education Press,2001:1-210.
[13] 肖寿庭,杜修德.LY12CZ铝合金悬臂梁动态疲劳 S—N曲线的试验测定[J].机械强度,1995,17(3):21-24. XIAO Shou-ting,DU Xiu-de.Measurement of a dynamic fatigue S-N curve for LY12CZ Al alloy cantilever specimens [J].Journal of Mechanical Strength,1995,17(3):21-24.
[1] 贺红林, 江涛, 付磊, 刘浩康. 双十字压电振子同型弯振模态驱动的平面超声电机[J]. 工程设计学报, 2019, 26(5): 594-602.