Please wait a minute...
工程设计学报
工程设计学报  2011, Vol. 18 Issue (3): 222-227    
机电一体化和智能化系统设计理论、方法与技术     
胶囊微机电无线能量传输系统设计与试验研究
 刘修泉1, 李艳红1, 薛凯峰2, 黄 平2
1. 广州番禺职业技术学院 机械与电子系, 广东 广州 511483; 2. 华南理工大学 机械与汽车工程学院,广东 广州 510640
The design and experimental research of capsule endoscope 
wireless energy transmission
 LIU  Xiu-Quan1, LI  Yan-Hong1, XUE  Kai-Feng2, HUANG  Ping2
1. Department of Mechanical and Electronic, Guangzhou Panyu Polytechnic, Guangzhou 511483, China;
2. School of Mechanical and Automotive Engineering, South China University of Technology, Guangzhou 510640, China
 全文: PDF(1907 KB)   HTML
摘要： 首先介绍了胶囊微机电无线电能传输系统的原理和系统的基本构成,然后设计了以松耦合变压器为基础的无线电能供给系统,采用互相正交的二维线圈来接收能量并进行试验研究.结果表明：不管体内微机电系统处在何种位置和姿态,都可以有效接收能量,特别在初级绕组窗口宽度内,次级绕组接收能量可以高达110~240 mW．最后研制了胶囊微机电无线能量传输系统样机,可以成功驱动胶囊微机电系统工作,表明了该胶囊无线电能传输系统设计是可行的．
关键词： 无线能量传输;  胶囊;  微机电系统    
Abstract: The principle of a wireless power transmission(WPT) and the basic constitutions of the capsule micro-electro-mechanical systems(MEMS) were introduced. Then, based on a loosely coupling transformer, the WPT system of the capsule MEMS were designed. The secondary receiving windings composed of two orthogonal coils received power after experiment research. The results show that regardless of the capsule location, the secondary can receive effective power, up to 110-240 mW. At last the luminous capsule model prototype was made, and the luminous capsule can work by WPT. It shows the WPT system is feasible．
Key words: wireless power transmission    capsule    MEMS
出版日期: 2011-06-28
:  TH 39  
基金资助:

广东省自然科学基金资助项目(10151148301000001)
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　
刘修泉
李艳红
薛凯峰
黄平

引用本文:

刘修泉, 李艳红, 薛凯峰, 黄 平. 胶囊微机电无线能量传输系统设计与试验研究[J]. 工程设计学报, 2011, 18(3): 222-227.

LIU Xiu-Quan, LI Yan-Hong, XUE Kai-Feng, HUANG Ping. The design and experimental research of capsule endoscope 
wireless energy transmission[J]. Chinese Journal of Engineering Design, 2011, 18(3): 222-227.

链接本文:

https://www.zjujournals.com/gcsjxb/CN/    或    https://www.zjujournals.com/gcsjxb/CN/Y2011/V18/I3/222

[1] 李俊, 应济, 周良兴. 基于MEMS的静电微泵建模与仿真[J]. 工程设计学报, 2009, 16(1): 63-67.
[2] 张 炜,陈英俊,黄 平. 胶囊机器人在黏液中旋进运动的研究[J]. 工程设计学报, 2007, 14(2): 89-96.
[3] 张炜, 李洁, 陈英俊, 黄平. 被动式胶囊内窥镜在小肠内运动的力学分析[J]. 工程设计学报, 2006, 13(5): 350-354.
[4] 杨涛, 何叶, 魏东梅, 李磊民. 微机电器件的稳健设计[J]. 工程设计学报, 2004, 11(3): 124-127.