一种机械系统动力学响应分析方法

工程设计学报

2008, Vol. 15

Issue (1): 1-5

工程设计理论、方法与技术

一种机械系统动力学响应分析方法

罗玉峰^1，2, 刘治志¹, 石志新¹, 杨廷力³

1.南昌大学机电工程学院,江西南昌 330031； 2.新余高等专科学校,江西新余 338031；
3.中国石化金陵石化公司,江苏南京210037

New dynamic analysis method for mechanism

LUO Yu-Feng^1,2, LIU Zhi-Zhi¹, SHI Zhi-Xin¹, YANG Ting-Li³

1. School of Mechanical and Electrical Engineering, Nanchang University, Nanchang 330031, China；
2.Xinyu College, Xinyu 338031, China； 3. Jinling Petrochemical Corporation, Nanjing 210037, Chin

全文: PDF(356 KB) HTML

摘要： 为了动力学响应分析的通用性及简便性,提出一种新的动力学响应分析方法.将机械系统分解成有序单开链单元,按其正序首先在约束度小于0的单元进行虚拟赋值,然后在其他单元依次进行运动分析,最后可得到维数最低的运动学方程.基于虚功原理导出动力学响应方程通式,对广义速度与广义加速度特殊赋值后通过序单开链法可求出响应方程的各系数,从而确定动力学响应方程.该动力学响应方程的维数等于机械系统自由度,形式简洁,便于求解,平面三自由度并联机构的实例表明了该方法的有效性.

关键词： 机械系统; 动力学响应; 序单开链

Abstract: A new dynamic analysis method is proposed for increasing the universality and simplicity of dynamic response analysis. Mechanisms were decomposed into a series of ordered-SOCs(single opened chains). According to their forward order, firstly put imaginary inputs to the SOCs whose constraint factor is below zero, and then the kinematic equations with minimum dimension can be obtained after performing kinematic analysis on other ordered-SOCs. The universal dynamic analysis equations were deduced based on the principle of virtual work. Given the special value of generalized velocity and generalized acceleration, all the coefficients of the equations can be computed using the ordered-SOCs method, therefore the dynamic analysis equations can been acquired. The dynamic analysis equations are compact, and their dimensions are equal to the freedom degree of the mechanism. The numerical example of a 3-degree of freedom planar parallel mechanism has demonstrated its efficiency.

出版日期: 2008-02-28

	服务
	把本文推荐给朋友
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	罗玉峰
	刘治志
	石志新
	杨廷力

引用本文:

罗玉峰, 刘治志, 石志新, 杨廷力. 一种机械系统动力学响应分析方法[J]. 工程设计学报, 2008, 15(1): 1-5.

LUO Yu-Feng, LIU Zhi-Zhi, SHI Zhi-Xin, YANG Ting-Li. New dynamic analysis method for mechanism[J]. Chinese Journal of Engineering Design, 2008, 15(1): 1-5.

链接本文:

https://www.zjujournals.com/gcsjxb/CN/ 或 https://www.zjujournals.com/gcsjxb/CN/Y2008/V15/I1/1

null

[1]	连晋毅, 史青录, 孙大刚. 机电相似系统的模型转换与可靠性分析[J]. 工程设计学报, 2010, 17(6): 410-414.
[2]	贺向东,张义民,闻邦椿. 多失效模式机械系统可靠性稳健设计方法研究[J]. 工程设计学报, 2009, 16(2): 81-83.
[3]	何竞飞, 高志雄, 聂荣光, 浮志强. 挠性带传动对速度波动影响的计算机仿真[J]. 工程设计学报, 2007, 14(4): 308-314.
[4]	黎水平, 贺建军. 基于分解的复杂机械系统多级设计方法[J]. 工程设计学报, 2006, 13(3): 129-134.
[5]	郭吉丰, 楼少敏, 刘晓. 微系统用超声微电机的研究现状和发展趋势[J]. 工程设计学报, 2002, 9(4): 173-177.

Viewed

Full text

Abstract

Cited

Shared

Discussed