Experimental investigations were conducted on the process of combustion and explosion vent in a 200 mm (diameter)×400 mm (length) vertical cylindrical vessel. When CH₄-air mixture gases were used and the vent diameter was 55 mm, conditions of Φ (equivalent ratio)=0.8, Φ=1.0 and Φ=1.3 and two ignition positions (at the cylinder center and bottom) were selected. The venting processes and the correlated factors are discussed in this paper.

Platinum/carbon catalyst is one of the most important catalysts in hydrogenation of ortho-nitrochlorobenzene to 2,2′-dichlorohydrazobenzene. The preparation process and the supports of catalysts are studied in this paper. Raw materials and preparation procedure of the activated carbon have great influences on the compositions and surface structure of platinum/carbon catalysts. Platinum catalysts supported on activated carbon with high purity, high surface area, large pore volume and appropriate pore structure usually exhibit higher activities for hydrogenation of ortho-nitrochlorobenzene to 2,2′-dichlorohydrazobenzene. The catalyst prepared from H₂PtCl₆ with pH=3 shows greater catalytic performance than those prepared under other conditions.

To determine the pharmacokinetics of gemcitabine (2′,2′-difluorodeoxycytidine) in Chinese non-small-cell lung cancer (NSCLC) patients. Six study subjects were administered gemcitabine at a fixed dose rate of 10 mg/m² per min (1200 mg/m², two hours infusion), and carboplatin and plasma gemcitabine concentrations were measured by ion-pair reversed-phase high-performance liquid chromatography (HPLC). 3P97 Pharmaceutical Kinetics Software was used for the calculation of pharmacokinetic parameters. The obtained mean parameters, elimnation half life (t_1/2) (10.67±3.38 min), area under the curve (AUC) (7.55±1.53 (µg·h)/ml), and clearance (CL) (3940.05±672.08 ml/min), were consistent with those reported in literature. The hematologic toxicology result showed that the regimen was effective on and tolerated by the patients.