Please wait a minute...
FITEE
Front. Inform. Technol. Electron. Eng.  2016, Vol. 17 Issue (10): 1095-1106    DOI: 10.1631/FITEE.1500311
    
运动补偿残余误差对机载顺轨干涉SAR性能的影响
Hui Zhang, Jun Hong, Xiao-lan Qiu, Ji-chuan Li, Fang-fang Li, Feng Ming
Institute of Electronics, Chinese Academy of Sciences, Beijing 100190, China; University of the Chinese Academy of Sciences, Beijing 100190, China; Key Laboratory of Technology in Geo-spatial Information Processing and Application Systems, Beijing 100190, China; Science and Technology on Millimeter-Wave Laboratory, Beijing 100854, China
Effects of residual motion compensation errors on the performance of airborne along-track interferometric SAR
Hui Zhang, Jun Hong, Xiao-lan Qiu, Ji-chuan Li, Fang-fang Li, Feng Ming
Institute of Electronics, Chinese Academy of Sciences, Beijing 100190, China; University of the Chinese Academy of Sciences, Beijing 100190, China; Key Laboratory of Technology in Geo-spatial Information Processing and Application Systems, Beijing 100190, China; Science and Technology on Millimeter-Wave Laboratory, Beijing 100854, China
 全文: PDF 
摘要： \n 概要：在机载合成孔径雷达（syntheticapertureradar,SAR）运动补偿中一般存在两个近似：波束中心近似和参考高程近似，这两种近似会在机载单天线SAR系统和机载干涉SAR系统成像过程中引入运动补偿残余误差。本文针对机载顺轨干涉SAR（airbornealong-trackinterferometricSAR,ATI-SAR）系统，分析了上述两种近似导致的运动补偿残余误差对干涉性能的影响。首先针对机载双天线ATI-SAR系统，在不存在参考高程误差和存在参考高程误差两种情况下分别推导了其运动补偿残余误差，然后利用机载仿真参数证明了推导公式的正确性，并展示了运补残余误差对ATI-SAR干涉相位的影响程度。结果表明，当不存在参考高程误差时，由于运补残余误差导致的干涉相位误差可以忽略；而当存在参考高程误差且参考高程误差大于某个门限值时，对于相应的测速精度要求，由于波束中心近似导致的干涉相位误差不可忽略。本文的研究为机载ATI-SAR误差源分析和信号处理提供了理论基础。
\n
关键词： 合成孔径雷达（SAR）;  顺轨干涉;  运动补偿;  残余误差;  干涉相位    
Abstract: Two approximations, center-beam approximation and reference digital elevation model (DEM) approximation, are used in synthetic aperture radar (SAR) motion compensation procedures. They usually introduce residual motion compensation errors for airborne single-antenna SAR imaging and SAR interferometry. In this paper, we investigate the effects of residual uncompensated motion errors, which are caused by the above two approximations, on the performance of airborne along-track interferometric SAR (ATI-SAR). The residual uncompensated errors caused by center-beam approximation in the absence and in the presence of elevation errors are derived, respectively. Airborne simulation parameters are used to verify the correctness of the analysis and to show the impacts of residual uncompensated errors on the interferometric phase errors for ATI-SAR. It is shown that the interferometric phase errors caused by the center-beam approximation with an accurate DEM could be neglected, while the interferometric phase errors caused by the center-beam approximation with an inaccurate DEM cannot be neglected when the elevation errors exceed a threshold. This research provides theoretical bases for the error source analysis and signal processing of airborne ATI-SAR.
Key words: Synthetic aperture radar (SAR)    Along-track interferometric    Motion compensation    Residual error    Interferometric phase
收稿日期: 2015-09-25 出版日期: 2016-10-08
CLC:  TN959.73  
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　
Hui Zhang
Jun Hong
Xiao-lan Qiu
Ji-chuan Li
Fang-fang Li
Feng Ming

引用本文:

Hui Zhang, Jun Hong, Xiao-lan Qiu, Ji-chuan Li, Fang-fang Li, Feng Ming. Effects of residual motion compensation errors on the performance of airborne along-track interferometric SAR. Front. Inform. Technol. Electron. Eng., 2016, 17(10): 1095-1106.

链接本文:

http://www.zjujournals.com/xueshu/fitee/CN/10.1631/FITEE.1500311    或    http://www.zjujournals.com/xueshu/fitee/CN/Y2016/V17/I10/1095

No related articles found!