Please wait a minute...
工程设计学报
工程设计学报  2013, Vol. 20 Issue (3): 230-235    
工程设计理论、方法与技术     
采煤机行走机构动态啮合特性分析
 周甲伟1, 刘瑜1, 刘送永2, 杜长龙2
1. 河南理工大学 机械与动力工程学院，河南 焦作 454000; 
2. 中国矿业大学 机电工程学院，江苏 徐州 221116
Characteristic analysis of dynamic meshing for shearer walking mechanism
 ZHOU  Jia-Wei1, LIU  Yu1, LIU  Song-Yong2, DU  Chang-Long2
1. School of Mechanical and Power Engineering， Henan Polytechnic University， Jiaozuo 454000， China;
2. School of Mechanical and Electrical Engineering， China University of Mining and Technology， Xuzhou 221008， China
 全文: PDF(823 KB)   HTML
摘要： 为分析渐开线采煤机行走轮与Ⅲ型销轨的动态啮合特性，基于ANSYS/LS_DYNA建立行走机构动态啮合过程数值分析模型，以牵引阻力和行走速度为变量研究行走机构动态啮合特性，得到动态啮合时行走速度波动、节线和齿根受力的变化规律．研究结果表明：牵引阻力对行走机构速度波动和节线及齿根受力规律影响显著，随着牵引阻力增大，啮合点在节线附近时对应齿面应力相对较低，但整个啮合过程中应力波动增大；行走速度变化对速度波动持续时间有较大影响；随着行走速度增大，各项载荷峰值呈现先减小后小幅增大的现象，且到达峰值后衰减加剧．
关键词： 采煤机行走机构;  动态啮合;  牵引阻力;  行走速度;  数值分析    
Abstract: In order to investigate the dynamic characteristic of involute shearer walking mechanism and type Ⅲ pin gear, the model of numerical analysis for dynamic meshing were established based on ANSYS/LS_DYNA. The influence of traction resistance and walking velocity on the behaviors of dynamic meshing for walking mechanism was discussed， the variations of walking velocity fluctuation and mechanics of pitch line and tooth root in dynamic mesing for shearer walking mechanism were obtained. The contrast study shows that the traction resistance has a significant influence on the variations of walking velocity fluctuation and mechanics of pitch line and tooth root. The tooth surface stress is low at the time of the meshing point nearby pitch line， but the stress fluctuation in the process of meshing increases with the development of the traction resistance. The influence of the walking velocity on the duration of velocity fluctuation is considerable. With the raise of the walking velocity， the peak loads decrease first and then increase slightly， and the loads after the peak attenuate sharply．
Key words: shearer walking mechanism    dynamic meshing    traction resistance    walking velocity    numerical analysis
出版日期: 2013-06-28
基金资助:

国家自然科学基金资助项目(51005232).
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　
周甲伟
刘瑜
刘送永
杜长龙

引用本文:

周甲伟, 刘瑜, 刘送永, 杜长龙. 采煤机行走机构动态啮合特性分析[J]. 工程设计学报, 2013, 20(3): 230-235.

ZHOU Jia-Wei, LIU Yu, LIU Song-Yong, DU Chang-Long. Characteristic analysis of dynamic meshing for shearer walking mechanism. Chinese Journal of Engineering Design, 2013, 20(3): 230-235.

链接本文:

https://www.zjujournals.com/gcsjxb/CN/    或    https://www.zjujournals.com/gcsjxb/CN/Y2013/V20/I3/230

No related articles found!