Please wait a minute...
工程设计学报
工程设计学报  2007, Vol. 14 Issue (3): 210-214    
工程设计理论、方法与技术     
基于MSC.Fatigue的汽车驱动桥壳疲劳寿命预估
高晶1,宋健,1张步良2,冯喜成2
1. 清华大学 汽车安全与节能国家重点实验室， 北京 100084；2. 东风车桥有限公司 产品研发中心， 湖北 十堰 442051
Prediction on fatigue life of vehicle's driving axle house based on MSC.Fatigue
GAO  Jing1,SONG  Jian1,ZHANG  Bu-Liang2,FENG  Xi-Cheng2
1. State Key Laboratory of Automotive Safety and Energy, Tsinghua University, Beijing 100084, China;2. Research & Development Center, Dongfeng Axle Limited Company, Shiyan 442051, China
 全文: PDF(1034 KB)   HTML
摘要： 运用三维造型软件Pro/Engineer Wildfire2.0建立某型商用车驱动桥后桥壳的实体模型.依据有限元基本理论，进一步建立该桥壳的有限元模型，并在通用有限元分析系统MSC.Nastran中进行有限元应力分析.基于应力分析结果，采用有效的疲劳寿命预估方法，利用专业耐久性疲劳寿命分析系统MSC.Fatigue对该桥壳进行全寿命分析，得到桥壳整体的疲劳寿命分布和危险点的寿命值.通过与台架疲劳试验的桥壳失效情况相对比，预估结果与试验结果一致.而后对在试验中发生破坏的桥壳进行疲劳断口的微观分析.最终在试验与仿真分析结果的基础上提出对该型桥壳生产的改进方案。
关键词： 驱动桥壳;  有限元方法;  疲劳寿命预估;  断口分析    
Abstract: The solid model of a commercial vehicle's driving axle house was established with Pro/Engineer Wildfire 2.0. According to FEM theory, the finite element model of this axle house is set up and its stress analysis is performed by FEA software MSC.Nastran. Based on the result of stress analysis, by adopting effective fatigue lifespan prediction method, lifecycle analysis of axle house is conducted by MSC.Fatigue, a professional fatigue analysis system and then fatiguelifespan distribution of the whole axle house body and the lifespan value of most dangerous points are obtained. By comparing the failure position and fatiguelife of the axle house in the rig test, the results show that the prediction result is the same as the one obtained from experiments. Then, the fracture surface of specimenswhich brought on fatigue invalidation in rig test is investigated with scanningelectron microscopy (SEM). Finally, on the basis of the results got from simulation calculation and rig test, the modified design of axle house is presented.
Key words: driving axle house    finite element method(FEM)    fatigue life prediction    fracture surface analysis
出版日期: 2007-06-28
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　

引用本文:

高晶,宋健,张步良,冯喜成. 基于MSC.Fatigue的汽车驱动桥壳疲劳寿命预估[J]. 工程设计学报, 2007, 14(3): 210-214.

GAO Jing,SONG Jian,ZHANG Bu-Liang,FENG Xi-Cheng. Prediction on fatigue life of vehicle's driving axle house based on MSC.Fatigue[J]. Chinese Journal of Engineering Design, 2007, 14(3): 210-214.

链接本文:

https://www.zjujournals.com/gcsjxb/CN/    或    https://www.zjujournals.com/gcsjxb/CN/Y2007/V14/I3/210

[1] 顾晓蕾, 唐志峰, 吕福在, 刘磊. 无源自适应磁流变阻尼器的磁场设计与研究[J]. 工程设计学报, 2011, 18(5): 386-390.
[2] 周游, 李国顺, 唐进元. 截齿截割煤岩的LS_DYNA仿真模拟[J]. 工程设计学报, 2011, 18(2): 103-108.
[3] 薛彩军, 邱清盈, 杨为. 机械结构静动态性能协同分析方法研究[J]. 工程设计学报, 2002, 9(4): 183-186.