Please wait a minute...
工程设计学报
工程设计学报  2008, Vol. 15 Issue (4): 290-294    
机电产品工程设计     
采煤机滚筒螺旋叶片结构参数研究
刘送永,杜长龙,崔新霞,王 想
中国矿业大学 机电工程学院,江苏 徐州 221008
Research on structure parameters of helical vane on shearer drum
LIU Song\|yong，DU Chang\|long，CUI Xin\|xia，WANG Xiang
College of Mechanical and Electrical Engineering，China University of Mining and Technology，Xuzhou 221008，China
 全文: PDF(339 KB)   HTML
摘要： 根据采煤机截割理论,建立了螺旋叶片参数（结构参数、运动参数）与目标参数（滚筒装煤量、轴向输煤速度、轴向抛煤力、滚筒最低转速、块煤率）间关系的数学模型．以此为基础,研究了滚筒直径为1 800,1 600,1 250 mm,叶片头数为2时,叶片升角、叶片螺距、滚筒转速与装煤量的关系和叶片升角、滚筒转速与轴向抛煤速度的关系；并分析了叶片升角、牵引速度、滚筒转速对轴向抛煤力和块煤率的影响,以及三种型号滚筒的叶片升角、牵引速度与滚筒最低转速之间的关系．研究结果表明,螺旋叶片的升角对滚筒装煤量、轴向抛煤速度、轴向抛煤力和滚筒最低转速影响较大,并得到叶片升角最佳值在0.43 rad左右,为采煤机滚筒设计提供理论依据．
关键词： 截割理论;  叶片升角;  装煤量    
Abstract: According to the cutting theory of shearer, the mathematic models of relationship between the helical vane parameters (structural parameters, kinematical parameters) and the objective parameters (coal capacity of the drum, coal conveying speed in axial direction, stoker force in axial direction, minimum speed of the drum, percentage of lump coal) were established. Based on the above, when the vane was with 2\|start, the drum diameters were 1 800, 1 600, 1 250 mm, the relationship between vane parameters (helical angle, drum rotary speed) and the coal conveying speed and the relationship between parameters namely helical angle, drum rotating speed and speed of stroking up coal in axial direction was studied. Furthermore, the influence of the vane parameters (helical angle, haulage speed, drum rotary speed) on the stoker force in axial direction and the percentage of lump coal, and the relationship of the vane parameters (helical angle, haulage speed) and the minimum speed of the drum were analyzed.The results indicate that the helical angle has a great influence on the objective parameters (coal capacity of the drum, coal conveying speed in axial direction, stoker force in axial direction, minimum speed of the drum), and the best value is obtained around 0.3 rad, which provides theoretic basis for design of the shearer drum．
Key words:  cutting theory    helical vane angle    coal capacity
出版日期: 2008-08-28
:  TD421.6  
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　
刘送永
杜长龙
崔新霞
王 想

引用本文:

刘送永,杜长龙,崔新霞,王 想. 采煤机滚筒螺旋叶片结构参数研究[J]. 工程设计学报, 2008, 15(4): 290-294.

LIU Song-yong，DU Chang-long，CUI Xin-xia，WANG Xiang. Research on structure parameters of helical vane on shearer drum[J]. Chinese Journal of Engineering Design, 2008, 15(4): 290-294.

链接本文:

https://www.zjujournals.com/gcsjxb/CN/    或    https://www.zjujournals.com/gcsjxb/CN/Y2008/V15/I4/290

No related articles found!