Please wait a minute...
工程设计学报
工程设计学报  2005, Vol. 12 Issue (1): 52-54    
工程设计理论、方法与技术     
液力变矩器循环圆的修正
 刘悦, 潘毓学
长春理工大学 机电学院， 吉林 长春 130022
Amendment to circulatory circle on hydrodynamic torque converter
 LIU  Yue, PAN  Yu-Xue
College of Mechanical and Electrical Engineering, Changchun University of Science and Technology, Changchun 130022, China
 全文: PDF(199 KB)   HTML
摘要： 在液力变矩器的设计过程中，循环圆的内环和设计流线通常需要修正。以三圆弧循环圆为例，分析了导数修正法的不足，并进一步完善了循环圆的修正设计。分析结果表明：采用新方法设计的变矩器，其过流面积变化均匀，流场分布合理,经过一次修正即可达到设计要求。
关键词： 液力变矩器;  循环圆;  修正设计    
Abstract: Amendment to in-circle and design streamline on circulatory circle during the design of hydrodynamic torque converter is commonly necessary. Taking the three circular arcs as an example, this paper presents the disadvantages of differential amendment method and further improves the amendment design of circular circle. The results indicates that torque converter, designed through this new method, achieves smooth changes of cross-sectional areas, reasonable distributions of flow field and can fulfill the requirements through one amendment.  
Key words: hydrodynamic torque converter    circulatory circle    amendment design
出版日期: 2005-02-28
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　
刘悦
潘毓学

引用本文:

刘悦, 潘毓学. 液力变矩器循环圆的修正[J]. 工程设计学报, 2005, 12(1): 52-54.

LIU Yue, PAN Yu-Xue. Amendment to circulatory circle on hydrodynamic torque converter[J]. Chinese Journal of Engineering Design, 2005, 12(1): 52-54.

链接本文:

https://www.zjujournals.com/gcsjxb/CN/    或    https://www.zjujournals.com/gcsjxb/CN/Y2005/V12/I1/52

[1] 陈东升, 杨凯华, 阎清东. 牵引一制动型液力变矩器原始特性研究[J]. 工程设计学报, 2003, 10(2): 98-102.