Please wait a minute...
工程设计学报  2015, Vol. 22 Issue (2): 178-184    DOI: 10.3785/j.issn. 1006-754X.2015.02.013
通用零部件设计     
基于改进型匹配网络的宽带高效率E类功放的设计
李咏乐1,南敬昌1,游长江2,杜学坤1,2,蒋 迪2
1.辽宁工程技术大学 电子与信息工程学院,辽宁 葫芦岛 125105;
2.电子科技大学 通信与信息工程学院,四川 成都 611731
Design of highly efficient broadband Class-E power amplifier based on improved matching network
LI Yong-le1, NAN Jing-chang1, YOU Chang-jiang2, DU Xue-kun1,2, JIANG Di2
1.School of Electrics and Information Engineering, Liaoning Technical University, Huludao 125105, China; 2.School of Communication & Information Engineering, University of Electronic Science and Technology of China, Chengdu 611731, China
 全文: PDF(2872 KB)   HTML
摘要: 为了解决E类功放工作带宽过窄的问题,对E类功放的输入、输出匹配网络提出了一种改进方案.该方案中输出匹配网络采用微带线结构与切比雪夫低通匹配网络相结合的方法,在较宽的工作带宽内有效地抑制了谐波;并采用阻抗变换方法设计了含闭式解的宽带带通输入匹配网络,明显增强了输入匹配网络设计的灵活性.利用该方案,同时采用多谐波双向牵引技术得到功率管的最佳源阻抗和负载阻抗,基于CGH40010F功率管设计了一款应用于L波段的宽带高效率E类功放.测试结果表明,在输入功率为28 dBm,漏极偏置电压VDS=28 V,栅极电压VGS=-3.3 V时,在整个L波段频率范围内漏极工作效率大于65%,最高达到83%,输出功率为39~41.1 dBm,增益为11~13.1 dB,增益平坦度为±1 dB.这一结果验证了该改进方案的有效性,使得E类功放具有宽带宽、高效率的性能.
关键词: 宽带匹配网络E类高效率功率放大器    
Abstract: In order to solve the problem of Class-E power amplifier (PA) having too narrow bandwidth, an improved scheme on the input and output matching network of Class-E power amplifier was proposed. The output matching network utilized the transmission-line combining with Chebyshev low\|pass matching network in order to suppress harmonics in a wide operating bandwidth; in addition, the closed-form solution broadband band\|pass matching network in the input matching network utilized the transformation method, which could enhance the design flexibility of matching network. Based on the proposed method and the optimum source and load impedances obtained by multi-harmonic bilateral\|pull technology, a broadband high efficiency Class-E power amplifier based on CGH40010F device was designed. The measured drain efficiency was more than 65% and maximum efficiency was 83%, output power was 39-41.1 dBm and power gain was 11-13.1 dB, and gain flatness was ±1 dB at the operation of a 28 dBm input power, 28 V drain voltage and -3.3 V gate voltage in the L-band. The measurements have shown that the proposed method is well verified, and the designed Class-E PA has a wide bandwidth and high efficiency.
Key words: broadband matching network    Class-E    high efficiency    power amplifier
收稿日期: 2014-03-25 出版日期: 2015-04-28
基金资助:

国家自然科学基金资助项目(61372058); 辽宁省高等学校优秀人才支持计划资助项目(LR2013012).

作者简介: 李咏乐(1990—),男,江苏泰州人,硕士生,从事射频及微波电路与器件等研究,E-mail: liyongle1990@126.com. 通信联系人:南敬昌(1971—),教授,博士生导师,从事信号处理与信息编码、通信系统仿真等研究,E-mail: nanjc886@sina.com.
服务  
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章  

引用本文:

李咏乐,南敬昌,游长江,杜学坤,蒋 迪. 基于改进型匹配网络的宽带高效率E类功放的设计[J]. 工程设计学报, 2015, 22(2): 178-184.

LI Yong-le, NAN Jing-chang, YOU Chang-jiang, DU Xue-kun, JIANG Di. Design of highly efficient broadband Class-E power amplifier based on improved matching network. Chinese Journal of Engineering Design, 2015, 22(2): 178-184.

链接本文:

https://www.zjujournals.com/gcsjxb/CN/10.3785/j.issn. 1006-754X.2015.02.013        https://www.zjujournals.com/gcsjxb/CN/Y2015/V22/I2/178

[1] 南敬昌, 张鹏俊. 平衡式E/F类功率放大器的设计与实现[J]. 工程设计学报, 2018, 25(2): 237-244.
[2] 朱二莉. FR算法在3G射频功率放大器设计中的应用[J]. 工程设计学报, 2011, 18(5): 396-.