Please wait a minute...
浙江大学学报(工学版)
浙江大学学报(工学版)
土木工程     
钢绞线截面应力精细化分析
陈冲, 袁行飞
浙江大学 空间结构研究中心,浙江 杭州 310058
Fine analysis of section stress of steel strand
CHEN Chong, YUAN Xing-fei
Space Structures Research Center, Zhejiang University, Hangzhou 310058, China
 全文: PDF(4303 KB)   HTML
摘要：

为了研究外荷载作用下钢绞线截面应力的真实分布规律,利用微分几何理论进行钢绞线的几何建模.模型采用20节点SOLID95单元,一端固定,另一端施加轴向均布荷载.采用库伦模型考虑钢丝之间摩擦对于钢绞线的影响,采用TARGE170和CONTA174单元进行摩擦分析.研究结果表明，当不考虑摩擦时,钢绞线截面等效应力中间小,外层大,呈扇形分布；钢绞线轴向应力相差不大,基本呈均匀分布.当考虑摩擦作用时,截面等效应力分布发生变化,各钢丝接触面上的等效应力值最大,中心钢丝等效应力次之,外层钢丝等效应力最小.进一步与已有文献实验结果进行对比,验证了该文分析结果的有效性.
Abstract:

The geometrical model was established by using differential geometrical theory in order to analyze the distribution of steel strand section stress. The twenty-node solid95 element was used. All the numerical analysis of the steel strand models were performed with one end clamped and the other submitted to a distributed load. The TARGE170 element and CONTA174 element were used considering the influence of friction on the steel strand section stress. The steel strands were analyzed by ANSYS with penalty algorithm. Results indicate that when the influence of friction is ignored, the Von Mises equivalent stress of steel strand section is fan-shaped distributed, and it increases as the increment of the radial distance from center of strand. The axial stress of steel strand is nearly equally distributed. The distribution of Von Mises equivalent stress changes a lot because of the influence of friction. The contact area has the maximal value, decreases as the increment of the radial distance from center of strand. The axial stress has almost no change, except the contact area. the results obtained by the finite element model were proved to be valid compared with the available experimental data．
出版日期: 2017-05-01
CLC:  U 443.38  
基金资助:

国家自然科学基金资助项目（51278461;51578492）; 浙江省重点基金资助项目（LZ14E080001）.
通讯作者: 袁行飞，女，教授，博导. ORCID：0000-0003-0507-5039.     E-mail: yuanxf@zju.edu.cn
作者简介: 陈冲（1986—），男，博士，从事大跨空间结构相关等研究. ORCID：0000-0001-9988-1159. E-mail：lhcc1986@163.com
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
作者相关文章　　

引用本文:

陈冲, 袁行飞. 钢绞线截面应力精细化分析[J]. 浙江大学学报(工学版), 10.3785/j.issn.1008-973X.2017.05.001.

CHEN Chong, YUAN Xing-fei. Fine analysis of section stress of steel strand. JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE), 10.3785/j.issn.1008-973X.2017.05.001.

参考文献(References)：
［1］ 钱若军,杨联萍.张力结构的分析、设计、施工［M］.南京：东南大学出版社,2001: 5-21．
［2］ 张德坤,葛世荣,朱真才.提升钢丝绳的钢丝微动摩擦磨损特性研究［J］.中国矿业大学学报,2002,31(9):367-370．
ZHANG De-kun, GE Shi-rong, ZHU Zhen-cai. Friction and wear performance on fretting wear of steel wires in hoisting ropes ［J］.Journal of China University of Mining & Technology, 2002, 31(9): 367-370．
［3］ CHIANG Y J. Characterizing simple-stranded wire cables under axial loading ［J］. Finite Elem Anal Des, 1996, 24(2)： 49-66．
［4］ 孔庆凯,万鹏.钢绞线的基本力学性能及其有限元方法模拟［J］.工程结构,2003,23(1): 20-22．
KONG Qing-kai, WAN Peng. Basic mechanical properties and finite element method of the strand wire［J］. Engineering Structure, 2003, 23(1): 20-22．
［5］ GHOREISHI S R, MESSAGER T, CARTRAUD P. Validity and limitations of linear analytical models for steel wire strands under axial loading, using a 3D FE model ［J］. International Journal of Mechanical Sciences, 2007, 49(11): 1251-1261．
［6］ 马军,葛世荣,张德坤.钢丝绳股内钢丝应力—应变分布的计算模型及数值模拟.机械工程学报,2009,45(4): 259264．
MA Jun, GE Shi-rong, ZHANG De-kun. Calculating model and numerical simulation of stress-strain distribution of wires within strands. ［J］.Journal of Mechanical Engineering, 2009, 45(4): 259-264．
［7］ FEYRER. Wire ropes, tension, endurance, reliability ［J］. Berlin, Springer-Verlag, 2007, 21(2): 1-10．
［8］ 浦汉军.起重机用不旋转钢丝绳寿命研究［D］.广州：华南理工大学, 2012．
PU Han-jun. Study on theory and life estimation of the non-rotating rope used in crane［D］. Guangzhou: South China University of Technology, 2012．
［9］ WANG DG. Effect of displacement amplitude on fretting fatigue behavior of hoisting rope wires in low cycle fatigue ［J］. Tribol Int, 2012, 52: 178-189.
［10］ 易贤人.钢绞线偏轴应变测量方法及实验研究\[J\].华中科技大学学报,2008,25(3): 211-214．
YI Xian-ren. Measurement method and experimental study of prestressed strand deflection axial strain. ［J］. Journal of Hua Zhong University of Science and Technology, 2008, 25(3): 211-214.
[1] 张婷婷,谢旭,潘骁宇. 考虑断丝影响的平行钢丝索拉伸力学特性[J]. 浙江大学学报(工学版), 2016, 50(5): 841-847.
[2] 潘骁宇,谢旭,李晓章,孙文智，朱汉华. 锈蚀高强度钢丝的力学性能与评级方法[J]. 浙江大学学报(工学版), 2014, 48(11): 1917-1924.