Please wait a minute...
浙江大学学报(工学版)
浙江大学学报(工学版)
机械能源工程     
汽油机余热回收单阀膨胀机模拟试验
刘子奇, 高文志, 李广华, 何王波
1.天津大学 内燃机燃烧学国家重点实验室,天津 300072
2.大连海洋大学 机械与动力工程学院,大连 116023
Simulation test on single valve expander for waste heat recovery of  gasoline engine
LIU Zi qi，GAO Wen zhi，LI Guang hua，HE Wang bo
1. State Key Laboratory of Engines，Tianjin University，Tianjin 300072，China
2. School of Mechanical and Power Engineering, Dalian Ocean University, Dalian 116023, China
 全文: PDF(1134 KB)   HTML
摘要：

发动机尾气能量占燃料燃烧放热总量的35%左右,为回收这部分能量,针对以水为工质的单阀膨胀机的工作特点,建立基于Matlab/Simulink的单阀膨胀机模型.分析该模型的性能,并进行试验验证模型的正确性.模拟结果表明,进气压力和进气阀升程的增加会导致单阀膨胀机输出功率和质量流量的增大,同时导致膨胀机效率的降低.随着转速的增大,膨胀机输出功率和质量流量先增大后趋于平稳|进气温度升高会导致质量流量的下降,对膨胀机输出功率和效率的影响不大.膨胀机试验结果表明,当汽油机功率为61 kW时,膨胀机回收的功率可达3 kW,使联合循环系统总输出功率增加5%.
Abstract:

According to the working characteristics of expander with water as working fluid, the theoretical model of a single valve expander was established based on Matlab/Simulink software in order to recover the exhaust energy, which accounts for about 35% of the total fuel energy. The model’s performance was analyzed, and its validity was verified by test. The simulation results show that the increase of inlet pressure and intake valve lift can lead to an increase of power and mass flow rate of expander, while a decrease of expander efficiency. The output power and mass flow rate increase at first and then tend to be steady with the rise of the rotation speed. The increase of the work fluid temperature can lead to a lower mass flow rate, but has inconspicuous influence on output power and expander efficiency. The test results of the expander show that the expander output power can reach 3 kW and the efficiency of the combined cycle system is increased by 5% when the output power of gasoline engine is 61 kW.
出版日期: 2016-12-08
:  TK 402  
基金资助:

国家“973”重点基础研究发展规划资助项目.
通讯作者: 高文志，男，教授. ORCID: 0000-0002-3305-0448.     E-mail: gaowenzhi@tju.edu.cn
作者简介: 刘子奇（1989—），女，硕士生,从事发动机余热回收研究.ORCID: 0000-0002-1971-4172. E-mail: 284334046@qq.com
服务　　
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章　　

引用本文:

刘子奇, 高文志, 李广华, 何王波. 汽油机余热回收单阀膨胀机模拟试验[J]. 浙江大学学报(工学版), 10.3785/j.issn.1008-973X.2016.12.008.

LIU Zi qi，GAO Wen zhi，LI Guang hua，HE Wang bo. Simulation test on single valve expander for waste heat recovery of  gasoline engine. JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE), 10.3785/j.issn.1008-973X.2016.12.008.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2016.12.008    或    http://www.zjujournals.com/eng/CN/Y2016/V50/I12/2297

［1］ EDWARDS S,EITEL J,PANTOW E, et al.Waste heat recovery: the next challenge for commercial vehicle thermo management ［J］. SAE International Journal of Commercial Vehicles, 2012, 5(1): 395-406．
［2］ DOMINGUES A, SANTOS H, COSTA M. Analysis of vehicle exhaust waste heat recovery potential using a Rankine cycle ［J］. Energy, 2013, 49: 71-85．
［3］ FU J, LIU J, FENG R, et al. Energy and energy analysis on gasoline engine based on mapping characteristics experiment ［J］. Applied Energy, 2013, 102: 62230．
［4］ WANG E, ZHANG H, FAN B, et al. Study of working fluid selection of organic Rankine cycle (ORC) for engine waste heat recovery ［J］. Energy, 2011, 36(5): 3406-3418．
［5］ WANG T,ZHANG Y,PENG Z,et al. A review of researches on thermal exhaust heat recovery with Rankine cycle ［J］. Renewable and Sustainable Energy Reviews, 2011,15(6): 2862-2871．
［6］ BADAMI M, MURA M, CAMPANILE P, et al. Design and performance evaluation of an innovative small scale combined cycle cogeneration system ［J］. Energy, 2008, 33(8): 1264-1276．
［7］ MOTORTREND. BMW TurboSteamer ［EB/OL］. (20060519)［20151013］. http:∥www.motortrend.com/news/technologuehybridqa/2006-05-19．
［8］ HE M, ZHANG X, ZENG K, et al. A combined thermodynamic cycle used for waste heat recovery of internal combustion engine ［J］. Energy, 2011, 36(12): 6821-6829.
［9］ HO T. Waste heat recovery concept to reduce fuel consumption and heat rejection from a diesel engine ［J］. SAE International Journal of Commercial Vehicles, 2010, 3(1): 60-68．
［10］ DEPCIK C. Review of organic Rankine cycles for internal combustion engine exhaust waste heat recovery ［J］. Applied Thermal Engineering, 2013, 51(1/2): 711-722.
［11］ 薛皓白. 多级单阀膨胀机的理论与实验研究［D］. 北京：中国科学院研究生院（工程热物理研究所）, 2014．
XUE Haobai. Theoretical and experimental study of a multistage single valve reciprocating expander ［D］. Beijing: Institute of Engineering Thermophysics, Chinese Academy of Sciences, 2014.
［12］ GLAVATSKAYA Y, PODEVIN P, LEMORT V, et al. Reciprocating expander for an exhaust heat recovery rankine cycle for a passenger car application ［J］. Energies, 2012, 5(6): 1751-1765．
［13］ BAO J, ZHAO L. A review of working fluid and expander selections for organic Rankine cycle ［J］. Renewable and Sustainable Energy Reviews, 2013, 24(10): 325-342．
［14］  ZIVIANI D, BEYENE A, VENTURINI M. Advances and challenges in ORC systems modeling for low grade thermal energy recovery ［J］. Applied Energy, 2014, 121(121): 7995.
［15］ 丑一鸣.活塞膨胀机 ［M］.北京：机械工业出版社,1990: 13-15.
［16］ 冯黎明,高文志,秦浩,等.用于发动机余热回收的往复活塞式膨胀机热力学分析［J］. 天津大学学报, 2011(8):665-670．
FENG Liming, GAO Wenzhi, QIN Hao, et al. Thermodynamic analysis of reciprocating piston expander used to recover waste heat of engine ［J］. Journal of Tianjin University, 2011(8): 665-670．
［17］ 周龙保,内燃机学 ［M］.北京：机械工业出版社,2011: 34-38．
［18］ GRIMALDIC N, MILLO F. Internal combustion engine (ICE) fundamentals ［M］∥Handbook of Clean Energy Systems. New York: John Wiley & Sons, Ltd, 2015: 34-38.
[1] 李恒,郝志勇,刘联鋆,郑旭. 多腔穿孔消声器声学特性三维时域计算及评估[J]. 浙江大学学报(工学版), 2015, 49(5): 887-892.
[2] 李一民,郝志勇,杜极生. 发动机曲轴与正时系耦合动力学研究[J]. J4, 2013, 47(9): 1650-1657.
[3] 刘联鋆, 郝志勇, 钱欣怡. 空滤器滤芯声学特性的仿真方法[J]. J4, 2012, 46(10): 1784-1789.
[4] 李一民, 郝志勇, 叶慧飞. 柴油机正时齿轮系动力学特性分析[J]. J4, 2012, 46(8): 1472-1477.
[5] 李一民,郝志勇,曾小春. 考虑油膜润滑的连杆有限元分析[J]. J4, 2012, 46(7): 1233-1237.
[6] 李佳, 刘震涛, 刘忠民, 谭永南, 俞小莉. 空气滤清器流动过程仿真与试验分析[J]. J4, 2012, 46(2): 327-332.
[7] 肖宝兰, 俞小莉, 韩松, 陆国栋, 夏立峰. 基于神经网络的换热器翅片参数灵敏度分析[J]. J4, 2011, 45(1): 122-125.
[8] 肖宝兰, 俞小莉,韩松,陆国栋,夏立峰. 翅片参数对车用中冷器流动传热性能的影响[J]. J4, 2010, 44(11): 2164-2168.
[9] 肖宝兰, 俞小莉, 钟勋, 韩松, 夏立峰. 纳米流体流动传热性能的实验与模拟研究[J]. J4, 2010, 44(6): 1149-1154.