Please wait a minute...
浙江大学学报(工学版)
机械工程     
锥阀式气动比例压力阀压力控制器的设计
班伟1 , 陶国良1 ,孟德远1,2 , 刘昊1 ,钱鹏飞1
1.浙江大学 流体传动及控制国家重点实验室, 浙江 杭州 310027; 2.中国矿业大学 机电工程学院, 江苏 徐州 221116
Development of  pressure controller for  poppet type pneumatic proportional pressure valve
BAN Wei1, TAO Guo-liang1, MENG De-yuan1, 2, LIU Hao1, QIAN Peng-fei1
1.State Key Laboratory of Fluid Power Transmission and Control,Zhejiang University, Hangzhou 310027, China; 2. School of Mechatronic Engineering, China University of Mining and Technology, Xuzhou 221116, China
 全文: PDF(1743 KB)   HTML
摘要:

为解决由于气体压缩性造成的锥阀式气动比例压力阀输出压力的可控性差的问题,设计一种基于电流环/压力环双闭环反馈的压力控制器.电流环单元采用基于电流比例负反馈的模拟电路实现,额定输出为0~0.9 A,最大电流纹波为35 mA,驱动035型比例电磁铁时的截止频率可达22.5 Hz.压力环单元采用数字反馈控制算法实现,分为2个阶段:当误差较大时,采用自抗扰控制器来补偿未知扰动对阀的输出压力的动态性能的不良影响;在设定压力附近,则切换为非线性PID控制器来提高压力控制精度和稳定性.同时,引入输入信号的轨迹规划进一步改善控制器的性能.实验结果表明,该控制器可以实现输出压力在0~6×105 Pa内连续控制,压力控制误差在±1 kPa以内, 且对下游负载变化具有较强的鲁棒性.

Abstract:

The poppet type pneumatic proportional pressure valve (PPPV), driven by a proportional solenoid, is of poor controllability due to the compressibility of the air. The idea of combining the pressure control loop with the current control loop was proposed to solve the problem. The current control loop was achieved by a special designed analog proportional amplify circuit, and was capable of providing the current up to 0.9 A. The maximum current ripple is 35 mA, and the cut off frequency of the circuit is about 22.5 Hz when driving a 035 type proportional solenoid. The software based pressure control loop was divided into two parts: active disturbance rejection control was adopted to drive the output pressure tracking the command signal when the feedback error is big; the nonlinear PID controller was switched on to enhance both the accuracy and the stability when error was small. The reference signal profile planning was further involved to improve the performance of the valve. Experiment results proves that the proposed PPPV can achieve a continuously variable pressure adjustment in the range of 0 to 600 kPa, while the control accuracy is within ±1 kPa, and it is also robust to the downstream disturbance.

出版日期: 2015-12-26
:  TH 138.523  
基金资助:

国家自然科学基金资助项目(51375430)

通讯作者: 陶国良,男,教授,博导     E-mail: gltao@zju.edu.cn
作者简介: 班伟(1984-), 男, 博士, 主要从事气动电子技术研究. E-mail: realbw@zju.edu.cn
服务  
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章  

引用本文:

班伟, 陶国良,孟德远, 刘昊, 钱鹏飞. 锥阀式气动比例压力阀压力控制器的设计[J]. 浙江大学学报(工学版), 10.3785/j.issn.1008-973X.2015.05.009.

BAN Wei, TAO Guo-liang, MENG De-yuan, LIU Hao, QIAN Peng-fei. Development of  pressure controller for  poppet type pneumatic proportional pressure valve. JOURNAL OF ZHEJIANG UNIVERSITY (ENGINEERING SCIENCE), 10.3785/j.issn.1008-973X.2015.05.009.

链接本文:

http://www.zjujournals.com/eng/CN/10.3785/j.issn.1008-973X.2015.05.009        http://www.zjujournals.com/eng/CN/Y2015/V49/I5/873

[1] MASSIMO S, GIORGIO F, STEFANO P. Dynamic model and experimental investigation of a pneumatic proportional pressure valve [J]. IEEE/ASME Transactions on Mechatronics, 2004, 9(1):78-86.
[2] 班伟,陶国良,路波,等. 新型气动比例压力阀的建模研究与特性分析[J]. 浙江大学学报:工学版, 2012, 46(11), 1953-1959.
BAN Wei, TAO Guo-liang, LU Bo, et al. Modeling and characteristics investigation on a new pneumatic proportional pressure valve [J]. Journal of Zhejiang University: Engineering Science, 2012, 46(11), 1953-1959.
[3] LU Bo, TAO Guo-liang, XIANG Zhong, et al. Modeling and control of the pneumatic constant pressure system for zero gravity simulation, [C]∥ IEEE/ASME International Conference on Advanced Intelligent Mechatronics. Xian: IEEE, 2008: 688-693.
[4] eljko itum. Control of a pneumatic drive using electronic pressure valve [J]. Transactions of the Institute of Measurement and Control, 2013, 35(8), 1085-1093.
[5] 聂勇. 新型可编程电液比例控制器关键技术研究[D]. 杭州: 浙江大学, 2010, 27-46.
NIE Yong. Research on the key technologies of novel programmable electro-hydraulic proportional controller [D]. Hangzhou: Zhejiang University, 2010, 27-46.
[6] CANUTO E, ACUA-BRAVO W, AGOSTANI, M, et al. Digital current regulator for proportional eletro-hydraulic valves with unknown disturbance rejection [J]. ISA Transactions, 2014, 53(4):909-919.
[7] JUNG H G, HWANG J Y, YOON P J, et al. Resistance estimation of a pwm-driven solenoid [J]. International Journal of Automotive Technology, 2007, 8(2), 249-258.
[8] CHO S H, FIEDLER M, RUDIGER F, et al. Virtual-design-model-based pressure-tracking control of high dynamic pneumatic valves using a sliding mode controller combined with a proportional-integral-derivation scheme [J]. Proceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering, 2006, 220(5):353-364.
[9] HAMDAN M, GAO ZHI-QIANG. A novel PID controller for pneumatic proportional valves with hysteresis, [C]∥ Industry Applications Conference. Rome: IEEE, 2000, 2:1198-1201.
[10] 路波,陶国良,袁月峰,等. 高精度气动比例压力阀的设计及特性研究[J]. 农业机械学报, 2009, 40(10):181-187.
LU Bo, TAO Guo-liang, YUAN Yue-feng, et al. Design and characteristics investigation of a high precision pneumatic proportional pressure valve [J]. Transactions of the Chinese Society for Agricultural Machinery, 2009, 40(10):181-187.
[11] HAN Jing-qing. From PID to active disturbance rejection control [J]. IEEE Transactions on Industrial Electronics, 2009, 56(3): 900-906.
[12] GAO Zhi-qiang. From linear to nonlinear control means: A practical progression [J]. ISA Transactions, 2002, 41(2): 177-189.
[13] GAO Zhi-qiang. Scaling and bandwidth parameterization based controller tuning [C]∥ Proceedings of the American Control Conference. Denver: IEEE, 2006, 6, 4989-4996.
[14] MIKLOSOVIC R, RADKE A, GAO Zhi-qiang. Discrete implementation and generalization of the extended state observer[C]∥ Proceedings of the American Control Conference. Minneapolis: IEEE, 2006, 6:2209-2214.

[1] 刘琼,陶国良,钟伟,班伟. 内外爆气动开关阀[J]. J4, 2013, 47(5): 790-795.
[2] 班伟 , 陶国良 , 路波,孟德远 , 袁月峰. 新型气动比例压力阀的建模研究与特性分析[J]. J4, 2012, 46(11): 1953-1959.